Role of micro-crystalline parameters in the physical properties of cotton fibers

Karnataka state in India is very well known for its cotton cultivation and there are innumerable varieties of these cotton fibers. Although, the yield and other types of characterization have been carried out on these fibers, the structure-property relation is not well studied till today. We have examined four different raw cotton fibers using Wide Angle X-ray Scattering (WAXS) technique and also we have computed micro-crystalline parameters. This study brings out the structure-property relation in cotton fibers.     

基于简化的应变梯度理论下Kirchhoff板模型边值问题的提法及其应用北大核心CSCD

考虑应变梯度和速度梯度的影响,建立薄板控制微分方程及给出其边值问题的提法,修正了前人给出的薄板角点条件.采用Levy法,给出受分布力作用下简支板的挠度及自由振动频率的解析解.通过与文献中分子动力学数据对比,验证了该文模型的有效性并提出校核材料参数的一种方法.研究结果表明,增大弹性地基和应变梯度参数可以有效提高板的等效刚度,而速度梯度参数则相反.该文提出的板的边值问题为研究薄板在复杂支撑边界及外荷载等条件提供了理论依据.同时,有望为其有限元法、有限差分法和基于能量原理的Galerkin法等数值方法提供理论依据.     

聚对苯二甲酸乙二酯非晶态膜片单轴热——拉伸中的结晶与松弛

用动态力学损耗温度谱作为测试手段,研究了非晶态PET膜片在78—112℃温度范围内的单轴拉伸。实验结果说明,在较低温度下所得结晶的拉伸试样,完全由于应变诱发结晶,发生在应力-应变曲线的屈服后应力开始上升的阶段。在较高温度下(90℃或更高)拉伸可得非晶态而且光学各向同性的试样,是由于分子链的小尺度取向在拉伸过程中已完全热松弛所致,而分子链的大尺度取向要通过高弹态流动而松弛,其速率较慢,用拉伸后试样两端固定时的应力松弛进行了观察。在较低温度下应力松弛后仍为非晶态,在较高温度下应力松弛到起始应力的1O％下才开始结晶。FTIR研究表明在这种状态下的结晶有一结晶诱导期,其时间尺度与应力松弛阶段相当。     

Influence of operational parameters on retention of ultra-high molecular weight polystyrenes in thermal field-flow fractionation

Summary The influence of various parameters (concentration of the injected polymer solution, flow rate, temperature gradient, relaxation conditions) on the retention and shape of the fractogram of ultra-high molecular weight polystyrenes in thermal field-flow fractionation was investigated. Under the operating conditions adopted, reproducible oscillations in the peak shape are observed for molecular weights larger than a few millions, especially at relatively high polymer concentration. They are attributed to some hydrodynamic instabilities. The retention of ultra-high molecular weight polystyrenes at high flow rate is strongly dependent on the initial relaxation period. All of the investigated operational variables have a complex effect on the resulting shape of the fractogram. Consequently, the confirmation of the shear-induced focusing of macromolecules across the channel thickness requires further study. Experiments on reinjection of fractions collected after an initial high speed pass through the separation system leads to the conclusion that shear degradation of the ultra-high molecular weight polymers did not occur under the investigated experimental conditions even at the highest flow rates.     

ANISOTROPIC STRAIN EFFECT ON MORPHOLOGY AND ATOMIC STRUCTURE OF VICINAL Si(001) SURFACE

On vicinal Si(001) surfaces, dependence of growth morphology on the applied strain direction and formation of vacancy lines from Ag-induced missing dimer vacancies are studied. Both phenomena are intimately related to the anisotropic nature of the strain field which originates from the surface dimerization. Strain relief mechanism, reflecting on the surface morphology, is shown to be different in two orthogonal directions. Normal to the steps, step-pair bunching and waving lead to formation of hillocks and pits. Along the step direction, bending of step pairs forms a cusp which later develops into a deep groove. Toward the atomic scale, the formation of the vacancy lines is driven by the short-range attractive interaction between the vacancies in adjacent dimer rows and the long-range repulsive interaction between them in the same dimer row. A full form and magnitudes of the interactions are derived from the thermally-excited wandering of the vacancy lines formed by a nominal amount of Ag depositing onto the surface.     

SHAPE MEMORY EFFECT OF PU IONOMERS WITH IONIC GROUPS ON HARD-SEGMENTS

SMPU （shape memory polyurethane） non-ionomers and ionomers, synthesized with poly（c-caprolactone） （PCL）, 4, 4＇-diphenylmethane diisocyanate （MDI）, 1,4-butanediol （BDO）, dimethylolpropionic acid （DMPA） were measured with cyclic tensile test and strain recovery test. The relations between the structure and shape memory effect of these two series were studied with respect to the ionic group content and the effect of neutralization. The resulting data indicate that, with the introduction of asymmetrical extender, the stress at 100% elongation is decreased for PU non-ionomer and ionomer series, especially lowered sharply for non-ionomer series; the fixation ratio of ionomer series is not affected obviously by the ionic group content; the total recovery ratio of ionomer series is decreased greatly. After sufficient relaxation time for samples stretched beforehand, the switching temperature is raised slightly, whereas the recovery ratio measured with strain recovery test method is lowered with increased DMPA content. The characterization with FT-IR, DSC, DMA elucidated that, the ordered hard domain of the two series is disrupted with the introduction of DMPA which causes more hard segments to dissolve in soft phase; ionic groups on hard segment enhance the cohesion between hard segments especially at high ionic group content and significantly facilitate the phase separation compared with the corresponding non-ionomer at moderate ionic group content.     

Transient rheological behavior of lyotropic (acetyl)(ethyl)cellulose/m-cresol solutions

The chiroptical properties and transient rheological behavior of (acetyl)(ethyl)cellulose (AEC) m-cresol liquid crystalline solutions have been investigated. Chiroptical properties were manipulated through (i) increasing degree of acetylation of ethyl cellulose (EC), and (ii) blending AEC with EC. At the same average degree of acetylation (DA), the chiroptical properties of pure AEC were different from those of the EC/AEC mixtures. However, at the same DA, the AEC and mixed AEC/EC solutions showed similar steady state flow and oscillatory behaviors, but the transient behaviors were different. At high flow rates the mixed AEC/EC solutions exhibited double recoil after cessation of steady-state flow, whereas the AEC solutions showed double recoil only in the high DA AEC solutions. All solutions, pure and mixed, had the same stress relaxation behavior. Both pitch and handedness affected the transient behavior. After cessation of high shear rate flow, the rate of modulus evolution decreased with increasing pitch, and was faster in right-handed mesophases than in left-handed ones at a similar pitch.     

Effect of disorder on relaxation in the one-dimensional Glauber model

We study the long-time relaxation of magnetization in a disordered linear chain of Ising spins from an initially aligned state. The coupling constants are ferromagnetic and nearest-neighbor only, taking valuesJ ₀ andJ ₁ with probabilitiesp and 1–p, respectively. The time evolution of the system is governed by the Glauber master equation. It is shown that for large timest, the magnetizationM(t) varies as [exp(–₀ t](t), where ₀ is a function of the stronger bond strengthJ ₀ only, and (t) decreases slower than an exponential. For very long times, we find that ln (t) varies as –t ^1/3. For low enough temperatures, there is an intermediate time regime when ln (t) varies as –t ^1/2. The results can be extended to more general probability distributions of ferromagnetic coupling constants, assuming thatM(t) can only increase if any bond in the chain is strengthened. If the coupling constants have a continuous distribution in which the probability density varies as a power law near some maximum valueJ ₀, we find that ln (t) varies as –t ^1/3(lnt)^2/3 for large times.     

单向应力条件下松弛时间率相关的非线性粘弹性本构模型

基于单向拉伸实验研究和内变量理论 ,提出了一种新的简单的一维非线性粘弹性本构关系 .对两种粘弹性材料 ,即高密度聚乙烯和聚丙烯进行了不同加载速率作用下的拉伸实验研究 ,实验结果表明 ,两种材料的应力应变关系与加载速率相关 ;对材料的应力应变实验数据进行拟合发现 ,材料的松弛时间具有很强的应变率相关性 ,当应变率发生数量级变化时 ,材料的松弛时间也发生数量级的变化 .采用内变量理论 ,导出了在单轴应力条件下松弛时间率相关的非线性粘弹性本构关系的迭代形式 ,并给出其收敛条件 .当采取一次迭代形式时 ,本构关系退化为松弛时间率相关的Maxwell模型 .数值拟合的结果表明 ,一次迭代形式的本构关系就可以很好地拟合和预测实验结果 .     

Temperature Dependent Dielectric Relaxation in Solvent Mixtures at Microwave Frequencies

By the use of time domain reflectometry method, dielectric measurements were carried out on dimethylformamide‐2‐nitrotoluene solvent mixtures in the frequency range 10 MHz‐20 GHz, at various temperatures from 15 °C to 45 °C. These solvent mixtures as well as pure solvents display a Debye type dispersion. Their frequency dependent dielectric properties can be summarized by the three parameters in the Debye equation: a static permittivity, permittivity at high frequency and a dielectric relaxation time constant. The free energy of activation for dipolar relaxation process and the Kirkwood correlation factor were determined using these fitting parameters for these solvent mixtures at various concentrations and temperatures. By using these dielectric parameters, the excess permittivity and excess inverse relaxation time is obtained. The excess permittivity is found to be positive for all concentrations and temperatures whereas the excess inverse relaxation time is negative.