短周期超晶格AlP／GaP能带结构的转变及其带间的光跃迁

介绍了间接跃迁的半导体ＡｌＰ与ＧａＰ形成的超晶格，由于零折叠效应，实现了能带由间接带隙向直接带隙的转变，从而增加了带间的光跃迁几率，并推导了该几率的表达式。     

集成光学干涉仪光纤陀螺

简述了集成光学干涉仪光纤陀螺（ＦＯＧ）的技术优势、发展概况和采用的技术途径，介绍了适用于不同技术条件要求的三种多功能集成光学芯片结构和相应的信息处理方法。简要地概括了目前国外ＦＯＧ的发展水平。     

锥形有源条半导体光放大器增益和饱和特性分析

以行波半导体光放大器速度方程为基础，采用传输矩阵方法，对锥形结构半导体光放大器的增益和饱和特性进行理论研究。讨论了不同锥形长度，不同结构时的增益和饱和特性差异。理论研究表明，锥形结构能改善半导体光放大器的偏振灵敏度。在同一锥度下，长锥形长度能提高饱和增益，降低偏振度。在进行半导体光放大器有源条结构设计时要综合考虑锥度及锥形长度的影响，以实现结构优化 。     

单片InGaAs／InP PIN PD阵列

文章简要地介绍了ＩｎＧａＡｓ／ＩｎＰ ＰＩＮ ＰＤ阵列的制作现状及其应用和发展趋势。     

河南省城市居民消费结构比较研究

本文主要应用聚类分析方法 ,对河南省 17个地市级城市居民的消费结构进行了比较统计分析 ,从而得到了各城市居民消费结构的一些特点和规律 ,并进一步探讨了其消费结构、可支配收入与总消费支出之间的关系     

Structure and mechanical properties of Al/AlN multilayer with different AlN layer thickness

Nanometer scale Al/AlN multilayers have been prepared by dc magnetron sputtering technique with a columnar target. A set of Al/AlN multilayers with the Al layer thickness of 2.9 nm and the AlN layer thickness variation from 1.13 to 6.81 nm were determined. Low angle X-ray diffraction (LAXRD) was used to analyze the layered structure of multilayers. The phase structure of the coatings was investigated with grazing angle XRD (GAXRD). Mechanical properties of these multilayers were thoroughly studied using a nanoindentation and ball-on-disk micro-tribometer. It was found that the multilayer hardness and reduced modulus showed no strong dependence on the AlN layer thickness. Al2.9 nm/AlN1.13 nm multilayer had more excellent tribological properties than single layers and other proportion multilayers with a lowest friction coefficient of 0.15. And the tribological properties of all the multilayers are superior to the AlN single layer.     

Preparation and characterization of ZnO nanorods from NaOH solutions with assisted electrical field

ZnO naorods on ZnO-coated seed substrates were fabricated by solution chemical method from Zn(NO₃)₂/NaOH under assisted electrical field. The working mechanism of electrical field was analyzed and the factors affecting the rod growth such as potential, precursor concentration and growth temperature were elucidated. The structural and optical properties are characterized by SEM, TEM, XRD, HRTEM and UV-vis. The results indicated that the nanorods have wurtzite structure without electrical field and are primarily of zincite structure under electrical field; when the electrical field is 1.1-1.3 V, not only the elevation of ion diffusion and adsorption lower the crystallite/solution interfacial energy and then the crystal nucleation barrier by increasing charge intensity, but also the production of H⁺ through oxidation of OH⁻ increases properly the degree of solution supersaturation near the substrate, and thus lowers the activation energy. Both the two processes do favor to rod growth. With increasing precursor concentration in this system, the average diameter and length of ZnO nanorods increase, leading to decreasing of optical transmittance. The maximum rod growth rate at given concentration of Zn²⁺ occurs at a specific temperature.     

Multiporous hollow polymer particles

Hollow particles with interconnected cavities have been prepared by a simple modified suspension polymerization of acrylate monomers in the incorporation of a phase inversion process and polymerizable emulsifier. The morphology of particles has been characterized by scanning electron micrographs (SEMs). Based on observations made using an optical microscope equipped with a digital camera and SEM images of particles obtained under different conditions, the formation mechanisms for multiporous hollow particles are discussed.     

The properties and structures of the mono- and the di- vacancy in Cu crystal

The structures and energies of formation and migration of the mono- and di-vacancy in Cu crystal have been described and calculated with modified analytical embedded atom method (MAEAM). The lattice relaxation is considered with molecular dynamics (MD) method at T=0 K. The results show the FN di-vacancy is the most stable and likely occurs in practice from the energy minimization. Compared with the mono-vacancy, the formation energy of the FN di-vacancy is higher than that of a mono-vacancy, but lower than that of two isolated mono-vacancy. The preferred migration mechanism of the FN di-vacancy is multi-jump of either vacancy (rotating the di-vacancy). The calculated migration energy of the FN di-vacancy is lower than that of a mono-vacancy, so the FN di-vacancy is easier to migrate. All of the calculated results are in good agreement with the experimental values.     

Influence of buffer layer thickness on the structure and optical properties of ZnO thin films

A series of ZnO thin films were deposited on ZnO buffer layers by DC reactive magnetron sputtering. The buffer layer thickness determination of microstructure and optical properties of ZnO films was investigated by X-ray diffraction (XRD), photoluminescence (PL), optical transmittance and absorption measurements. XRD results revealed that the stress of ZnO thin films varied with the buffer layer thickness. With the increase of buffer layer thickness, the band gap edge shifted toward longer wavelength. The near-band-edge (NBE) emission intensity of ZnO films deposited on ZnO buffer layer also varied with the increase of thickness due to the spatial confinement increasing the Coulomb interaction between electrons and holes. The PL measurement showed that the optimum thickness of the ZnO buffer layer was around 12 nm.