远红外加热工作波段及辐射源温度的选择

在远红外加热过程中，被加热物料对红外辐射的吸收遵从吸收定律，本文从这一律出发，分布了对于不同的加热对象和加热目的，如何选择最佳工作波段和辐射源浊国度，才能达到节能和加热效果好等目标。     

A NOVEL PASSIVE DUAL ENERGY RECOVERY SNUBBER FOR HIGH POWER GTO CONVERTERS

A novel passive dual energy recovery snubber circuit is presented where energy trapped in the snubber inductor and capacitor is recovered into the both DC rail and load, without any active devices or resistors. The maximum over-shoot voltage on the switch is fixed, peak switch current is low, circuit reset is fast and the operational range of load current is wide. This circuit is suitable for use in high frequency, single ended power gate turn-off (GTO) thyrister choppers. Main design equations, some simulations and practical results are included.     

波长调制吸收光谱技术的燃气轮机燃烧室温度组分二维分布测量方法

可调半导体激光光谱技术（TDLAS）可实现温度、组分浓度等多参数同时测量,具有体积小、响应速度快、环境适应性高等优点,逐渐成为燃烧流场诊断的主要手段之一。TDLAS光谱测量常采用直接吸收技术和波长调制技术,其中强度归一化的波长调制技术,适合存在振动、湍流等致光束偏转效应和强辐射本底等恶劣应用环境条件的燃气轮机流场参数测量。基于TDLAS技术,开展了1f归一化波长调制技术燃气轮机燃烧室温度、组分浓度参数测量方法研究和实验室验证工作,并在某燃气轮机单喷嘴台架进行了冷态、热态试验验证,实现了燃气轮机燃烧室沿气流方向温度及H₂O、CH₄浓度二维分布测量。采用1f归一化波长调制技术抑制台架振动、热辐射背景噪声,采用1 392,1 469和1 343 nm蝶形封装的DFB激光器,三支激光器的出光方式为时分复用,选取H₂O的7 185.6,6 807.83和7 444.3 cm-1处的吸收线,两两组合使用,测量热态下一定范围内的温度和H₂O浓度;采用1 654 nm蝶形封装的DFB激光器,选取CH₄的6 046.96 cm-1处的吸收线进行冷态CH₄浓度测量。实验室对测量系统可靠性进行验证,配置4%~6%范围内的CH₄气体进行测量并与实际值对比,浓度测量最大相对偏差为3.72%;在高温炉中设定900~1 500 K范围内的温度台阶,充入纯水汽,计算不同设定温度和压力下的温度和浓度测量值,温度测量最大相对偏差3.07%,浓度测量最大相对偏差为-2.00%,验证了该测量系统的可靠性。台架燃气轮机实验中,集成了一套小型化测量仪器,设计多束激光收发一体的测量结构。实验采用两个电动位移台,搭载测量结构,每间隔5 mm逐点移动采样,对燃气轮机燃烧室300 mm×60 mm的燃烧区域进行测量,获取了若干工况下冷热态结果。通过双三次插值的方法绘制分辨率为0.5 mm的二维流场分布图,结果分别反映了测量区域范围内CH₄和火焰分布的真实状态。为燃气轮机喷嘴燃料、空气掺混情况和燃烧特性研究提供了新的研究方法和技术手段。     

40≤Z≤44类镍离子3d94s,3d94p,3d94d组态s-p,p-d跃迁的计算

用多组态自洽场方法,结合我们提出的半经验拟合公式,对40≤Z≤44类镍离子3d94s,3d94p,3d94d态的能级进行计算,根据能级拟合值算出s-p,p-d跃迁的谱线波长,并给出各谱线的HFR振子强度.     

Restoration optimization strategy for multifiber optical networks

Resource optimization is a very important issue related with restoration in optical networks. In the proactive restoration, backup lightpaths are established along with the primary light paths. In this paper, we have proposed a strategy for resource optimization, which works with proactive restoration. The performance of the proposed strategy is evaluated by applying on the sample network.     

A concurrent two-layer restoration scheme for GMPLS WDM networks

Next generation backbone networks will likely consist of IP routers as well as optical cross connects (OXCs) and will deploy an optical control plane protocol. Generalized Multi Protocol Label Switching (GMPLS) has been proposed as the candidate of choice for the control plane. Optical fibers may carry large volumes of traffic and therefore adequate mechanisms must exist to enable the network to automatically recover from failures of fiber. In mission critical networks survivability becomes very important. We investigate the problem of autonomous recovery in such networks. The literature contains work in this area that investigates the problem of multilayer recovery. Such recovery had only been sequential in the sense that the published work recovers first in the optical domain, assuming the availability of redundant resources, and then proceeds to recover packet label switched paths. We report a recovery procedure for recovering packet label switch paths (packet LSPs) and lambda label switch paths (λLSP) concurrently. We have conducted an OPNET-based simulation study that compares the performance of the concurrent scheme with the previously published sequential two-layer recovery scheme. The study shows that the concurrent two-layer recovery scheme performs as much as forty-four percent faster than the sequential two-layer recovery scheme.     

光交叉连接节点的功能结构

光交叉连接(OXC)是未来波分复用光传送网实现交换与选路功能的核心部件.目前,OXC节点的物理结构得到深入研究,已经提出了一些采用不同光子器件的OXC实现方案.本文从描述光交叉连接功能的角度出发,给出一种分析OXC节点功能结构的模型,并比较各种OXC方案在功能结构上的差异。     

全光网络探索

全光网络(AON)的出现标志着网络传输技术又向前迈出了重大的一步,它与传统的传输网络相比具有卓越的性能,被称为第三代网络,不久的将来,它将成为电信、Internet等网络的核心,广电网络工作者应对该技术给予必要的关注与了解.     

Broadband arrayed waveguide gratings on InP

Broadband arrayed waveguide gratings on InP are presented using a novel S-shape design. This design was utilized to accommodate the large free spectral range required for broadband operation. Four and eight channel AWGs with a wavelength channel spacing of 18 nm are discussed. The output peaks of the AWGs have a wide FWHM of 11 nm which provides insensitive operation to polarization, temperature fluctuations, and chromatic dispersion.     

不对称半桥变换器的小信号建模与仿真研究

不对称半桥变换器利用自身的寄生器件实现了开关管的零电压操作,在不影响电路整体结构,以及不增加成本的前提下达到了很好的输入、输出特性。文章建立了该类变换器的小信号模型,进行了动态分析、仿真研究及补偿回路设计,并对整体的电路稳定性和几个关键的频率特性进行了研究。