A 24-GHz Patch Array with a Power Amplifier/Low-Noise Amplifier MMIC

This paper presents an active patch array designed at 24 GHz. It can be used as a front-end component for a phased array. A series resonant array structure is chosen which is compact and easy excite. With 5 elements, the array proved a 12-dB antenna gain. A power amplifier and a low noise amplifier are designed on a single GaAs chip (PALNA). Bias switch is used in the PALNA, which greatly reduces the switch loss in a transceiver and increases the efficiency. 20-dB small signal gain is achieved in both power amplifier and low noise amplifier. The active patch array is built by the combination of the patch array and PALNA. The measured active gain of this antenna is 35-dB for the PA mode and 31-dB for the LNA mode. This active patch array can obtain an EIRP of 34 dBm with a total radiated power of 22dBm and a maximum PAE of 32%. To check the noise performance, we applied sources at both normal temperature and 77K (liquid nitrogen) and extracted the noise figure (3.5 dB) of the active antenna by the Y factor method. The results proved that the active antenna is working efficiently as both a transmitting and receiving antenna.     

The minimum squared euclidean distance of multi-h phase codes

The minimum squared Euclidean distance(MSED) of binary multi-h phase codes is presented. The signal segregation degree(SSD) has been put forward to determine MSED of multi-h phase codes. In order to maximize MSED, SSD should be as large as possible. The necessary and sufficient conditions of maximizing SSD are derived. Finally, SSD and the exact formulae for MSED of binary 2-h phase codes are also presented.     

Skeleton chain coding for Chinese characters

The compression of Chinese characters is very important for Chinese office automation and desktop publishing. In this paper, various methods are used to compress 13,051 Chinese characters losslessly by coding their skeleton points. The skeleton points are composed of isolated points and curves. To trace every point in a curve once and consecutively is a NP problem. Therefore, we use contour path following and revisiting algorithms to trace skeleton curves with chain codes. The remaining isolated skeleton points are encoded by an Elias code. Our coding method has a better compression rate than that of conventional skeleton coding.     

群时延精确设计的全差分四阶Bessel滤波器

采用MOS管有源电阻,提出了一种全差分R-MOSFET-C四阶Bessel有源低通滤波器,.通过调节工作于亚阈值区的CMOS管的沟道导纳补偿电阻值的大小,能抵消集成电路制造工艺中电阻值的一致偏差,实现Bessel有源滤波器群时延的精确设计.根据无源滤波器的状态方程完成有源滤波器的综合,应用3.3V,0.5μm CMOS工艺完成了群时延大小为0.75μs的四阶Bessel低通滤波器的管极计算机仿真,仿真结果表明所提电路正确有效,适于全集成.     

大规模集成电路浮栅ROM器件总剂量辐射效应

提出了一种大规模集成电路总剂量效应测试方法:在监测器件和电路功能参数的同时,监测器件功耗电流的变化情况,分析数据错误和器件功耗电流与辐射总剂量的关系.根据该方法利用60Co γ射线进行了浮栅ROM集成电路(AT29C256)总剂量辐照实验,研究了功耗电流和出错数量在不同γ射线剂量率辐照下的总剂量效应,以及参数失效与功能失效时间随辐射剂量率的变化关系,并利用外推实验技术预估了电路在空间低剂量率环境下的失效时间.     

铜互连中SiCOF/a-C∶F双层低介电常数薄膜的制备和表征(英文)

用等离子体化学气相淀积系统制备了一种新颖的SiCOF/a-C∶F双层低介电常数介质薄膜,并用红外光谱表征了该薄膜的化学结构.通过测量介质的折射率发现该薄膜长时间暴露在空气中,其光频介电常数几乎不变.然而,随退火温度的增加,其光频介电常数则会减小.基于实验结果讨论了几种可能的机理.二次离子质谱分析表明在Al/a-C∶F/Si结构中F和C很容易扩散到Al中,但在Al/SiCOF/a-C∶F/Si结构中,则没有发现C的扩散,说明SiCOF充当了C扩散的阻挡层.分析还发现在SiCOF和a-C∶F之间没有明显的界面层.     

一种低压低功耗SRAM/SOI单元设计

提出一种改进4管自体偏压结构SRAM/SOI单元.基于TSUPREM4和MEDICI软件的模拟和结构性能的分析,设计单元结构并选取结构参数.该结构采用nMOS栅下的含p+埋沟的衬底体电阻代替传统6管CMOSSRAM单元中的pMOS元件,具有面积小、工艺简单的优点.该结构可以在0.5V的电源电压下正常工作,与6管单元相比,该单元瞬态响应正常,功耗只有6管单元的1/10,满足低压低功耗的要求.     

A Two-Level Spreading-despreading CDMA System and Its Performance Evaluation

1　IntroductionHowtosuppresstheinterferenceintheCDMAsystems,includingtheSelfInterference(SI) ,Mul tipleAccessInterference(MAI)andtheAdjacentCellInterference(ACI) ,isthekeypointinimprov ingthesystemperformanceandcapacity .Insteadofthecomplicatedspecializedsignalprocessingtech niquesusedbefore[1～ 4] ,spreadingsequenceswithgoodcorrelationpropertiescanimprovethesystemperformanceradically[5] .InRef.[6～ 9],theconceptofZeroCorrelationZone (ZCZ) ,whichisequivalenttothegeneralizedothogonal…     

Performance of a turbo‐coded CDMA system in a mobile satellite channel

The bit error rate (BER) performance of a turbo‐coded code‐division multiple‐access (CDMA) system operating in a satellite channel is analysed and simulated. The system performance is compared for various constituent decoders, including maximum a posteriori probability (MAP) and Max‐Log‐MAP algorithms, and the soft‐output Viterbi algorithm. The simulation results indicate that the Max‐Log‐MAP algorithm is the most promising among these three algorithms in overall terms of performance and complexity. It is also shown that, for fixed code rate, the BER performance is improved substantially by increasing the number of iterations in the turbo decoder, or by increasing the interleaver length in the turbo encoder. The results in this paper are of interest in CDMA‐based satellite communications applications. Copyright © 2005 John Wiley & Sons, Ltd.     

ULSI中的铜互连线RC延迟

随着ULSI向深亚微米特征尺寸发展，互连引线成为ULSI向更高性能发展的主要限制因素。由互连引线引起的串扰噪音及RC延迟限制了ULSI的频率性能的提高，同时考虑到电迁移和功率损耗，人们开始寻找新的互连材料；低电阻率的铜互连材料和低介电常数介质的结合可以有效地发送互连线的性能，主要讨论了互连延迟的重要性以及发送和计算延迟的方法。