利用微悬臂梁表面应力研究聚N-异丙基丙烯酰胺分子的构象转变

提出了一种基于微悬臂梁传感技术研究大分子折叠/构象转变的新方法.通过分子自组装的方法将热敏性的聚N-异丙基丙烯酰胺(PNIPAM)分子链修饰到微悬臂梁的单侧表面，用光杠杆技术检测温度在20—40℃之间变化时由于微悬臂梁上的PNIPAM分子在水中的构象转变所引起的微悬臂梁变形.实验结果显示：在升温过程中，微悬臂梁的表面应力发生了变化并且导致微悬臂梁产生了弯曲变形，这个过程对应着微悬臂梁上的PNIPAM分子从无规线团构象到塌缩小球构象的构象转变.在降温过程中，微悬臂梁发生了反方向的弯曲变形，这对应着PNIPA 关键词： 构象转变 聚N-异丙基丙烯酰胺分子链 表面应力 微悬臂梁     

大型钢结构人行景观天桥的有限元分析

采用有限元方法对大型钢结构人行景观天桥进行了静力学、温度应力、动力学模态和初步的抗震能力分析,并就桥自重作用下的最大竖向位移和实际观测结果进行了比较,两者是一致的.计算结果表明:人行景观天桥在常规、温度极值改变和多遇地震荷载作用等多种工况下,现有的设计方案具有足够的强度、刚度和抗震能力.     

测量冷原子温度的理论与近似拟合公式的误差分析

对短程飞行时间法(tim e-of-flight,TOF)中推算冷原子温度的理论拟合公式与近似拟合公式进行了误差分析与比较。研究表明:对于使用短程飞行吸收光谱信号推测冷原子团温度,当探测光光斑半径与冷原子团高斯半径之比k小于0.2时,理论拟合公式和近似拟合公式能很好的相符,随着探测光光斑半径与冷原子团高斯半径比值的逐渐增大,用近似拟合公式所得TOF吸收信号与用理论拟合公式所得TOF吸收信号的误差也将逐渐增大,当比值为0.5时,用近似拟合公式所得TOF吸收信号的误差将增大到20%。     

Preparation and characterization of ZnO nanorods from NaOH solutions with assisted electrical field

ZnO naorods on ZnO-coated seed substrates were fabricated by solution chemical method from Zn(NO₃)₂/NaOH under assisted electrical field. The working mechanism of electrical field was analyzed and the factors affecting the rod growth such as potential, precursor concentration and growth temperature were elucidated. The structural and optical properties are characterized by SEM, TEM, XRD, HRTEM and UV-vis. The results indicated that the nanorods have wurtzite structure without electrical field and are primarily of zincite structure under electrical field; when the electrical field is 1.1-1.3 V, not only the elevation of ion diffusion and adsorption lower the crystallite/solution interfacial energy and then the crystal nucleation barrier by increasing charge intensity, but also the production of H⁺ through oxidation of OH⁻ increases properly the degree of solution supersaturation near the substrate, and thus lowers the activation energy. Both the two processes do favor to rod growth. With increasing precursor concentration in this system, the average diameter and length of ZnO nanorods increase, leading to decreasing of optical transmittance. The maximum rod growth rate at given concentration of Zn²⁺ occurs at a specific temperature.     

Parking Capacity and Pricing in Park'n Ride Trips: A Continuous Equilibrium Network Design Problem

In this paper we consider the problem of designing parking facilities for park'n ride trips. We present a new continuous equilibrium network design problem to decide the capacity and fare of these parking lots at a tactical level. We assume that the parking facilities have already been located and other topological decisions have already been taken.The modeling approach proposed is mathematical programming with equilibrium constraints. In the outer optimization problem, a central Authority evaluates the performance of the transport network for each network design decision. In the inner problem a multimodal traffic assignment with combined modes, formulated as a variational inequality problem, generates the share demand for modes of transportation, and for parking facilities as a function of the design variables of the parking lots. The objective is to make optimal parking investment and pricing decisions in order to minimize the total travel cost in a subnetwork of the multimodal transportation system.We present a new development in model formulation based on the use of generalized parking link cost as a design variable.The bilevel model is solved by a simulated annealing algorithm applied to the continuous and non-negative design decision variables. Numerical tests are reported in order to illustrate the use of the model, and the ability of the approach to solve applications of moderate size.     

数字放大器—3G无线基站的助推器

为了构筑第三代无线网络,人们需要对现有基础设施进行彻底改造,包括网络的发射基站。配置在无线基站中的新型数字控制功率放大器能够改善频谱利用率和功率效率,从而提高系统容量。PMC-Sierra公司的数字控制功率放大器采用了数字校正信号处理器(DCSP)以及自适应控制处理器和补偿估值器(ACPCE),该放大器可改善无线基础设施的可靠性,同时降低系统成本、规模及复杂性。     

The Effect of Polymer Optoelectronic Properties on the Performance of Multilayer Hybrid Polymer/TiO2 Solar Cells

We report a study of the effects of polymer optoelectronic properties on the performance of photovoltaic devices consisting of nanocrystalline TiO₂ and a conjugated polymer. Three different poly(2‐methoxy‐5‐(2′‐ethylhexoxy)‐1,4‐phenylenevinylene) (MEH‐PPV)‐based polymers and a fluorene–bithiophene copolymer are compared. We use photoluminescence quenching, time‐of‐flight mobility measurements, and optical spectroscopy to characterize the exciton‐transport, charge‐transport, and light‐harvesting properties, respectively, of the polymers, and correlate these material properties with photovoltaic‐device performance. We find that photocurrent is primarily limited by the photogeneration rate and by the quality of the interfaces, rather than by hole transport in the polymer. We have also studied the photovoltaic performance of these TiO₂/polymer devices as a function of the fabrication route and device design. Including a dip‐coating step before spin‐coating the polymer leads to excellent polymer penetration into highly structured TiO₂ networks, as was confirmed through transient optical measurements of the photoinduced charge‐transfer yield and recombination kinetics. Device performance is further improved for all material combinations studied, by introducing a layer of poly(ethylene dioxythiophene) (PEDOT) doped with poly(styrene sulfonic acid) (PSS) under the top contact. Optimized devices incorporating the additional dip‐coated and PEDOT:PSS layers produced a short‐circuit current density of about 1 mA cm^–2, a fill factor of 0.50, and an open‐circuit voltage of 0.86 V under simulated AM 1.5 illumination (100 mW cm^–2, 1 sun). The corresponding power conversion efficiency under 1 sun was ≥ 0.4 %.     

Adaptive application of operators in standard representation

Recently adaptive wavelet methods have been developed which can be shown to exhibit an asymptotically optimal accuracy/work balance for a wide class of variational problems including classical elliptic boundary value problems, boundary integral equations as well as certain classes of noncoercive problems such as saddle point problems. A core ingredient of these schemes is the approximate application of the involved operators in standard wavelet representation. Optimal computational complexity could be shown under the assumption that the entries in properly compressed standard representations are known or computable in average at unit cost. In this paper we propose concrete computational strategies and show under which circumstances this assumption is justified in the context of elliptic boundary value problems. Dedicated to Charles A. Micchelli on the occasion of his 60th birthday Mathematics subject classifications (2000) 41A25, 41A46, 65F99, 65N12, 65N55. This work has been supported in part by the Deutsche Forschungsgemeinschaft SFB 401, the first and third author are supported in part by the European Community's Human Potential Programme under contract HPRN-CT-202-00286 (BREAKING COMPLEXITY). The second author acknowledges the financial support provided through the European Union's Human Potential Programme, under contract HPRN-CT-2002-00285 (HASSIP) and through DFG grant DA 360/4–1.     

Comparative Study on Large and Small Signal Theory for Intensity Modulation Response of Semiconductor Lasers Including Higher-Order Dispersion Terms

In this article, the comparison of large signal theory and small signal theory has been done with dispersive propagation of optical signal with IMDD (Intensity Modulation Direct Detection) systems for semiconductor lasers with higher-order dispersion terms. The expressions for an exact large signal theory and small signal theory including higher-order dispersion terms for propagation of an optical wave with sinusoidal amplitude and frequency modulation in a dispersive fiber have been derived. It is observed that small signal theory is more sensitive compared to large signal theory in terms of intensity modulation/direct detection systems. Also, it is reported that for large signal analysis the higher-order effects of dispersion can be ignored, whereas for small signal theory, the higher-order effects can be ignored for lower modulation frequencies only. The variation in the transfer function for various values of modulation indices are greater for small signal analysis than for large signal analysis. Also, as the intensity modulation index is increased, there is a decrease in the value of transfer function. The large signal model approximates the small signal model for lower values of the intensity modulation index.     

Converged properties of clean metal surfaces by all-electron first-principles calculations

All-electron full-potential linearized augmented plane-wave calculations of the surface energy, work function, and interlayer spacings of close-packed metal surfaces are presented, in particular, for the free-electron-like metal surfaces, Mg(0 0 0 1) and Al(1 1 1), and for the transition metal surfaces, Ti(0 0 0 1), Cu(1 1 1), Pd(1 1 1), and Pt(1 1 1). We investigate the convergence of the surface energy as a function of the number of layers in the slab, using the Cu(1 1 1) surface as an example. The results show that the surface energy, as obtained using total energies of the slab and bulk from separate calculations, converges well with respect to the number of layers in the slab. Obviously, it is necessary that bulk and surface calculations are performed with the same high accuracy. Furthermore, we discuss the performance of the local-density and generalized gradient approximations for the exchange-correlation functional in describing the various surface properties.