用离子速度影象技术研究n-C4H9Br的光解

利用离子速度影象技术研究了正一溴丁烷(n-C4H9Br)在231~267 nm波段的光解,得出了如下结论:正一溴丁烷(n-C4H9Br)在231~267 nm波段的吸收源于基态到三个最低激发态的跃迁,这三个激发态标识为1A″、2A′和3A′;发生在这三个排斥态的势能面(PES)上的光解最终导致C4H9 Br(2P3/2)或C4H9 Br*(2P1/2)的产生;2A′和3A′态之间存在避免交叉(Avoided crossing)会影响最终的光解产物;从基态1A′到激发态1A″的跃迁矩垂直于对称面,也就垂直于C-Br键;从基态1A′到激发态3A′的跃迁矩平行于对称面,同时平行于C-Br键;从基态1A′到激发态2A′的跃迁矩在对称面内,且与C-Br键成53.1°夹角.我们也讨论了正一溴丁烷(n-C4H9Br)在234 nm和267 nm附近光解时的避免交叉几率(Avoided crossingprobability),以及它对单通道相对产额(Relative fraction of the individual pathways)的影响.     

红外动态图像生成技术概念研究

红外动态图像生成技术的基本概念包括基本术语及其定义。为了描述红外动态图像生成技术的特性,通常采用如光源类型、光谱波段、阵列规模、空间分辨率、填充因子、时间常数、帧频、闪烁、温度范围、串扰、均匀性、发射率、辐射对比度、动态范围、温度分辨率、调制传递函数、几何畸变及最大温度和最大辐射强度等概念。介绍了描述红外动态图像生成系统性能的基本概念的定义。转换器的指标定义对于转换器的设计和性能指标的测试都有重要的意义。     

某接收机测试台系统设计

介绍某接收机测试台设计方案、主要技术特点及实现方法。     

脉冲相干激光雷达对运动目标成像模拟

针对运动目标，在考虑激光雷达方程、信噪比和自动增益、成像指标、噪声、图像处理等模块的基础上，对脉冲相干成像激光雷达进行了运动目标的成像模拟。     

高性能小型扫描器

本文讨论了一种高性能小型扫描器的基本原理及扫描时序变换。对采用该小型扫描器的热成像系统也作了详细的介绍。该小型扫描器可满足多种用途。     

荧光波长对共焦显微镜成像特性的影响

导出了共焦显微镜中不同荧光波长情况下的荧光功率传输函数、三维脉冲响应函数（3D－PSF）和三维光学传递函数（3D－OTF）。结果表明，不同的荧光波长对共焦显微镜的空间截止频率、分辨率、光学传递函数存在明显的影响。当激发波长与荧光波长的比值下降到一定程度时，可以看到明显的失锥现象。     

群时延精确设计的全差分四阶Bessel滤波器

采用MOS管有源电阻,提出了一种全差分R-MOSFET-C四阶Bessel有源低通滤波器,.通过调节工作于亚阈值区的CMOS管的沟道导纳补偿电阻值的大小,能抵消集成电路制造工艺中电阻值的一致偏差,实现Bessel有源滤波器群时延的精确设计.根据无源滤波器的状态方程完成有源滤波器的综合,应用3.3V,0.5μm CMOS工艺完成了群时延大小为0.75μs的四阶Bessel低通滤波器的管极计算机仿真,仿真结果表明所提电路正确有效,适于全集成.     

Near-field thermoelastic imaging coupled with infrared detection

Near-field thermoelastic imaging is a simple way to investigate the thermal and coupled thermoelastic properties of materials. A few microscopes, deriving from the atomic force microscope, have been used to observe and to quantify the samples observed. But the main problem is the absolute measurement of the temperature, because surface topography and thermal expansion contributions are not easily discernible. In the proposed SThEM (scanning thermoelastic microscope), the tip is excited at the resonance frequency of the cantilever and the sample is periodically heated by the Joule effect. Thus the static contributions (drift, topography) are reduced. Moreover, a radiometric sensor, operating in the far field, has been added in order to quantify the temperature. This multi-acquisition microscope enables one to investigate small objects at the nanoscale with complementary information at the micrometric scale.     

Monolithic SiGe Up‐/Down‐Conversion Mixers with Active Baluns

The purpose of this paper is to describe the implementation of monolithically matching circuits, interface circuits, and RF core circuits to the same substrate. We designed and fabricated on‐chip 1 to 6 GHz up‐conversion and 1 to 8 GHz down‐conversion mixers using a 0.8 µm SiGe hetero‐junction bipolar transistor (HBT) process technology. To fabricate a SiGe HBT, we used a reduced pressure chemical vapor deposition (RPCVD) system to grow a base epitaxial layer, and we adopted local oxidation of silicon (LOCOS) isolation to separate the device terminals. An up‐conversion mixer was implemented on‐chip using an intermediate frequency (IF) matching circuit, local oscillator (LO)/radio frequency (RF) wideband matching circuits, LO/IF input balun circuits, and an RF output balun circuit. The measured results of the fabricated up‐conversion mixer show a positive power conversion gain from 1 to 6 GHz and a bandwidth of about 4.5 GHz. Also, the down‐conversion mixer was implemented on‐chip using LO/RF wideband matching circuits, LO/RF input balun circuits, and an IF output balun circuit. The measured results of the fabricated down‐conversion mixer show a positive power conversion gain from 1 to 8 GHz and a bandwidth of about 4.5 GHz.     

Computational Implementation of Asymmetric Integral Imaging by Use of Two Crossed Lenticular Sheets

We propose an asymmetric integral imaging method to adjust the resolution and depth of a three‐dimensional image. Our method is obtained by use of two lenticular sheets with different pitches fabricated under the same F/#. The asymmetric integral imaging is the generalized version of integral imaging, including both conventional integral imaging and one‐dimensional integral imaging. We present experimental results to test and verify the performance of our method computationally.