Synthese und spektroskopische Charakterisierung einiger Pentacarbonylwolfram(0)-Komplexe mit verschiedenen 1H-Phosphiren-Liganden,Kristallstrukturen von,und

Synthesis and Spectroscopic Characterization of some Pentacarbonyltungsten(0) Complexes with Various 1H-Phosphirene Ligands: Crystal Structures of , and The tungsten(0) complex 1 reacts upon heating with acetylene derivatives 2a–f in toluene to form benzonitrile and the complexes 4a–f ( 4a : R¹ ? Ph, R² ? H; 4b : R¹ ? Ph, R² ? CH₃; 4c : R¹ ? OEt, R² ? H; 4d : R¹ ? Ph, R² ? CO₂Et; 4e : R¹, R² ? CO₂Me; 4f : R¹, R² ? SiMe₃), which have been isolated by chromatography. Spectroscopic and mass spectrometric data are discussed. The crystal structures of the compounds 4a, b and d were determined by X-ray single crystal structure analysis ( 4a : space group P2₁/n, Z = 4, a = 937,5(2) pm, b = 2202,4(6) pm, c = 1266,3(4) pm, β = 108,94(4)°; 4b : space group P2₁/c, Z = 4, a = 1293,9(2) pm, b = 923,5(1) pm, c = 2223,4(3) pm, β = 92,385(6)°; 4d : space group P2₁/c, Z = 4, a = 955,2(2) pm, b = 3190,9(4) pm, c = 930,7(2) pm, β = 99,64(1)°).     

异相成核和拉伸诱导对生物基PHBV复合纤维结晶结构与力学性能的影响

采用熔融纺丝法制备了聚(3-羟基丁酸酯-co-3-羟基戊酸酯)(PHBV)/二硫化钨(WS_2)复合纤维.利用示差扫描量热仪(DSC)、热台偏光显微镜、二维广角射线衍射仪(2D-WXRD)、纤维强力仪研究了WS_2异相成核作用和牵伸诱导作用对纤维的结晶结构和力学性能的影响.研究表明,WS_2显著提高了PHBV的结晶温度,当使用2 wt%WS_2时,复合材料的结晶温度提高到115~130oC,比纯PHBV(99~105oC)提高了约25oC.WS_2不仅没有影响PHBV球晶的径向生长速率,且明显提高了PHBV/WS_2复合材料的晶核密度,熔体成核活性Φ由1.0降低为0.49.随着牵伸倍率和WS_2用量的增加,纤维的拉伸强度呈现出先增加后减小的趋势.当添加1 wt%WS_2并采用单向牵伸3.8倍时,纤维中的晶体取向产生了β晶结构,使复合纤维的拉伸强度由纯PHBV的37 MPa提高至155 MPa,断裂伸长率由2.4%增加至45%.     

可控表面磷原子修饰提升超细W2C纳米颗粒电解水析氢反应性能

研究高活性和稳定性的非贵金属基析氢催化剂对解决当前能源危机和环境污染问题具有重要意义.碳化钨具有与贵金属Pt类似的d带电子结构,因而成为一类新兴的非贵金属析氢催化剂,受到广泛关注.磷掺杂是提高催化剂析氢活性的有效方法之一,然而目前最常见的构筑磷掺杂方法是使用多金属氧酸盐(POMs,如H3PW12O40),其固定的W/P原子比导致W2C中的掺杂浓度难以调控,并且磷掺杂主要是进入碳载体而不是碳化物本身,从而导致无法明确杂原子对其电催化析氢活性的贡献.本文采用植酸(PA)为磷源设计合成了可控磷掺杂W2C纳米颗粒,并探讨了催化剂组分、杂原子掺杂位置与析氢性能之间的关系.深入研究了磷掺杂碳化钨(WCP)的化学结构和析氢活性.与原始的W2C催化剂相比,WCP具有更高的本征活性、更快的电子转移速率和更多的活性位数量,并且在酸性和碱性条件下均表现出较好的析氢性能.特别是过电位为-200 mV时,WCP催化剂的本征活性在酸性和碱性条件下分别为0.07和0.56 H2 s-1,高出纯W2C(0.01和0.05 H2 S-1)数倍.同时,在电流密度为-10 mA cm-2时,优化后的WCP催化剂在酸性和碱性条件下的析氢过电位分别降低了96和88 mV.XPS及EDS元素分析结果表明,随磷源添加量增加,磷掺杂从碳化钨表面逐渐向内部扩散,进一步说明磷取代位置与析氢活性之间的构效关系,高浓度的表面磷取代可以加速质子捕获过程,从而显著提高其析氢活性,而过量的内部磷取代会破坏W2C结构,降低电子转移速率,从而导致析氢性能下降.利用密度泛函理论计算深入研究了WCP具有较好析氢性能的原因,与内部磷取代相比,表面磷取代会使碳化钨表现出更合适的氢吸附自由能,并且更加有效地降低了氢释放势垒,从而优化了析氢反应动力学.综上,本文为元素掺杂工艺提供了新的思路,同时研究了表面异质原子对析氢活性的关键作用,为该类催化材料的构效关系研究提供了新思路.     

Binary Metal Oxide Adsorbed Graphene Modified Glassy Carbon Electrode for Detection of Riboflavin

Tungsten oxide (W) decorated titanium oxide (T) adsorbed onto a graphene (Gr) and modified the glassy carbon electrode for the electrochemical quantification of riboflavin (RF) in edible food and pharmaceuticals. For comparison, nanocomposites are formed using graphene oxide (GO), reduced graphene oxide (rGO) and pure graphite (G) sheets to study the electrochemical activities towards riboflavin. The ternary WTGr modified GCE shows the highest electrocatalytic activity due to synergetic interactions between the metal oxide and graphene. The electrochemical observations are supported by the SEM, HRTEM, XRD, UV-Vis, Zeta potential (ζ) and size data. The sensor shows a wide linear range 20 nM–2.5 μM with a detection limit 25.24 nM and sensitivity (4.249×10⁻⁸ A/nM). The fabricated sensor is validated in real samples.     

The Remarkably Robust,Photoactive Tungsten Iodide Cluster [W6I12(NCC6H5)2]

The new heteroleptic tungsten iodide cluster compound [W₆I₁₂(NCC₆H₅)₂] is presented. The synthesis is carried-out from Cs₂W₆I₁₄ and ZnI₂ under solvothermal conditions in benzonitrile solution, yielding red cube-shaped crystals. [W₆I₁₂(NCC₆H₅)₂] represents a heteroleptic [W₆I₈]-type cluster bearing four apical iodides and two benzonitrile ligands. Molecular [W₆I₁₂(NCC₆H₅)₂] clusters form a robust hydrogen bridged crystal structure with high thermal stability and high resistibility against hydrolysis. The electronic structure is analyzed by quantum chemical methods of the calculated electron localization function (ELF) and the band structure. Photoluminescence measurements are performed to verify and describe the photophysical properties of [W₆I₁₂(NCC₆H₅)₂]. Finally, the photocatalytic properties of [W₆I₁₂(NCC₆H₅)₂] are evaluated as a proof-of-concept.     

LIGAND EFFECT OF CATALYTIC SYSTEM WCl_6-Et_2Al FOR RING OPENING METATHESIS POLYMERIZATION OF DICYCLOPENTADIENE

INTRODUCTIONInrecentyearsresearchprojectsonROMPofcycloolefinshavebeenattractingattentionofscientistsengagedinthesynthesisanddesignofnewpolyTneric'AprojectsupportedbytheNationalNaturalSCienceFoundationofChina(projectapprovalnumber:29474160).'-Correspondingauthormaterials,amongthemROMPsofnorbornene,norbornenederivativesandDCPDhavefoundgrowingfavourinthechemists,.y.,LI--4].Acrosslinkedpolarer(PDCPD),anewplastic,possessingexcellentmechanicalproperties(highNIS,TSetc)a-ndgoodthermal…     

石墨烯-氧化钨复合薄膜的制备及界面电子传输特性

以偏钨酸铵为钨源、聚乙烯吡咯烷酮为连接剂,采用浸渍提拉法制备了石墨烯-氧化钨复合薄膜,利用X射线衍射（XRD）、扫描电镜（SEM）、透射电镜（TEM）及Raman光谱等方法对复合结构材料进行了表征,并利用光电流测试、交流阻抗谱（EIS）、瞬态光电流谱和强度调制光电流谱等方法,研究复合薄膜电极在光电作用下界面上的载流子转移过程和电荷传输行为. 结果表明,组成薄膜的氧化钨纳米颗粒与石墨烯充分复合,光电性能显著提高;与石墨烯复合后,薄膜的瞬态时间常数增大,电子-空穴对寿命延长;电子传输时间减少,为纯氧化钨薄膜的47.5%.     

侵彻环境下两种钨合金的细观响应特性

本文实验发现具有较大密度和较高速度的93W钨合金长杆模拟弹的穿靶深度反而比密度较小，速度较低的90W钨合金长杆弹的穿靶深度小．针对这一现象，本文从两种材料在侵彻环境下的细观响应特性的差异上给出了有实验根据的合理分析，结论是90W在侵彻环境下较易于形成绝热剪切带，从而在弹头部发生“自锐化”效应所致．     

一种钨合金含损伤本构的唯象模型

利用多压阻传感器拉氏实验分析方法对受冲击90w钨合金材料中形成的应力波场进行了测试，并利用拉格朗日分析方法获得的结果建立了合金的不含损伤的本构关系．然后以动态层裂试验获得的层裂参数曲线和数据为依据．提出了一种考虑材料内部损伤成核，成长及汇合效应的唯象本构模型，并通过对层裂实验曲线进行数值模拟，确定了该合金的含损伤本构的参数．     

钨合金的冲击动力学性质及细微观结构的影响

简单介绍了钨合金(主要为W-Ni-Fe)的制备工艺和常用热处理方法,其后着重从动 态力学性能、剪切带的实验观察和研究、细微观结构对材料力学性能的影响等几方 面总结和评述了近年来针对钨合金取得的主要结果.并在文章的最后初步提出了有 前景的几个研究方向.