Mesoporous silica hybridized by ordered mesoporous carbon for in‐tube solid‐phase microextraction

To enhance the extraction performance, a mesoporous silica was modified with ordered mesoporous carbon for solid‐phase microextraction. Three stainless‐steel wires coated with the mesoporous material were placed in a polyetheretherketone tube for getting an extraction tube. The tube was coupled to high‐performance liquid chromatography with diode array detector, and the online analysis system was constructed. Then its extraction performance was evaluated using hydrophobic polycyclic aromatic hydrocarbons, phthalates, and hydrophilic neonicotinoids. The best selectivity was presented for polycyclic aromatic hydrocarbons. Several main conditions were optimized such as sampling volume, sampling rate, methanol concentration in the sample, and desorption time, a rapid and sensitive analytical method was established toward polycyclic aromatic hydrocarbons. The analytical method exhibited wide linear range from 0.017 to 15 µg/L with acceptable correlation coefficients more than 0.9990, limits of detection in 0.005‐0.020 µg/L, limits of quantification ranging from 0.017 to 0.066 µg/L as well as large enrichment factors of 377‐2314. It was successfully applied to detect trace polycyclic aromatic hydrocarbons in some real water samples including tap water, snow water, and domestic sewage.     

Photocatalysis: an overview of recent developments and technological advancements

Photocatalysis,which is the catalyzation of redox reactions via the use of energy obtained from light sources,is a topic that has garnered a lot of attention in recent years as a means of addressing the environmental and economic issues plaguing society today.Of particular interest are photosynthesis can potentially mimic a variety of vital reactions,many of which hold the key to develop sustainable energy economy.In light of this,many of the technological and procedural advancements that have recently occurred in the field are discussed in this review,namely those linked to:(1)photocatalysts made from metal oxides,nitride,and sulfides;(2)photocatalysis via polymeric carbon nitride(PCN);and(3)general advances and mechanistic insights related to TiO2-based catalysts.The challenges and opportunities that have arisen over the past few years are discussed in detail.Basic concepts and experimental procedures which could be useful for eventually overcoming the problems associated with photocatalysis are presented herein.     

Molybdenum Carbide‐Embedded Multichannel Hollow Carbon Nanofibers as Bifunctional Catalysts for Water Splitting

With the environmental pollution and non‐renewable fossil fuels, it is imperative to develop eco‐friendly, renewable, and highly efficient electrocatalysts for sustainable energy. Herein, a simple electrospinning process used to synthesis Mo₂C‐embedded multichannel hollow carbon nanofibers (Mo₂C‐MCNFs) and followed by the pyrolysis process. As prepared lotus root‐like nanoarchitecture could offer rich porosity and facilitate the electrolyte infiltration, the Mo₂C‐MCNFs delivered favourable catalytic activity for HER and OER. The resultant catalysts exhibit low overpotentials of 114 mV and 320 mV at a current density of 10 mA cm^?2 for HER and OER, respectively. Furthermore, using the Mo₂C‐MCNFs catalysts as a bifunctional electrode toward overall water splitting, which only needs a small cell voltage of 1.68 V to afford a current density of 10 mA cm^?2 in the home‐made alkaline electrolyzer. This interesting work presents a simple and effective strategy to further fabricating tunable nanostructures for energy‐related applications.     

High performance of nitrogen-doped carbon-supported cobalt catalyst for the mild and selective synthesis of primary amines

A nitrogen-doped carbon-supported Co catalyst (Co/N-C-800) was discovered to be highly active for the reductive amination of carbonyl compounds with NH₃ and the hydrogenation of nitriles into primary amines using H₂ as the hydrogen source. Structurally diverse carbonyl compounds were selectively transformed into primary amines with good to excellent yields (82.8–99.6%) under mild conditions. The Co/N-C-800 catalyst showed comparable or better catalytic performance than the reported noble metal catalysts. The Co/N-C-800 catalyst also showed high activity for the hydrogenation of nitriles, affording the corresponding primary amines with high yields (81.7–99.0%). An overall reaction mechanism is proposed for the reductive amination of benzaldehyde and the hydrogenation of benzonitrile, which involves the same intermediates of phenylmethanimine and N-benzylidenebenzylamine.     

活性炭前处理对双电层电容器性能的影响

制备了沥青焦基活性炭双电层电容器用电极材料,将其分别经水洗、酸洗以及超音速气流粉碎处理。在1 mol/L(C2H5)4NBF4/碳酸丙烯酯电解液体系中进行电化学测试,对比评价了各活性炭前处理方法对电容器电化学性能的影响。结果表明,酸洗后活性炭电极比电容提高7%达到163 F/g,高功率放电性能明显改善,当电流密度由70 mA/g增加到1 A/g时,其电极比电容保持率为88%;活性炭进行超细粉碎后不利于电化学性能的提高。     

Sb掺杂SnO2修饰双电层电容活性炭电极的研究

应用sol-gel浸渍与热处理工艺相结合,在活性炭表面包覆Sb掺杂的SnO2薄膜对电极进行修饰,构成AC-SnO2/KOH/AC-SnO2双电层电容器,测试结果表明,400 mA/g电流密度条件下,修饰后的双电层电容器在0.001～1.5 V相对较高电压区间的放电容量,比AC/KOH/AC双电层电容器在0.001～1.0 V电压区间高36%,但AC-SnO2的单电极比电容仅为AC单电极比电容的91.9%;当电流密度大于400 mA/g,两种电极的大电流性能相当。     

微波辐照石油焦制备双电层电容器用活性炭

以石油焦为原料,KOH为活化剂,采用微波辐照加热法,制备了石油焦基双电层电容器用活性炭。研究了石油焦与KOH活化剂的比例、微波功率以及微波辐照时间对活性炭孔径分布和比电容量的影响。结果表明:在KOH活化剂与石油焦的质量比为3.5∶1,微波功率800W和辐照时间7min时,制备的活性炭比表面积为2031.96m2/g,比电容量达286.79F/g,以该活性炭作电极的双电层电容器有良好的循环稳定性和充放电性能。     

Organophosphine bearing multiple hydrogen-bond donors for asymmetric Michael addition reaction of 1-oxoindane-2-carboxylic acid ester via dual-reagent catalysis

Multiple hydrogen bonds containing nucleophilic phosphines derived from dipeptide dual-reagents catalyzed asymmetric Michael addition reactions between indene esters and activated olefins in high yields and good to excellent enantioselectivities under mild reaction conditions. The success of current highly selective reactions should provide inspiration for expansion to other reactions and would open up new paradigms for the synthesis of indanone derivatives bearing chiral quaternary carbon centers.     

Research on Preparation Methods of Carbon Nanomaterials Based on Self-Assembly of Carbon Quantum Dots

Here, based on self-assembly of carbon quantum dots (CDs), an innovative method to prepare nanomaterials under the action of a metal catalyst was presented. CDs were synthesized by a one-step hydrothermal method with citric acid (CA) as the carbon source, ethylenediamine (EDA) as the passivator and FeSO₄•7H₂O as the pre-catalyst. In the experiment, it was found that the nano-carbon films with a graphene-like structure were formed on the surface of the solution. The structure of the films was studied by high-resolution transmission electron microscopy (HRTEM), Fourier transform infrared (FT-IR), etc. The results demonstrated that the films were formed by the self-assembly of CDs under the action of the gas–liquid interface template and the metal catalyst. Meanwhile, the electrochemical performance of the films was evaluated by linear cyclic voltammetry (CV) and galvanostatic charge discharge (GOD) tests. In addition, the bulk solution could be further reacted and self-assembled by reflux to form a bifunctional magnetic–fluorescent composite material. Characterizations such as X-ray diffractometer (XRD), fluorescence spectra (FL), vibrating sample magnetometer (VSM), etc. revealed that it was a composite of superparamagnetic γ-Fe₂O₃ and CDs. The results showed that self-assembly of CDs is a novel and effective method for preparing new carbon nanomaterials.     

Antimicrobial Activities of Plant Extracts against Solanum tuberosum L. Phytopathogens

The purpose of the study was to select an environmentally friendly plant biopesticide to protect seed potatoes against phytopathogens. The scope included the evaluation of the antimicrobial activities of 22 plant water extracts, 22 water-glycol extracts, and 3 subcritical carbon dioxide extracts using the agar diffusion method against 10 potato phytopathogens. For the most effective extracts, minimal inhibitory concentration (MIC), chemical composition analysis by gas chromatography–mass spectrometry and in situ assays on seed potatoes were performed. Garlic water extract was finally selected as the most effective in phytopathogen growth inhibition, both in vitro and in situ, with MIC values ranging between 6.3–25 mg/mL. 5-Hydroxymethylfurfural was determined to be the main component of this extract (33.24%). Garlic water extract was proposed as a potential biopesticide against potato phytopathogens.