高帧速摄像器

本文介绍了高帧速摄像器的设计、制造、工作和性能。该高帧速有３６０×３６０像素、摄像速度高达５×１０５帧／秒，该摄像器读出电路类似于帧转移ＣＣＤ，由四部分组成     

D→Klv～l衰变过程的研究

用光锥QCD求和规则研究D→Klv～_l衰变过程，首先计算D→K跃迁形状因子，通过构造新的关联函数，消除了twist-3波函数的不确定性给计算结果所带来的影响，从而使计算结果更加精确. 计算得到的分支比与最近的实验数据相一致. 关键词： QCD光锥求和规则 D介子半轻衰变 分支比 形状因子     

Fabrication of isotype (p-p) selenium-polyaniline heterojunction diode by electrochemical method

In the present work, for the first time, heterojunction has been fabricated using electrochemically deposited isotype p-selenium-p-polyaniline from a single solution bath. The structural characterization of selenium and polyaniline thin film was carried out using XRD technique. Polyaniline exhibited amorphous structure while selenium offered monoclinic (β) phase. The junction was formed by electrodepositing polyaniline over selenium film and heating at 423 K. The current density versus voltage (J-V) plot showed the formation of a junction with ideality factor of 1.16. From J-V characteristics at different temperatures, static resistance (R_s), dynamic resistance (R_d), and rectification ratio of diodes were determined. Heat treatment above 448 K caused junction breakdown.     

Kerr介质中"耦合双原子-单模光场"模型的反聚束效应

利用全量子理论,研究了在Kerr介质中,耦合二能级双原子与单模光场相互作用过程的反聚束效应,着重讨论了Kerr介质对场的二阶相干度的影响,并揭示了初始场强及原子间耦合系数的变化与场的二阶相干度的关系。     

Electrical properties of polypyrrole/p‐InP structure

The polypyrrole/p‐InP structure has been fabricated by the electrochemical polymerization of the organic polypyrrole onto the p‐InP substrate. The current–voltage (I–V), capacitance–voltage (C–V), and capacitance–frequency (C–f) characteristics of the PPy/p‐InP structure have been determined at room temperature. The structure showed nonideal I–V behavior with the ideality factor and the barrier height 1.48 and 0.69 eV respectively. C–f measurements of the structure have been carried out using the Schottky capacitance spectroscopy technique and it has been seen that there is a good agreement between the experimental and theoretical values. Also, it has been seen that capacitance almost show a plateau up to a certain value of frequency, after which, the capacitance decreases. The higher values of capacitance at low frequencies were attributed to the excess capacitance resulting from the interface states in equilibrium with the p‐InP that can follow the a.c. signal. The interface state density N_ss and relaxation time τ of the structure were determined from C–f characteristics. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 1572–1579, 2006     

Gas transport through homogeneous and asymmetric polyethersulfone membranes

Both homogeneous and asymmetric polyethersulfone (PES) membranes were prepared by solvent casting. The sorption and permeation behavior of CO₂, O₂, and N₂ using these two kinds of cast PES membranes and commercially available homogeneous PES film was investigated to extract the pressure dependence of gas permeability and the permselectivity for CO₂ relative to N₂, and to confirm the validity of the working assumption that a skin layer in an asymmetric membrane can be essentially replaced by a thick homogeneous dense membrane. The pressure dependence of the mean permeability coefficient to CO₂ in homogeneous membranes obeys the dual-mode mobility model. The ideal separation factor for CO₂ relative to N₂ at an upstream pressure of 0.5 MPa attains ca. 40, while the permeability to CO₂ is about 2.7 Barrer at the same upstream pressure. The same separation factor in asymmetric membranes amounts to 35. The diffusion behavior for the skin layer in an asymmetric membrane with a thin skin layer can be simulated approximately by that in a homogeneous dense membrane. © 1993 John Wiley & Sons, Inc.     

对NO生理作用的新认识及其电化学实时检测

本文综述了近年来学术界对ＮＯ生理作用的新认识，并介绍了现场实时检测生物活体中释放的ＮＯ浓度的电化学方法．     

DFT and CIS(D) theoretical study on the ground and excited states of pentanitrogen cation

Different isomers of N₅⁺ were modeled at DFT(PBE0)/aug-cc-pV(Q + d)Z, and their ground(transition) state characteristics were assessed through frequency calculations. Single-point energies were accomplished at PBE0/aug-cc-pV(5 + d)Z. Nonlinear optical susceptibilities (NLO) of isomers were accomplished using Firefly, while the linear optical invariant was examined using the finite-field method, Firefly, and modified dipole field tensor in the presence of two different screening factors. The excited states, singlets and triplets, of were modeled at the CIS and CIS(D) and then their optical parameters were estimated at TDFT(PBE0)/aug-cc-pV(Q + d)Z using Firefly. The singlet is found the most stable isomer, with the inversional rate constant larger than that of the Cs isomer and high energy barrier with the triplet counterpart. Isomers 2 , 3 , and 4 are found local minima, while 5 and 6 are saddle points: transition states between equivalent invertomers. Energy calculations of the singlet and triplet isomers were in excellent agreement with the literature. An excellent correlation is found between the average polarizability and the impulse factor. Substantial variations were found between the singlet and triplet excited states in terms of energy, geometry, and optical properties from one side and with from the other side. Reactivity indices showed that N1 and N5 are the optimum nucleophilic and electrophilic reactivity sites.     

Setting up of recovery profiles: A tool to perform the compliance with recovery requirements for residue analysis

The use of the recovery term has presented some confusion in Analytical Chemistry. Recent IUPAC recommendations propose to distinguish between two terms: recovery or recovery factor, ℜ, and apparent recovery, ℜ*. Apparent recovery includes recovery factor and a new recovery term proposed in this paper, named calibration recovery, ℜ^C, which depends of the type of systematic error due to the matrix effect (constant and/or proportional) and is related to the applied calibration methodology. This paper highlights the dependence of the calibration recovery on the sample analyte concentration and, for extension, of the apparent recovery, defines the recovery profile, and makes evident the need to determine a “fit for purpose” analyte concentration interval to comply with a regulated recovery requirements. An approach to estimate the calibration recovery and its associated uncertainty in relation to the above-mentioned dependence is presented. The usefulness of the proposed methodology has been shown in the quantification of a pesticide by GC-ECD for assessing dermal exposure.     

Capacity factors and peak widths in the gradient elution reversed phase separation of high molar mass polystyrenes

Summary A simplex method for determining the constantsS andk _o from the equation lnk’=lnk _o−S ϕ (was developed and applied to the reversed phase separation of high molar mass polystyrenes using gradients of any curvature. Experimental retention times described using the equation had a standard deviation of 1.1%. The inclusion of a quadratic term in the equation was found to be unwarranted. BothS and lnk _o varied linearly with ln molar mass. The logarithm of peak width of an eluting polystyrene peak was found to be a linear function of the mobile phase composition at elution. The slope was equal toS.