TiO2纳米棒光阳极的制备及性能改进

首先采用水热法制备 TiO2纳米棒光阳极,并引入 Au@SiO2纳米颗粒对其性能进行改善。结果表明,Au@SiO2纳米颗粒的引入虽然增强了光吸收,但同时减少了染料在 TiO2纳米棒上的吸附量,反而导致了电池器件性能的下降。因此,在 TiO2纳米棒/Au@SiO2纳米颗粒结构上进一步生长一层 TiO2钝化层：一方面可增加染料吸附量;另一方面有利于减少电荷复合。基于这种光阳极组装的染料敏化太阳能电池获得了 2.34%的光电转换效率,较单一 TiO2纳米棒光阳极组装的电池效率提高了 60%。     

ZnO单晶声表面波谐振器传播特性的研究

基于有限元压电材料中表面波传播的有限元分析原理,利用有限元分析软件COMSOL对基于ZnO单晶材料的声表面波器件进行多物理域耦合建模与仿真,提取出了符合声表面波振型的对称模态变形图和反对称模态变形图。通过谐振频率分析,计算出了ZnO单晶的相速度和机电耦合系数;通过频率响应分析,得出谐振器输入导纳、阻抗与频率之间的关系图;最后讨论了叉指换能器的结构对谐振频率、反谐振频率的影响,得出输入、输出叉指换能器(IDT)的叉指电极对数越大,插入损耗值越大,信号衰减越小。     

Various shaped-ZnO nanocrystals via low temperature synthetic methods: Surfactant and pH dependence

ZnO nanocrystals, rod-, carnation-, and flower-like structures, have been synthesized in a high yield through low-temperature synthetic methods. Well-aligned ZnO nanorods having hexagonal wurtzite structure were grown on the ZnO thin films assembled by a spin-coating method. The morphologies of ZnO seed films are affected by pHs of sol–gel solutions, resulting smaller sizes and homogeneous roughness at higher pHs and higher number of spin-coating times. The carnation-like structures, average size of about 2–3 μm, were assembled by tens of uniform ZnO nanosheet petals of ∼50 nm in thickness when a different volume ratio of the precursory solution was used. ZnO nanocrystals on the facets of the compact ZnO nanorods have grown to linear nanorods having an average diameter of ∼500 nm and length of ∼2 μm. Furthermore, a noticeable difference in the growth of ZnO nanocrystals in the presence of various surfactants, polyvinylpyrrolidone, polyvinylsulphonic acid, and polyethyleneimine, has been observed and discussed.     

Environmentally Benign and Efficient Ag2S‐ZnO Nanowires as Photoanodes for Solar Cells: Comparison with CdS‐ZnO Nanowires

In this work, we develop a low‐temperature, facile solution reaction route for the fabrication of quantum‐dot‐sensitized solar cells (QDSSCs) containing Ag₂S‐ZnO nanowires (NWs), simultaneously ensuring low manufacturing costs and environmental safety. For comparison, a CdS‐ZnO NW photoanode was also prepared using the layer‐by‐layer growth method. Ultraviolet photoelectron spectroscopy analysis revealed type‐II band alignments for the band structures of both photoanodes which facilitate electron transfer/collection. Compared to CdS‐ZnO QDSSCs, Ag₂S‐ZnO QDSSCs exhibit a considerably higher short‐circuit current density (J_sc) and a strongly enhanced light‐harvesting efficiency, but lower open‐circuit voltages (V_oc), resulting in almost the same power‐conversion efficiency of 1.2 %. Through this work, we demonstrate Ag₂S as an efficient quantum‐dot‐sensitizing material that has the potential to replace Cd‐based sensitizers for eco‐friendly applications.     

Characterizing the Role of Iodine Doping in Improving Photovoltaic Performance of Dye‐Sensitized Hierarchically Structured ZnO Solar Cells

We report two novel types of hierarchically structured iodine‐doped ZnO (I? ZnO)‐based dye‐sensitized solar cells (DSCs) using indoline D205 and the ruthenium complex N719 as sensitizers. It was found that iodine doping boosts the efficiencies of D205 I? ZnO and N719 I? ZnO DSCs with an enhancement of 20.3 and 17.9 %, respectively, compared to the undoped versions. Transient absorption spectra demonstrated that iodine doping impels an increase in the decay time of I? ZnO, favoring enhanced exciton life. Mott–Schottky analysis results indicated a negative shift of the flat‐band potential (V_fb) of ZnO, caused by iodine doping, and this shift correlated with the enhancement of the open circuit voltage (V_oc). To reveal the effect of iodine doping on the effective separation of e^?‐h⁺ pairs which is responsible for cell efficiency, direct visualization of light‐induced changes in the surface potential between I? ZnO particles and dye molecules were traced by Kelvin probe force microscopy. We found that potential changes of iodine‐doped ZnO films by irradiation were above one hundred millivolts and thus significantly greater. In order to correlate enhanced cell performance with iodine doping, electrochemical impedance spectroscopy, incident‐photon‐current efficiency, and cyclic voltammetry investigations on I? ZnO cells were carried out. The results revealed several favorable features of I? ZnO cells, that is, longer electron lifetime, lower charge‐transfer resistance, stronger peak current, and extended visible light harvest, all of which serve to promote cell performance.     

M2+(M=Cu、Cd、Ag、Fe)掺杂氧化锌纳米粉晶的抗菌性能

采用柠檬酸溶胶-凝胶法制备了ZnO及M²⁺掺杂ZnO纳米粉晶(M=Cu、Cd、Ag、Fe),用现代测试技术表征了样品的组成、结构和形貌,以大肠杆菌(Escherichia coli)、金黄色葡萄球菌(Staphylococcus aureus)和白色念珠菌(Candida albicans)为测试菌株,用抑菌圈、最小抑菌浓度和最小杀菌浓度等方法研究了样品在日光照射下的抗菌活性。结果表明,与母体ZnO相比,Cu、Ag、Cd掺杂样品的抗菌性能明显地增强,这可能是由于掺杂金属离子置换Zn²⁺生成了晶格缺陷和电荷缺陷,阻止了光生电子和光生空穴对的复合从而增强了光催化活性和抗菌活性。     

微波诱导燃烧法合成类花状ZnO纳米材料及其晶体结构、荧光性质研究

以硝酸锌[Zn(NO3)2.6H2O]和尿素[CO(NH2)2]作前驱体,通过微波诱导燃烧技术可控合成具有不同形貌的ZnO纳米晶体,并用热重分析和差热分析进行了研究。对各种生长条件:微波功率,辐射时间和尿素/Zn2+物质的量的比对ZnO纳米晶体形貌的影响作了分析。结果表明:尿素/Zn2+物质的量的比对ZnO纳米材料的形貌具有显著影响。X衍射图表明合成的ZnO纳米结构呈六角形。傅里叶变换红外光谱图中400~500 cm-1处明显的峰为Zn-O的振动峰。ZnO纳米结构的发光光谱在366 nm的带边发射,因缺陷又由许多可见光发射峰组成。用扫描电子显微镜、透射电子显微镜、选区电子衍射研究了花状ZnO纳米结构的增长机理。本方法仅需几分钟就获得的了ZnO纳米结构。     

ZnO Nanoparticles as an Efficient,Heterogeneous, Reusable,and Ecofriendly Catalyst for One-Pot,Three-Component Synthesis of 3,4-Dihydropyrimidin-2(1H)-(thio)one Derivatives in Water

An extremely efficient heterogeneous protocol is reported for the one-pot, three-component synthesis of a series of dihydropyrimidinones (DHPMs) in the presence of ZnO nanoparticles in water as a green solvent. The ZnO nanoparticles exhibited excellent catalytic activity and the proposed methodology is capable of providing the desired products in good yields (65–94%) within short reaction times. After the reaction course, ZnO nanoparticles can be recycled and reused without any apparent loss of activity, which makes this ecofriendly process cost-effective.