Spectral estimates for saddle point matrices arising in weak constraint four‐dimensional variational data assimilation

We consider the large sparse symmetric linear systems of equations that arise in the solution of weak constraint four‐dimensional variational data assimilation, a method of high interest for numerical weather prediction. These systems can be written as saddle point systems with a 3 × 3 block structure but block eliminations can be performed to reduce them to saddle point systems with a 2 × 2 block structure, or further to symmetric positive definite systems. In this article, we analyse how sensitive the spectra of these matrices are to the number of observations of the underlying dynamical system. We also obtain bounds on the eigenvalues of the matrices. Numerical experiments are used to confirm the theoretical analysis and bounds.     

基于深度学习的ELM实时识别研究

基于深度学习的方法，在HL-2A装置上开发出了一套边缘局域模(ELM)实时识别算法。算法使用5200次放电数据(约24.19万数据切片)进行学习，得到一个深度为22层的卷积神经网络。为衡量算法的识别能力，识别了HL-2A装置自2009年实现稳定ELMy H模放电以来所有历史数据(约26000次放电数据)，共识别出1665次H模放电，其中误识别35次，误报率为2.10%。在实际的1634次H模放电中，漏识别4次，漏识别率为0.24%。该误报率和漏报率可以满足ELM实时识别的精度要求。识别算法在实时控制环境下，对单个时间点的平均计算时间为0.46ms，可以满足实时控制的计算速度要求。     

Highly Luminescent Red Phosphorescent OLED with Interfacial Layers for Hole Transport and Electron Injection

Four kinds of red phosphorescent organic light-emitting devices were fabricated and compared to investigate the effect of interfacial layers for hole transport and electron injection. 1 nm-thick LiF in the device A and C and 1 nm-thick Cs₂CO₃ in the device B and D were deposited as an electron injection layer between the anode and the electron transport layer, and 5 nm-thick layer of dipyrazion[2,3-f:2′,2′-h]quinoxaline-2,3,6,7,10,11-hexacarbonitrile[HATCN] was inserted as a hole transport interfacial layer between the hole injection layer and the hole transport layer only in the device C and D. Under a luminance of 1000 cd/m², the power efficiencies were 7.6 lm/W and 8.5 lm/W in the device A and B, and 8.6 lm/W and 13.4 lm/W in the device C and D. The quantum efficiency of the device D was 15.8% under 1000 cd/m² which was somewhat lower than those of the device A and C, but a little higher than that of the device B. The luminance of the device D was much higher than those of the other devices at a given votage. The luminance of the device D at 7 V was 23,710 cd/m², which was 13.0, 3.4, and 4.0 times higher than those of the device A, B, and C at the same voltage, respectively.     

Simultaneous determination of major components of Huangqi–Honghua extract in rat plasma using LC–MS/MS and application to a pharmacokinetic study

A sensitive and reliable LC–MS/MS method was developed and validated for simultaneous quantification of the major components of Huangqi–Honghua extact in rat plasma, including hydroxysafflor yellow A (HSYA), astragaloside IV (ASIV), calycosin‐7‐O‐β‐d ‐glucoside (CAG), calycosin, calycosin‐3′‐O‐glucuronide (C‐3′‐G) and calycosin‐3′‐O‐sulfate (C‐3′‐S). After extraction by protein precipitation with acetonitrile and methanol from plasma, the analytes were separated on a Hypersil BDS C₁₈ column by gradient elution with acetonitrile and 5 mM ammonium acetate. The detection was carried out on a triple quadrupole tandem mass spectrometer equipped with electrospray ionization source switched between negative and positive modes. HSYA was monitored in negative ionization mode from 0 to 4.9 min, and ASIV, CAG, calycosin, C‐3′‐G and C‐3′‐S were determined in positive ionization mode from 4.9 to 10 min. The lower limits of quantification of the analytes were 6.25 ng/mL for HSYA, 0.781 ng/mL for CAG and 1.56 ng/mL for ASIV and calycosin. The intra‐ and inter‐assay precision (RSD) values were within 13.43%, and accuracy (RE) ranged from ?8.75 to 9.92%. The validated method was then applied to the pharmacokinetic study of HSYA, ASIV, CAG, calycosin, C‐3′‐G and C‐3′‐S in rat after an oral administration of Huangqi–Honghua extract.     

Cycloparaphenylene (CPP) series are molecular models for graphene armchair edges: trends in their aromaticity and cyclic conjugation are evaluated

Cycloparaphenylene ([r]CPP) and cyclacene ([r]CA) series are models for short carbon nanotubes. It is shown that armchair edges in model cycloparaphenylenes possess greater aromaticity and cyclic conjugation than do zigzag edges in model cyclacenes. According to Aihara’s bond resonance energy (BRE) and Bosanac and Gutman energy effect (ef) measurements, cycloparaphenylenes are twice as aromatic as cyclacenes. The general solution of all eigenvalues of all members of the cycloparaphenylene series is given. The origin of the recurrence of some eigenvalues are determined.     

Gas-phase 21Ne NMR studies and the nuclear magnetic dipole moment of neon-21

Gas-phase ²¹Ne nuclear magnetic resonance spectra were measured at the natural abundance of ²¹Ne isotope for samples consisting of pressurized neon up to 60 bar at room temperature and applying the magnetic field of the strength B₀ = 11.7574 T. It showed that the nuclear magnetic resonance frequency is linearly dependent on the density of gaseous neon. The resonance frequency was extrapolated to the zero-density point, and it permitted the determination of the ²¹Ne nuclear magnetic moment, μ(²¹Ne) = 0.6617774(10) μ_N. The present value of μ(²¹Ne) is not influenced by the bulk magnetic susceptibility of neon and interactions between neon atoms; therefore, it is more precise and reliable than the previous result obtained for μ(²¹Ne).     

Rational Molecular Design towards Vis/NIR Absorption and Fluorescence by using Pyrrolopyrrole aza‐BODIPY and its Highly Conjugated Structures for Organic Photovoltaics

Pyrrolopyrrole aza‐BODIPY (PPAB) developed in our recent study from diketopyrrolopyrrole by titanium tetrachloride‐mediated Schiff‐base formation reaction with heteroaromatic amines is a highly potential chromophore due to its intense absorption and fluorescence in the visible region and high fluorescence quantum yield, which is greater than 0.8. To control the absorption and fluorescence of PPAB, particularly in the near‐infrared (NIR) region, further molecular design was performed using DFT calculations. This results in the postulation that the HOMO–LUMO gap of PPAB is perturbed by the heteroaromatic moieties and the aryl‐substituents. Based on this molecular design, a series of new PPAB molecules was synthesized, in which the largest redshifts of the absorption and fluorescence maxima up to 803 and 850 nm, respectively, were achieved for a PPAB consisting of benzothiazole rings and terthienyl substituents. In contrast to the sharp absorption of PPAB, a PPAB dimer, which was prepared by a cross‐coupling reaction of PPAB monomers, exhibited panchromatic absorption across the UV/Vis/NIR regions. With this series of PPAB chromophores in hand, a potential application of PPAB as an optoelectronic material was investigated. After identifying a suitable PPAB molecule for application in organic photovoltaic cells based on evaluation using time‐resolved microwave conductivity measurements, a maximized power conversion efficiency of 1.27 % was achieved.     

Single-Crystalline TiO2(B) Nanobelts with Unusual Large Exposed {100} Facets and Enhanced Li-Storage Capacity

The {100} facet of single-crystalline TiO₂(B) is an ideal platform for inserting Li ions, but it is hard to be obtained due to its high surface energy. Here, the single-crystalline TiO₂(B) nanobelts from H₂Ti₃O₇ with nearly 70% {100} facets exposed are synthesized, which significantly enhances Li-storage capacity. The first-principle calculations demonstrate an ab in-plane 2D diffusion through the exposed {100} facets. As a consequence, the nanobelts can significantly accommodate Li ions in LiTiO₂ formula with specific capacity up to 335 mAh g⁻¹, which is in good agreement with the electrochemical characterizations. Coating with conductive and protective poly(3,4-ethylenedioxythiophene)-poly(styrenesulfonate), the cut-off discharge voltage is as low as 0.5 V, leading to a capacity of 160.7 mAh g⁻¹ after 1500 cycles with a retention rate of 66% at 1C. This work provides a practical strategy to increase the Li-ion capacity and cycle stability by tailoring the crystal orientation and nanostructures.     

Assessing the nucleophilic character of 2-amino-4-arylthiazoles through coupling with 4,6-dinitrobenzofuroxan: Experimental and theoretical approaches based on structure-reactivity relationships

A kinetic study of the reactions of potentially bioactive 2-amino-4-arylthiazoles with highly reactive 4,6-dinitrobenzofuroxan (DNBF) is reported herein in acetonitrile solution. The complexation reaction was followed by recording the UV–vis spectra with time at λ_max = 482 nm. Electronic effects of substituents influencing the rate of reaction have been studied using structure-reactivity relationships. It is shown that the Hammett plot relative to the reaction of DNBF with 2-amino-4-(4-chlorophenyl)thiazole exhibit positive deviation from the log k₁ versus σ correlation, while it showed excellent linear correlation in terms of Yukawa–Tsuno equation. It has be noticed that the nonlinear Hammett plot observed for 2-amino-4-(4-chlorophenyl) thiazole is not attributed to a change in rate-determining step but is due to nature of electronic effect of substituent caused by the resonance of stabilization of substrates. The second-order rate constant (k₁) relating to the bond C–C and C-N forming step of the complexation processes of DNBF with 4-substituted-aminothiazoles and 2-amino-5-methyl-4-phenylthiazole, respectively, is fit into the linear relationship log k = s_N (N + E), thereby permitting the assessment of the nucleophilicity parameter (N) of the 2-amino-4-arylthiazoles of the range (4.90 < N < 6.85). 2-amino-4-arylthiazoles is subsequently ranked by positioning its reactivity on the general nucleophilicity scale developed recently by Mayr and coworkers (2003) leading an interesting and a direct comparison over a large domain of π-, σ -, and n-nucleophiles. The global electrophilicity/nucleophilicity reactivity indexes of the 2-amino-4-arylthiazoles have been investigated by means of a density functional theory (DFT) method. .     

On‐the‐Spot Immobilization of Quantum Dots,Graphene Oxide,and Proteins via Hydrophobins

Class I hydrophobin Vmh2, a peculiar surface active and versatile fungal protein, is known to self‐assemble into chemically stable amphiphilic films, to be able to change wettability of surfaces, and to strongly adsorb other proteins. Herein, a fast, highly homogeneous and efficient glass functionalization by spontaneous self‐assembling of Vmh2 at liquid–solid interfaces is achieved (in 2 min). The Vmh2‐coated glass slides are proven to immobilize not only proteins but also nanomaterials such as graphene oxide (GO) and quantum dots (QDs). As models, bovine serum albumin labeled with Alexa 555 fluorophore, anti‐immunoglobulin G antibodies, and cadmium telluride QDs are patterned in a microarray fashion in order to demonstrate functionality, reproducibility, and versatility of the proposed substrate. Additionally, a GO layer is effectively and homogeneously self‐assembled onto the studied functionalized surface. This approach offers a quick and simple alternative to immobilize nanomaterials and proteins, which is appealing for new bioanalytical and nanobioenabled applications.