Phosphorescence lifetime of naphthalene and phenanthrene in aggregated aromatic molecule-β-cyclodextrin-precipitant complexes

Aggregated aromatic molecule--cyclodextrin-precipitant complexes exhibit long-lived phosphorescence at room temperature in water after the chemical binding of oxygen. The temperature dependences of the phosphorescence lifetimes of naphthalene-h₈, naphthalene-de, and phenanthrene in the aggregates were measured. For example, the phosphorescence lifetimes of naphthalene-d₈ aggregated with -cyclodextrin and cyclohexane are equal to 25.1, 17.6, and 6.8 s at 77, 276, and 347 K, respectively, and that of phenanthrene aggregated with isooctane and -cyclodextrin are 3.24, 3.06, and 1.26 s at 268, 274, and 335 K, respectively. The temperature dependences of the phosphorescence lifetimes at room temperature are determined by the rate constants of the radiative and nonradiative transitions from the triplet state of an aromatic molecule.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 9, pp. 2225–2228, September, 1996.     

Potentiometric measurements of the first hydrolysis quotient of magnesium(II) to 250°C and 5 molal ionic strength (NaCl)

The first molal hydrolysis quotient, Q_1.1, of Mg²⁺ was measured potentiometrically from 1 to 250°C at ionic strengths of 0.11, 0.31, 1.01, and 5.0 mol-kg^-1 in an aqueous NaCl medium using a hydrogen-electrode, concentration cell. Only hydrolysis of the first four percent of the magnesium in solution could be followed before precipitation of brucite, Mg(OH)₂(cr), occurred. The log Q_1.1 values were fitted as a function of temperature and ionic strength using four adjustable parameters. The resulting constants are compared with the limited existing low temperature data. At infinite dilution and 25°C the following quantities are reported: logK _1.1 = -11.68±0.05, †H_so = 70.1±1.2 kJ-mol^-1, †S^o = 11±4 J-K^-1-mol^-1, and †C _p ^o = 0 J-K^-1-mor^-1. At each ionic strength, including the values extrapolated to infinite dilution, the heat capacity change for the hydrolysis reaction was zero,i.e., logQ _1.1 was found to be a linear function of the reciprocal temperature in Kelvin, at least over the measured range of l-250°C. The hydrolysis constants at infinite dilution were modeled to 550°C and two kbar pressure with a function incorporating solvent density using published results obtained at these extreme conditions.     

Investigation of the thermophysical properties of polymers by the temperature wave technique

The technique of temperature waves to measure the complex thermophysical characteristics of materials has been proposed. The relations for the moduli and arguments of these characteristics for the case of plane temperature waves have been calculated. The temperature dependences of the moduli and arguments of complex thermophysical characteristics of polyvinylacetate (PVAc) at different frequencies and also the temperature dependences of its vibrational and configurational heat capacities have been determined. It has been shown that the vibrational heat capacity of PVAc in the region of softening grows sharply and its configurational heat capacity goes through a peak. The segmental mobility has been found to affect the heat transfer in the polymer in an ambivalent way causing both a decrease and increase of thermal conductivity.

---

Zusammenfassung Zur Bestimmung der komplexen thermophysischen Eigenschaften von Stoffen wurde eine Temperaturwellentechnik vorgeschlagen. Für den Fall zweidimensionaler Temperatur-wellen wurden die Verhältnisse von Moduli und Argumenten dieser Eigenschaften berechnet. Die Temperaturabhängigkeit von Moduli und Argumenten der komplexen thermophysischen Eigen-schaften von Polyvinylacetat (PVAc) bei verschiedenen Frequenzen und auch die Temperatur-abhängigkeit seiner Vibrations- und Konfigurations-Wärmekapazitäten wurden bestimmt. Es wurde gezeigt, daß die Vibrations-Wärmekapazität von PVAc im Erweichungsbereich scharf zunimmt und die Konfigurations-Wärmekapazität durch einen Peak geht. Man fand, daß die Segment-Mobilität den Wärmetransport im Polymer auf eine ambivalente Weise beeinflußt, in dem die Wärmeleit-fähigkeit entweder gesenkt oder angehoben wird.

     

Measurement and modeling of the glass transition temperatures of multi-component solutions

Protein crystals are usually grown in multi-component aqueous solutions containing salts, buffers and other additives. To measure the X-ray diffraction data of the crystal, crystals are rapidly lowered to cryogenic temperatures. On flash cooling, ice frequently forms affecting the integrity of the sample. In order to eliminate this effect, substances called cryoprotectants are added to produce a glassy (vitrified) state rather than ice. Heretofore, the quantity of cryoprotectant needed to vitrify the sample has largely been established by trial and error. In this study, differential scanning calorimetry (DSC) was used to measure the melting (T_m), devitrification (T_d) and glass transition (T_g) temperatures of solutions with a range of compositions typical of those used for growing protein crystals, with the addition of glycerol as cryoprotectant. The addition of cryoprotectant raises the T_g and lowers the T_m of bulk solution thereby decreasing the cooling rates required for vitrification of protein crystals. The theoretical T_g value was calculated using the apparent volume fraction using the Miller/Fox equation extended for multi-component systems. The experimental values of T_g were within approximately ±4% of that predicted by the model. Thus, the use of the model holds the promise of a rational method for the theoretical determination of the composition of cryoprotectant requirement of protein crystallization solutions.     

Dielectric relaxation of polystyrene with side-chain- and chain-end-labels

Polystyrenes with different concentrations of side groups with cyano groups were prepared and complex dielectric constants were measured in the range of the glass transition temperature and the frequency range of 10^–2–10⁷ Hz.The GPC and DSC measurements showed that the molecular weight of these polystyrenes was about 10500 g/mole and the glass transition temperatures were 89.5°C for all samples.The dielectric relaxation spectra obtained for the side group polystyrene labels and also the chain-end polystyrene labels prepared before [9] were analyzed to find out the degree of coupling of the chain-end and side-group labels with the cooperative reorientation of the polymeric matrix. The analysis of the spectra was carried out using the analysis method developed by Mansour and Stoll [6].The results obtained showed that both end- and side-group labels are strongly coupled with the segmental reorientation and relax with relaxation times longer than that of the segments.The value of logf _m = (logf _m(label)) – logf _m(matrix)) was obtained from the recently designed comparison diagram suggested by Mansour and Stoll [6, 14]. The value of logf _m depends on the label length in the case of chain-end labels.It was surprising to find that the side groups relax slower than the segments by only 0.9 decades. These results obtained implied that the label relaxes through a multistep relaxation mechanism of the side and end groups and not through a diffusion mechanism of the whole chain. In addition, the effective lengths of the relaxing units were determined using the empirical equation obtained before in the case of rodlike molecules in polyisoprene [7].     

RuO2 electrode surface effects in electrocatalytic oxidation of glucose

We have studied the electrocatalytic activity of RuO₂-PVC film electrodes, fabricated using RuO₂ powders prepared at five different temperatures, viz., 300, 400, 500, 600 and 700°C, for the oxidation of glucose in high alkaline media, 1 to 3 M NaOH. The RuO₂-PVC film electrodes have been first characterized in 1 to 3 M NaOH solution by cyclic voltammetry (CV) and rotating disc electrode (RDE) techniques in a wide potential range −1,100 to 450 mV (SCE), and three redox pairs representing Ru(IV)/Ru(III), Ru(VI)/Ru(IV) and Ru(VII)/Ru(VI) transitions have been identified. The voltammetric peaks at low sweep rates have been analyzed using surface activity theory formulated for interacting electroactive adsorption sites, and interaction terms have been evaluated. The total voltammetric surface charges have been analyzed as per Trassatti’s formalism with respect to their dependence on potential sweep rate, and charges associated with less accessible and more accessible surface sites have been calculated. For glucose oxidation, the results have indicated that RuO₂ (700°C)-PVC electrode shows two oxidation peaks in contrast to RuO₂ (300°C)-PVC electrode. Also, RuO₂ (700°C)-PVC electrode exhibits higher intrinsic electrocatalytic activity than the 300°C electrode, although the former possesses lower electrochemically active surface area. Additionally, kinetic analyses made from RDE results with reference to Michealis–Menten (MM) enzyme catalysis has shown that RuO₂ (700°C) electrode possesses extended glucose-sensing range in terms of MM kinetic constant, K _M , compared to other electrodes. Possible reasons for such differences in the behavior of the electrodes of different temperatures towards glucose oxidation are identified from studies on oxidation of glucose in solutions of different pH, oxidation of different glucose derivatives, and also from physicochemical results from BET, XRD, SEM, DTGA, XPS analysis of RuO₂ powder samples.     

Formatation of pore structure in tape-cast alumina membranes – effects of binder content and firing temperature

Disc type ceramic aluminium oxide membrane has been prepared by tape casting technique. Thickness of this single layer membrane is in the range 200–300 μm. Porosity and pore size distribution have been determined by mercury porosimetry. Polymeric binder content of the green tape and the firing temperature are found to have strong influence on the average pore size, pore size distribution and overall porosity. Higher binder content promotes agglomeration of the ceramic particles, which on firing leads to wider pore size distribution and formation of closed pores. Pore coarsening is observed with increasing firing temperature.     

Parametric study of the flow and temperature fields in an inductively coupled r.f. plasma torch

A theoretical investigation of the effect of different parameters on the flow and the temperature fields in a radiofrequency inductively coupled plasma is carried out. The parameters studied are: central injection gas flow rate, total gas flow rate, input power, and the type of plasma gas. The results obtained for argon and nitrogen plasmas at atmospheric pressure indicate that the flow and the temperature fields in the coil region, as well as the heat flux to the wall of the plasma confinement tube, are considerably altered by the changes in the torch operating conditions.     

Synthesis and Stereochemistry of New Bis(1,3-Oxathian-2-yl) Derivatives: Epimerisation and Chair–Twist Equilibria

The synthesis and stereochemistry of some new bis(1,3-oxathian-2-yl) derivatives are reported. The conformational behavior of these compounds and the orientation of their substituents are deduced from the NMR spectra, from the X-ray crystal structures of two compounds and from the ab-initio level calculations. The epimerization of diastereoisomers and the chair ⇌ 22,5-twist equilibria were studied by variable temperature NMR.     

Effect of Oxygen Redistribution on the Normal and Superconducting Properties of Yttrium High‐Temperature Superconductors

An anomaly is found in the vicinity of T_max 560$ K on electric resistance versus temperature curves for yttrium hightemperature superconductors of the 123 phase. Xray phase analysis suggests a structural phase transition in the vicinity of T_max due to oxygen redistribution in the mobile sublattice of this compound. Investigation of samples with Y partially replaced by Ca has shown that the structural phase transition does not depend on carrier concentration in the conduction band.