Time jitter analysis of 1-bit sigma-delta synthesizer

This letter presents a general analysis of time jitter in sigma-delta synthesizer. One of the practical applications of 1-bit sigma-delta systems is a generation of high-resolution local oscillator (LO) signals. In order to generate LO signals, one may use a single-bit sigma-delta technique to encode sine waves. Today, direct generation of high-frequency sine wave using a clock with higher frequency, is possible. In this letter, we will analyze different LO signal generators and develop a practical way of computation to decide how to choose the best configuration under minimum degradation of signal-to-noise ratio (SNR) at the output.     

声表面波脉冲编码调制振荡器

论述了一种直接式声表面波脉冲编码调制振荡器的工作原理及设计方法。实际制作了工作频率为３９４ＭＨｚ、调制频偏大于２００ｋＨｚ、调制信号码速率大于４００ｋｂｉｔ／ｓ、输出功率大于５０ｍＷ、温度稳定性优于±５０×１０－６（－２０°Ｃ～＋６０°Ｃ）的性能优良的声表面波脉冲编码调制振荡器     

Smaller Output Beam Divergence in the Slowly Opened Q-Switch Operation

The mechanism of the slowly opened Q-switch operation was investigated thoroughly. Maximum energy extraction from the resonator could be optimized, and the smallest output beam divergence could be achieved. In this article, we present a detailed analysis that has numerically verified the mode-selection mechanism in the slowly opened Q-switch operation, and the degree of the smaller output laser beam divergence that has been achieved. The mechanism of the slowly opened Q-switch operation is the inherent advantage of the passive saturable absorber in this operation. We can use the maximum energy extraction and the smallest output beam divergence results of the slowly opened Q-switch operation to design and optimize various passive saturable absorbers: plastic dye sheets, LiF:F₂⁻ color center crystals, Cr4⁺: YAG crystals, RG1000 color glass filters, and the single crystal semiconductor saturable absorber wafers that are in developed in our microchip laser systems.     

The Micro-Theory of Ultra-Short Pulse Propagating in Nonlinear Fiber

The modified quantum nonlinear Schrodinger equation of ultra-short pulse propagating in fiber is derived using dispersion relation and the Hamiltonian of the transmission system. The derived equation is solved with linearization approximation, and modulation instability is analyzed. The equation is also solved with Hartree approximation. The results indicate that pulse power, loss and self-steeping effect change the critical frequency, the maximum gain and the gain spectrum range, but the third order dispersion has no effect on modulation instability. The expectation value of optical field is average of a set of modified classical solitons, and higher order terms change the amplitude, pulse position and phase of soliton.     

脉冲离散效应对光纤中基于交叉相位调制的脉冲压缩的影响

通过数值模拟，分析了脉冲离散效应对单模光纤正群速色区基于暗孤子交叉不相位调制的脉冲压缩的影响，并提出了减轻这种影响的办法，作者发现，即使暗孤子与被压缩脉冲的中心波长相差很小，离散效应对脉冲压缩的影响也很大，离散效应不仅导致脉冲压缩比的减小和压缩后脉冲峰值功率的降低，而且还导致脉冲压缩所需最佳光纤长度的增加以及压缩后的脉冲呈现不对称性，还发现，若采取本文提出了的非同步耦合法，则可以明显地弥补离散效应     

载波钝化和钼酸盐后处理对不锈钢钝化膜性能的影响

一般认为交流电对金属的腐蚀过程具有加速作用,但我们发现,在直流电位基础上叠加适当波形、幅值和频率的交流电对不锈钢进行载波钝化,尔后再进行适当后处理可使钝化膜的稳定性提高,我们曾就不经后处理的载波钝化过程进行过探讨,本文着重探讨钼酸盐后处理对载波钝化膜表面状态和化学稳定性改善的作用机理。     

Electron kinetics of collision dominated r.f. bulk plasma in CO: The role of second-kind collisions

Electron energy distribution functions (EEDF) and related properties in the bulk region of the rf CO plasma at the reduced rf field frequency /p₀=×10⁷ sec^–1 torr^–1 have been calculated by solving the time-dependent spatially homogeneous Boltzmann equation in the presence of second-kind collisions and have been interpreted on a microphysical basis. The results show that second-kind collisions (vibrational and electronic) strongly affect the temporal evolution of EEDF, of the mean energy, and of the mean collision frequencies for vibrational and electronic excitation processes, as well as for ionization. In particular, second-kind collisions in the CO rf bulk plasma strongly decrease the modulation of the mean ionization frequency during its periodical alteration in the rf field. Furthermore, the effect of second-kind collisions on an approximate determination of the time-averaged EEDF in the rf bulk plasma using the so-called effective-field appriximation has been estimated.     

高铁场景下联合天线与IOS单元选择的分布式IOS-SM传输方案

针对高铁场景下封闭车厢带来的高信号穿透损耗导致传输速率下降问题,提出一种分布式智能全表面（intelligent omni-surface,IOS）辅助空间调制（spatial modulation,SM）的传输方案。首先,采用SM技术保证索引信息部分不受穿透损耗的影响;然后,为了减小远距离IOS车窗的高路径损耗和功率损耗,根据最大化接收信噪比原则对分布式IOS遍历选择,激活最佳IOS车窗传输SM调制信息。最后,为了减小缺失直视路径增益对系统容量性能的影响,基于功率损耗模型,采用天线移除原则和排序选择方式,对接收天线和IOS单元进行动态选择激活。仿真结果表明,相比于传统中继转发和可重构智能超表面-空间调制（reconfigurable intelligence surface-SM,RIS-SM）方案,所提方案更适合高铁通信场景。并且在功率损耗模型下,联合天线与IOS单元选择的分布式IOS-SM方案仍能够保证系统高性能传输。     

基于引导调制的彩色点云无参考质量评价方法

彩色点云(color point cloud, CPC)作为三维场景和对象的有效描述形式,在虚拟现实、增强现实等许多领域得到重要应用。CPC在其采集、压缩、传输、重建等过程中会引入相应的失真,需要设计有效的评价方法对失真CPC质量进行评测。本文提出一种基于引导调制的CPC无参考质量评价方法。考虑到几何信息与彩色纹理信息的联合失真,利用引导调制的方法联立两者,以综合考虑几何失真、彩色纹理失真、联合失真。结合人眼的多通道性,利用剪切波变换提取特征。最后,将所有特征构成的特征向量输入到支持向量回归模型(support vector regression, SVR)学习预测点云质量。实验结果表明,所提出的方法与人类主观感知具有很好的一致性。