Cu-Zr-Al非晶合金成分设计与激光熔覆

在采用团簇线判据优化设计Cu-Zr-Al非晶合金成分的基础上，采用激光熔覆技术在AZ91HP镁合金表面制备了Cu-Zr-Al合金涂层。研究结果表明，合金涂层是由非晶、Cu8Zr3和Cu10Zr7相所组成。通过X射线峰位分离计算表明，随着扫描速度增加，由于熔覆区冷却速率增大，稀释度降低，致使合金涂层中非晶相的相对含量上升，其最高质量分数可达61％。同时，由于金属间化合物的增强作用随着扫描速度的增加而减弱，致使合金涂层的硬度、弹性模量、耐磨性降低，而耐蚀性增高。     

非晶YBCO薄膜热释电红外探测器

介绍了非晶YBCO薄膜用作非制冷热释电红外探测器材料。它在室温下显示出强的热释电行为,并且容易在室温下采用射频磁控溅射法沉积,制备工艺与CMOS工艺相兼容,是 一种很有潜力的热释电探测器材料。并介绍了非晶YBCO热释电薄膜的研究现状,阐述了该薄膜及其探测器的制备技术和研究动向。     

Interdiffusion of polymers across interfaces

Neutron Reflection (NR) and Dynamic Secondary Ion Mass Spectroscopy (DSIMS) experiments were conducted on symmetrically deuterated polystyrene triblock bilayers (HDH/DHD) which directly probed the interdiffusion dynamics of the chains during welding. The HDH chains had their centers deuterated 50%, the DHD chains had their ends deuterated (25% at each end) such that each chain contained approximately 50% D. During welding, anisotropic motion of the chains produces a time-dependent oscillation (ripple) in the H and D concentration at the interface, which bears the characteristic signature of the polymer dynamics. These oscillations were compared with those predicted by Rouse, polymer mode coupling (PMC), and reptation dynamics. The following conclusions can be made from this study. (a) During the interdiffusion of high molecular weight HDH/DHD pairs, higher mobility of the chain ends caused a concentration oscillation which increased to a maximum amplitude, and eventually vanished at times, t > τ_D. The amplitude, or excess enrichment found, was appreciably more than that predicted by Rouse and PMC simulations, and was only slightly less than that predicted from reptation simulations. (b) The oscillations were completely missing in the 30 and 50K HDH/DHD polymers, which are only weakly entangled. The lack of oscillations for the 30 and 50K pairs may be due to a combination of surface roughness and fluctuations of order 30 Å. (c) It was found that the position of the maximum in this ripple stayed at the interface during its growth. This is also consistent with reptation and has not been explained by other theories. (d) All dynamics models for linear polymers produce ripples, many of which are qualitatively similar to that predicted for reptation. However, each ripple bears the fingerprint of the dynamics in terms of its time-dependent shape, position, and magnitude, and the models are clearly distinguishable. Our results, in summary, support reptation as a candidate mechanism of interdiffusion at polymer(SINGLEBOND) polymer interfaces and its uniqueness is being further pursued. © 1996 John Wiley & Sons, Inc.     

Characterization of the motion of spin probes and spin labels in amorphous polymers with two-dimensional field-step ELDOR

The motion of nitroxide spin probes and spin labels in amorphous polymers is studied below the glass transition temperature with a two-dimensional pulsed electron double-resonance experiment. Polystyrene and a liquid crystalline side group polymer are studied using both spin probes and spin labels covalently bound to specific sites along the polymer chain. Two methyl acrylic polymers differing only in their side group structure and polyvinylacetate are compared and large differences in the molecular dynamics deduced from both the nuclear and the electron spin relaxation rates are observed as the glass transition is approached. The results demonstrate the complexity of small amplitude motion in simple polymers below the glass transition temperature and show that it is very sensitive to the packing in the polymer. © 1996 John Wiley & Sons, Inc.     

化学镀镍硼合金镀层的结构及性能

本文研究了化学镀镍硼合金镀层的显微组织、结构和性能以及热处理对它们的影响。研究表明,该合金镀层在镀态下为非晶态,加热至250℃以上晶化,晶化稳定相为Ni、Ni3B。热处理后能显著提高镀层的硬度,400℃时保温1小时硬度可达HV1115。镀层具有良好的耐蚀性和附着力。     

Modelling segmental dynamics in miscible polymer blends

The complex thermorheological behaviour observed in miscible polymer blends is modelled by combining two existing theoretical approaches: The Thermal Concentration Fluctuation model (A. Zetsche, E.W. Fischer, Acta Polymer. 1994 , 45, 168) and the Effective Concentration model (T.P. Lodge, T.C.B. McLeish, Macromolecules 2000 , 33, 5278), giving rise to a simple model with only one adjustable parameter. This model is then tested in the case of two model blends allowing to show its abilities and limitations to describe how the respective segmental dynamics of lowest or highest T_g component are affected by blending.     

Isochronal Studies of α‐Si:H Crystallization and the Performance of it's Schottky Barriers

Hydrogenated amorphous silicon films (α‐Si:H) were crystallized employing a metal induced crystalline (MIC) technique. Structural changes during annealing these films at 300 °C for different periods (0‐300 minutes) were obtained by XRD. Al was used as a metal induced crystalline for α‐Si:H produced by ultra high vacuum (UHV) plasma enhanced chemical vapor deposition (PECVD). XRD shows that crystallization of the interacted α‐Si:H film underneath Al initiates at 300 °C for 15 minutes. A complete crystallization was obtained after annealing for 60 minutes. A gold dot was evaporated onto α‐Si:H films, which annealed for different periods to form Schottky barriers. Electrical properties of Au/α‐Si:H were calculated such as the ideality factor, n, barrier height, Φ_B, donor concentration, N_D, and the diffusion voltage, V_d, as a function of the annealing time of α‐Si:H films. All these parameters were carried out through the current voltage characteristics (J‐V) and the capacitance voltage measurements (C‐V). The results were presented a discussed on the basis of XRD performance and the thermionic emission theory.     

Copolymer Adsorption on Planar Chemically Heterogeneous Substrates: The Interplay between the Monomer Sequence Distribution and Interaction Energies

We use a three‐dimensional self‐consistent field model to study the adsorption of A‐B copolymers from A‐B copolymer/A homopolymer blends on planar substrates comprising two chemically distinct regions C and D. The interplay between the spatial distribution of the surface chemical heterogeneities and the monomer sequence distribution in the copolymer is examined for diblock (A‐B), triblock (A‐B‐A), inverted triblock (B‐A‐B), and alternating (A‐alt‐B) copolymers. Our results demonstrate that when the chemically heterogeneous motifs on the substrate are detected by the copolymer adsorbing segments, the copolymers can transcribe them with high fidelity into three dimensions. The way the surface pattern gets transferred is dictated by the monomer sequence distribution. We show that relative to alternating copolymers, block copolymers are generally better at capturing the chemical pattern shape and transcribing it into the polymer mixture. Moreover, block copolymers with shorter adsorbing blocks are capable of better recognizing the substrate motifs. In order to address the interplay between the monomer sequence distribution in the copolymer and the interaction energies, we systematically vary the repulsion between A and B, and the attraction between B and D. Our calculations reveal that increasing i) the interaction between the copolymer adsorbing segments (B) and the “sticky” points at the substrate (D), and/or ii) the repulsion between the copolymer segments (A and B) increases the total amount of the copolymer adsorbed at the mixture/substrate interface, and decreases (increases) the fidelity of the substrate chemical pattern recognition by compositionally symmetric (asymmetric) copolymers.     

LOW TEMPERATURE OPTICAL PROPERTIES OF AMORPHOUS OXIDE NANOCLUSTERS IN POLYMETHYL METHACRYLATE MATRIX

We studied the temperature-dependent steady-state and time-resolved fluorescence properties of very small (1-2 nm) ZnO, CdO, and PbO amorphous nanoclusters prepared in AOT reverse micelles and imbedded in polymethyl methacrylate(PMMA) films. X-ray diffraction and electron diffraction and imaging indicate that these structures are amorphous. These amorphous oxide nanoclusters demonstrate similar structural, electronic, and optical properties. Properties of steady-state fluorescence spectra indicate the unique localization of electronic states due to the amorphous structure. ZnO and CdO show double-band fluorescence structure, which is due to the spin-orbital splitting, similar to Cu₂O. Time-resolved fluorescence studies of the nanoclusters in the polymer reveal two lifetime components, as found in solution. The slow component reflects relaxation processes from band-tail states while the fast component may be related to high-lying extended states. The temperature dependence of fast fluorescence component reveals the presence of exciton hopping between anharmonic wells at temperatures higher than 200K. We correlate the barrier height between two wells formed around local atoms with the inter-atomic distance and bond ionicity.