The molecular and crystal structures of two diastereomeric 3,4-dihydropyrromethenones

The molecular and crystal structures of the two racemic diastereomeric 3,4-dihydropyrromethenone derivatives1 and2 of configurations (Z) and (E) were determined at 93 K (1, 2) and at room temperature (1). From an analysis of the crystallographically observed temperature coefficients a pseudorotation flexibility of the pyrrolidinone ring in the crystal is deduced. In both compounds a nearly orthogonal arrangement between the two heterocyclic ring systems is observed, which is ascribed to the steric bulk of the substituents in positions 1 and 3 of the pyrrolidinone ring.Herrn Prof.Josef Schurz zum 60. Geburtstag gewidmet.     

Behavior of fused silica capillaries subjected to gamma radiation. Part 1: Chromatographic performance

Fused silica capillaries deactivated with D₄ and coated with OV-1 were subjected to cobalt-60 gamma radiation in order to elucidate the effect of incident radiation on column performance. The chromatographic performance of these open tubular columns in which OV-1 was polymerized in situ was found to be dependent on the dosage of radiation and was evaluated before and after the irradiated columns were rinsed with solvent. Of the radiation dosages employed, 3 MRad produced superior chromatographic performance coupled with very favorable residual surface activity.     

MoO3—SiO2表面复合物金属催化剂载体的制备与表征

采用ＭｏＯＣｌ４的盐酸溶液负载于ＳｉＯ２的表面反应法，制备了负载型和键联型两种ＭｏＯ３－ＳｉＯ２（ＭｏＳＯ）表面复合物载体。利用红外光谱法研究了ＭｏＳＯ的表面构造及其化学吸附性能；并利用ＴＰＲ技术考察了该表面复合物载体对负载金属Ｐｄ，Ｃｕ氧化物还原过程的影响。     

迎头色谱程序升温脱附快速测定吸附热新方法

在Ｐｏｌａｎｙｉ吸附势理论基础上，结合程序升温脱附曲线的测定，建立了一个快速测定吸附热的新方法，详细讨论了该方法的原理，通过微机采样和数据处理，测定一条吸附热与覆盖度的曲线仅需１ｈ左右。     

碳纤维微电极研究(Ⅺ)——利用温度效应测定电极反应的热力学和动力学参数

研究了温度对碳纤维微电极上伏安曲线的影响及温度与电极电位的关系,测定了电极反应的热力学参数.由电流与温度的关系测定了去极剂的扩散活化能E_(al)和D_o,利用微电极具有高速传质的特性,测定了常规电极上为可逆反应的电极反应标准速率常数(?),并通过(?)与温度的关系测定了电极反应的活化能.     

Temperature selectivity effects in reversed-phase liquid chromatography due to conformation differences between helical and non-helical peptides

In order to characterize the effect of temperature on the retention behaviour and selectivity of separation of polypeptides and proteins in reversed-phase high-performance liquid chromatography (RP-HPLC), the chromatographic properties of four series of peptides, with different peptide conformations, have been studied as a function of temperature (5-80 degrees C). The secondary structure of model peptides was based on either the amphipathic alpha-helical peptide sequence Ac-EAEKAAKEX(D/L)EKAAKEAEK-amide, (position X being in the centre of the hydrophobic face of the alpha-helix), or the random coil peptide sequence Ac-X(D/L)LGAKGAGVG-amide, where position X is substituted by the 19 L- or D-amino acids and glycine. We have shown that the helical peptide analogues exhibited a greater effect of varying temperature on elution behaviour compared to the random coil peptide analogues, due to the unfolding of alpha-helical structure with the increase of temperature during RP-HPLC. In addition, temperature generally produced different effects on the separations of peptides with different L- or D-amino acid substitutions within the groups of helical or non-helical peptides. The results demonstrate that variations in temperature can be used to effect significant changes in selectivity among the peptide analogues despite their very high degree of sequence homology. Our results also suggest that a temperature-based approach to RP-HPLC can be used to distinguish varying amino acid substitutions at the same site of the peptide sequence. We believe that the peptide mixtures presented here provide a good model for studying temperature effects on selectivity due to conformational differences of peptides, both for the rational development of peptide separation optimization protocols and a probe to distinguish between peptide conformations.     

The effect of calcination conditions on the superconducting properties of Y−Ba−Cu−O powders

Calcination conditions of the precursor powders, i.e. temperature, type of atmosphere and duration, were determined with a view to obtain superconducting powders with the most advantageous physico-chemical properties. Investigated were powders in the Y?Ba?Cu?O system prepared by the sol-gel method. Thermogravimetric examinations of the powders have revealed that the decomposition kinetics of BaCO₃ determines the formation rate of the superconducting YBa₂Cu₃O_7?x (‘123’) phase. It follows from the decomposition kinetics of BaCO₃ that the process is the most intensive in argon, whereas in static air and oxygen it is the slowest. The phase composition analysis (XRD) and low-temperature magnetic susceptibility measurements of the calcinated powders, confirm the above mentioned changes in the decomposition kinetics. The reaction of barium carbonate can be completed if the calcination process is conducted at the temperature of 850°C for 25 h, yielding easily sinterable powders for obtaining single-phase superconducting bulk samples with advantageous functional parameters.     

Influence of the heating rate on the temperature profiles and on the conversion rate of powdery cellulose and pine sawdust

An experimental study of the thermal decomposition of powdered cellulose and pine sawdust has been performed. The influence of the heating rate on the temperature profiles in the sample and on the solid conversion rate has been studied. A mathematical model without adjustable parameters has been used to calculate the temperature at different points in the solid bed and the average total solid conversion. The experimental results have been compared with those calculated by the model. A good agreement has been obtained for sawdust. Some differences are observed for cellulose at high heating rates, and the influence of the thermal conductivity and the reaction heat on the results has been analysed.     

Phase separation and structural properties of semidilute aqueous mixtures of ethyl(hydroxyethyl)cellulose and an ionic surfactant

Turbidity and small-angle neutron scattering (SANS) measurements have been carried out over an extended temperature range (10-60 °C) on thermoreversible gelling and non-gelling semidilute aqueous systems of ethyl(hydroxyethyl)cellulose (EHEC) in the presence of various amounts of sodium dodecyl sulfate (SDS). EHEC dissolved in D₂O exhibits a lower consolute solution temperature with an abrupt change of the turbidity upon heating the sample. The turbidity transformation is shifted toward higher temperatures (the cloud point temperature rises) and it becomes gradually gentler as the level of surfactant addition increases. Precision turbidity measurements demonstrate the existence of hysteresis effects when heating and cooling scans are conducted. This effect is reduced with SDS addition and disappears at a sufficiently high SDS concentration where most aggregates are disrupted. It is shown from temperature quench turbidity experiments that it takes a very long time for the temperature-induced complexes to disintegrate. The scattered intensity results from SANS at low values of the scattering vector (q) disclose that elevated temperature and low SDS concentration promote the formation of large-scale associations, and at higher levels of surfactant addition the tendency to form aggregates is suppressed. At high surfactant concentrations (8 and 16 mm), an interaction peak appears in the spectrum at intermediate values of q. For the EHEC sample with 8 mm SDS, the peak disappears at higher temperatures because of enhanced hydrophobicity of the polymer. The analysis of the SANS data for the gelling sample (EHEC with 4 mm SDS) reveals that the inhomogeneity of the gel becomes more pronounced in the post-gel region.     

Radiation polymerization of thermo-sensitive poly (N-vinylcaprolactam)

Temperature-sensitive poly (N-vinylcaprolactam) both in water-soluble state and in gel was prepared by γ-radiation polymerization. The effects of radiation dose, radiation dose rate and monomer concentration on polymerization and the low critical solution temperature characteristics of the polymer were studied. The results show that the polymer prepared within certain radiation dose (beyond 2 kGy) and dose rate range (2–14 Gy/min) has good temperature sensitivity and uniformity.