Pyrolysis of tertiarybutylphosphine at low pressure

The pyrolysis of tertiarybutylphosphine (TBP) has been studied in the low pressure conditions used for chemical beam epitaxy (CBE). The pyrolysis studies were carried out in low pressure reactors of two different configurations, one of which is a cracker cell designed for use in a CBE system. The reaction products were studied using a quadrupole mass spectrometer. The products observed are accounted for by a reaction mechanism involving homolysis of the parent TBP molecule to produce PH₂ and C₄H₉ radicals. These undergo subsequent reactions to form the stable products C₄H₈, PH₃ and H₂, with smaller amounts of P and P₂ being produced. The production of the sub-hydride PH₂ using this cracker cell design indicates that the use of partially cracked TBP may be a promising technique for reducing the amount of carbon incorporated into the growing epitaxial layer.     

Current R & D activities at TRCRE in polymer processing by EB

The current status of the R & D activities is presented on electron beam processing of polymers being carried out at TRCRE. Topics included are sterilization of medical products, graft polymers for selective separation or absorbents and curing of liquid prepolymer-monomer systems.     

锁相技术在电子束曝光机工件台稳速控制中的应用

采用锁相技术，对电子束曝光机工件台运动实现速度环的全数字控制。设计了数字差频积分回路和数字差频比例控制器，能有效消除速度的静态误差和改善系统的动态特性。     

Zeeman transitions in deuterium atoms induced by ultra-relativistic electrons

We present data showing hyperfine transitions in an atomic deuterium beam induced by the (476 MHz) radio-frequency field of a 704 MeV electron beam in a storage ring. A polarized deuterium beam, produced in an atomic beam source, was crossed with a stored electron beam and analyzed with a Breit--Rabi polarimeter. Electron-beam induced transitions were singled out by injecting different combinations of hyperfine states. Transition probabilities as high as 70% were measured at large currents (~ 100 mA). All possible deuterium transitions for a radio-frequency of 476 MHz were observed. In addition, a 1--6 transition resulting from the first harmonic (952 MHz) was observed. The effects of these transitions are of general importance for the polarized internal target technique applied in nuclear and particle physics experiments. The data are reasonably described by numerical estimates. The observed mechanism can be exploited to create nuclear polarized atoms when injecting electron polarized atoms with no net nuclear polarization into a storage cell. However, when nuclear polarized atoms are injected, care should be taken to avoid this mechanism, since it would result in depolarization of the atoms. The studies enabled us to choose the magnetic guide field during our spin-dependent electron--deuteron scattering experiments, such that electron-beam induced depolarizing effects were avoided. This revised version was published online in July 2006 with corrections to the Cover Date.     

Low-Power Adaptive Biased Integrated Amplifiers

In this paper the author will present the working principle and the applications of a novel adaptive biasing topology, designed to decrease the stand-by power dissipation without affecting the transient performance of low-power amplifiers. The proposed circuit, whose principle and circuit topology can be implemented both in CMOS and in bipolar standard technologies, gives a biasing current whose value depends on the applied input differential voltage and can be set according to the requested transient performance constraints. The adaptive architecture can be utilized in the design of high-efficient low-power operational amplifiers, for the biasing of both the input stage (where the input source current is dynamically increased) and the output stage (where the output current can be controlled and limited). These amplifiers show a very good behaviour, evaluated in terms of two efficiency factors, if compared with those of other adaptive solutions and class-AB topologies, proposed in the literature. Simulation results and also measurements on a chip prototype, fabricated in a standard CMOS technology, are finally presented.     

Selective area epitaxy of CdTe

We have performed selective area epitaxy (SAE) of CdTe layers grown by molecular beam epitaxy using a shadow mask technique. This technique was chosen over other SAE techniques due to its simplicity and its compatibility with multiple SAE patterning steps. Features as small as 50 microns × 50 microns were obtained with sharp, abrupt side walls and flat mesa tops. Separations between mesas as small as 20 microns were also obtained. Shadowing effects due to the finite thickness of the mask were reduced by placing the CdTe source in a near normal incidence position. Intimate contact between the mask and the substrate was essential in order to achieve good pattern definition.     

准直孔法改善束流品质初探

本文提出了用准直孔结合调节束流导引磁场获得较好品质强流电子束的方法,运用该方法在1.5MeV直线感应加速器(LIA)进行了试验,结果准直束流前后沿明显减小,束亮度提高几倍;同时,用此方法测出了束密度及束亮度的径向分布.     

微型电磁继电器的制作和仿真分析

介绍了一种基于MEMS技术的微型电磁继电器的制作过程和仿真分析.这种微继电器的大小约是4mm×4mm×0.5mm,主要采用普通的微加工技术来完成全部制作工艺.与传统继电器相比,这种继电器采用平面线圈来代替螺线管线圈,有利于MEMS工艺,并且提出了一种双支撑的悬臂梁结构做为活动电极,具有较高的灵敏性和稳定性.另外,还进行了一些有关线圈通过激励电流后对活动电极产生电磁力的理论计算和仿真分析,利用这些结果可以对这种电磁继电器的结构和参数进一步优化.     

电子直线加速器磁控管频率稳定的自适应线性神经元方法

 电子直线加速器电子束能量的稳定与否取决于功率源工作频率的稳定性,磁控管在短时间内的散谱和轻微跳谱造成稳频系统的控制精度下降,最后电子束的扫描均匀度下降。引入自适应线性神经元方法(ADALINE)和噪声对消技术以消除对工作频率长期稳定性的影响,从而保证了电子束的扫描均匀度。     

Numerical propagation of partially coherent laser beams through optical systems

The propagation of partially coherent beams through optical systems is computed numerically in one transverse dimension. The optical system is divided into different elementary segments, through which the propagation of light can be calculated by appropriate operators, working on the coherence function or the Wigner distribution function respectively. For the necessary changes between these two functions describing the partially coherent beams, the use of the remarkable z-transform seems to be an advantage. With this algorithm the grid and the resolution in the spatial frequency domain can be arbitrarily chosen in contrast to the usual Fourier transform, the influence of phase aberrations on the focusability of Gauss-Schell model beams is discussed as an application example of the numerical model. With the help of this tool, practical beam guiding systems can be simulated for use with multimode laser radiation.