Design of a combined ozone/electron beam process for waste water and economic feasibility of the process

A design of a combined ozone/electron beam irradiation process for treating a 50 m³/h waste water stream from a molasses processing is discussed. Moreover, a cost evaluation of such a process in comparison to a conventional ozonation/biology treatment process has been performed to assess the potential of the irradiation process for technical use. Although the result of this comparison is not bad for the irradiation process an implementation into a full scale plant would not seem to be the thing to do in the present case.     

甲烷在Ni表面及La薄膜上激活解离化学吸附

利用分子束技术改变甲烷的平动能E_k来研究E_k及其法向分量E_n对甲烷在Ni表面及La薄膜上激活解离吸附的影响。对CH_4/Ni及CH_4/La系统, 当甲烷的平动能E_k分别低于58.5 kJ·mol~(-1)及52.3 kJ·mol~(-1)时, 没观察到甲烷的解离吸附。当甲烷的平动能超过此阈值时, 即对CH_4/Ni系统, 当Ek=58.5增至63.8 kJ·mol~(-1)时, 初始沾着几率s_0由0至0.54线性增加; 对CH_4/La系统, 当E_k=52.3增至63.8 kJ·mol~(-1)时, S_0由0至0.49线性增加。这些结果表明, 两个系统的化学吸附是不经过前趋态的直接化学吸附。最后求出CH_4/Ni, CH_4/La系统的表观活化能分别为46.8 kJ·mol~(-1)和38.1 kJ·mol~(-1)。     

Controllable donor-acceptor neutral [2]rotaxanes

In pursuit of a neutral bistable [2]rotaxane made up of two tetraarylmethane stoppers--both carrying one isopropyl and two tert-butyl groups located at the para positions on each of three of the four aryl rings--known to permit the slippage of the pi-electron-donating 1,5-dinaphtho[38]crown-10 (1/5DNP38C10) at the thermodynamic instigation of pi-electron-accepting recognition sites, in this case, pyromellitic diimide (PmI) and 1,4,5,8-naphthalenetetracarboxylate diimide (NpI) units separated from each other along the rod section of the rotaxane's dumbbell component, and from the para positions of the fourth aryl group of the two stoppers by pentamethylene chains, a modular approach was employed in the synthesis of the dumbbell-shaped compound NpPmD, as well as of its two degenerate counterparts, one (PmPmD) which contains two PmI units and the other (NpNpD) which contains two NpI units. The bistable [2]rotaxane NpPmR, as well as its two degenerate analogues PmPmR and NpNpR, were obtained from the corresponding dumbbell-shaped compounds NpPmD, PmPmD, and NpNpD and 1/5DNP38C10 by slippage. Dynamic 1H NMR spectroscopy in CD2Cl2 revealed that shuttling of the 1/5DNP38C10 ring occurs in NpNpR and PmPmR, with activation barriers of 277 K of 14.0 and 10.9 kcal mol(-1), respectively, reflecting a much more pronounced donor-acceptor stabilizing interaction involving the NpI units over the PmI ones. The photophysical and electrochemical properties of the three neutral [2]rotaxanes and their dumbbell-shaped precursors have also been investigated in CH2Cl2. Interactions between 1/5DNP38C10 and PmI and NpI units located within the rod section of the dumbbell components of the [2]rotaxane give rise to the appearance of charge-transfer bands, the energies of which correlate with the electron-accepting properties of the two diimide moieties. Comparison between the positions of the visible absorption bands in the three [2]rotaxanes shows that, in NpPmR, the major translational isomer is the one in which 1/5DNP38C10 encircles the NpI unit. Correlations of the reduction potentials for all the compounds studied confirm that, in this non-degenerate [2]rotaxane, one of the translational isomers predominates. Furthermore, after deactivation of the NpI unit by one-electron reduction, the 1/5DNP38C10 macrocycle moves to the PmI unit. Li+ ions have been found to strengthen the interaction between the electron-donating crown ether and the electron-accepting diimide units, particularly the PmI one. Titration experiments show that two Li+ ions are involved in the strengthening of the donor-acceptor interaction. Addition of Li+ ions to NpPmR induces the 1/5DNP38C10 macrocycle to move from the NpI to the PmI unit. The Li+-ion-promoted switching of NpPmR in a 4:1 mixture of CD2Cl2 and CD3COCD3 has also been shown by 1H NMR spectroscopy to involve the mechanical movement of the 1/5DNP38C10 macrocycle from the NpI to the PmI unit, a process that can be reversed by adding an excess of [12]crown-4 to sequester the Li+ ions.     

Electron beam irradiated textile cellulose fibres.: ESR studies and derivatisation with glycidyl methacrylate (GMA)

Powdered samples of cotton, flax and viscose from textile fibres were subjected to electron beam irradiation (20-400 KGy). ESR signals were observed after irradiation. The intensity of the signals depended on the administered dose and exhibited an exponential decay with time. The ESR spectra, whose pattern depended drastically on the crystallinity of the samples, indicated the simultaneous presence of at least three carbon-centred radical species. When the whole irradiated textile fibres were quenched in a solution of glycidyl methacrylate (GMA) a significant increase of the weight was observed, the increase being strongly dependent on the administered dose and on the time interval elapsed between irradiation and quenching. Spectroscopic characterisation evidenced that GMA acted as cellulose radicals scavenger on the unsubstituted carbon of the double bond and was covalently linked to the fibre through a new C-C bond while maintaining unaltered the ester and the epoxide groups, available for further derivatisations. Because irradiation of the whole textile fibres in the range 20-200 KGy does not result in significant degradation of the material, GMA quenching of fibres irradiated in this dose range may represent an attractive route to their functionalisation.     

Analytical,structural and electrical characterization of SiGe layers by electron microbeam techniques

k-ratios of Ge-L and Si-K measured at different beam energies allow to evaluate simultaneously composition and thickness of SiGe layers on a Si substrate. A simple technique applying backscattered electrons also enables estimation of composition of bulk SiGe and of composition and thickness of relatively thick (200 nm) SiGe layers on Si. Electron channeling patterns of pseudomorphic SiGe/Si structures and of pure Si substrate show no significant differences whereas in relaxed structures a smearing of the pattern with increasing density of misfit dislocations is observed. Under particular conditions the technique of the electron beam induced current permits imaging of recombination-active misfit dislocations with a spatial resolution around 0.2 m. Moreover, a repulsion of holes due to the valence-band offset in a n-Si/SiGe heterostructure was detected.     

Mechanical properties of fiber reinforced styrene-butadiene rubbers using surface-modified UHMWPE fibers under EB irradiation

Aiming to develop a high performance fiber reinforced rubber of SBR, a special technique using electron beam (EB) irradiation-induced graft-polymerization was applied to ultra-high molecular-weight polyethylene (UHMWPE) fibers. Although UHMWPE is chemically inert, N-vinyl formamide (NVF) could be graft-polymerized onto the UHMWPE fiber surface with this special technique. A maximum grafting percentage of 23.6% was achieved. The composite of SBR and grafted UHMWPE fibers with maximum grafting indicated a linear increase in the initial modulus and strength with the fiber content. At the fiber content of 10%, the initial modulus was improved about five times with respect to that of the pure SBR, while the strength was done about twice. At this moment, only a small reduction could be observed in the strain compared with that of pure SBR. The fiber reinforced rubber with a good performance was obtained in the system of SBR and grafted UHMWPE fibers.     

Microstructural and physicochemical study of the buried Fe/AlGaAs(100) interface by transmission electron microscopy and x‐ray emission spectroscopy

Among the magnetic metal/semiconductor contacts, the Fe/GaAs system has been widely studied owing to its potential applications in electronic devices. In contrast, there are not many studies concerning the Fe/Al_xGa_1?xAs contact, and in particular there are no reports concerning the changes induced in the interfacial zone by the presence of Al. In this work, thin polycrystalline iron films were deposited by ion beam sputtering at room temperature on a 300 nm thick Al_0.25Ga_0.75As layer grown by molecular beam epitaxy onto GaAs(001). X‐ray diffraction analysis showed that the iron films are polycrystalline, and indications of a (002) texture of the film were observed. The fine scale analysis of the interface was achieved by high‐resolution transmission electron microscopy (HRTEM) observations, the results of which are compared with the physicochemical information obtained from electron‐induced x‐ray emission spectroscopy, by analysing the Al 3p valence states at the Fe/Al_xGa_1?xAs interface. The HRTEM experiments on cross‐section samples indicate that the interfacial zone between iron and AlGaAs is limited to <1.5 nm in thickness. X‐ray emission spectroscopy showed the presence of Al atoms in an FeAl‐like environment at the interface, and the existence of wrong bonds and point defects. The estimated width of the perturbed interface (2.0 ± 0.5 nm) is in agreement with the HRTEM results. Copyright © 2003 John Wiley & Sons, Ltd.     

Polarization of coherent synchrotron radiation from an electron beam rotating in a plasma

After eliminating reflections from the walls of the plasma container, we observed polarization of the coherent synchrotron radiation from a relativistic electron beam rotating in a plasma. Several features of the polarization agree well with calculations based on the single particle synchrotron radiation theory. A particular polarization ratio (Fig. 3) does not, however. We deduce from this direct diffraction of the radiation by the beam electrons. This is strong evidence for beam-particle bunches of size cm. Also, there must be some absorption of the extraordinary wave to account for the observations. We suggest a way to apply these results to measure the pitch angle of the beam.Work supported by Army Research Office.     

基于弹簧管悬臂梁的FBG压力传感的研究

提出了一种等强度悬臂梁与弹簧管结合的高灵敏度的光纤布拉格光栅(FBG)压力传感器。将FBG粘贴在悬臂梁的下表面,粘贴方向与悬臂梁轴线一致。理论分析了FBG中心波长相对偏移量与压力的关系,实验测得该传感器的压力灵敏度为2.767×10-4/MPa,是裸FBG压强灵敏度系数的142倍。压力灵敏度与悬臂梁和弹簧管的几何参数有关,改变参数,可获得不同灵敏度的压力传感器。     

X波段同轴腔多注速调管的研究

开展了具有同轴谐振腔互作用电路和双模工作杆控电子枪的X波段同轴腔双模多注速调管的研究工作.结合数值计算和冷测实验,对工作于TM₃₁₀高次模的同轴谐振腔模式分布和特性参数进行研究,获得了可满足多注速调管要求的谐振腔特性阻抗和良好的模式稳定性.采用具有双控制极的新型杆控多注电子枪及电子光学系统,可使多注速调管具有双模的新工作特性,通过数值模拟获得了优化的几何参数和具有良好层流性和波动性的空心多电子注.对采用6个电子注和5个谐振腔的X波段多注速调管进行了注波互作用大信号计算,结果表明当电子注电压为21.5kV,脉冲电流为14.4A时,可在30MHz频带范围内获得的100kW左右的脉冲输出功率,互作用效率大于30%,增益大于36dB.