Controlled structure and density of “living” polystyrene brushes on flat silica surfaces

Thin layers of polystyrene were grown from surface-grafted nitroxide initiators via controlled “living” free radical polymerization. The “reactive” Langmuir-Blodgett deposition method allowed an effective control of the initiator layer density leading to PS brushes with different and high grafting density and stretching. The influence of the grafting density on the layer structure was studied. Comparison with theoretical predictions for monodispersed brushes in bad solvent was discussed. The thickness was found to vary linearly with molecular weight and the density dependence was shown using wetting measurements. Special features of controlled radical nitroxide polymerization from a surface were discussed. A direct comparison of the molecular weight and polydispersity between surface and bulk polymers was made by de-grafting the brushes into a toluene/HF solution. Finally, some evidence of a “surface Fischer” effect was shown from re-initiated layers. Received 20 December 2001     

Identity of defect causing nonideality in nearly ideal Au/n-Si Schottky barriers

We have proposed a mechanism of nonideality, i.e., the temperature dependence of the ideality factor, in nearly ideal Au/n-Si Schottky barriers. Because of the nature of metal-induced gap states, positively ionized defects close to the interface are considered to cause local lowering of the Schottky barrier height (SBH) due to downward bending of the energy band. These positively charged defects become neutralized in equilibrium with the Fermi level due to the band bending, when they are very close to the interface. However, because the SBH lowering disappears by the neutralization of donor, the energy level of donor with a usual energy level scheme rises above the Fermi level after the neutralization. This contradiction to the equilibrium neutralization is resolved by Si self-interstitial with a large negative-U property, which is generated by the fabrication process. The energy level of the donor estimated from the SBH lowering is in good agreement with that of theoretical calculation of Si self-interstitial. Thus, the defect is concluded to be the Si self-interstitial, which is distributed to more than 10 Å depth from the interface.     

电沉积n—CdSe在多硫溶液界面上的电荷转移机理

通过测定平带电位,澄清了OH~-离子在CdSe电极上的吸附情况,发现在S、S~(2-)、OH~-溶液中S~(2-)离子优先吸附,结合旋转环盘电极测量,证明n-CdSe电极在多硫溶液界面上的电荷转移过程。     

Intermixing during epitaxial growth and Mössbauer spectroscopy with probe layers

Mössbauer spectroscopy with ⁵⁷Fe (¹¹⁹Sn) probe layers is a useful method to study the local magnetic structures at buried interfaces. However interface alloying, which always exists in the real samples, have to be taken into account for accurate interpretation of experimental data. We developed an algorithm, which describes the interface intermixing in the multilayers. Substituting deposited atoms by atoms of substrate and floating of deposited atoms in the upper layers during epitaxial growth leads to the formation of asymmetric chemical and magnetic interfaces. This asymmetry in the M₁/M₂ superlattices can explain the difference between magnetic responses from M₁ on M₂ and M₂ on M₁ interfaces which were observed in experiments. Applying this intermixing model to the systems with probe layers located at different distances from the interfaces gives the natural explanation of hyperfine fields distributions on probe atoms and helps us clarify some discrepancies reported in the literature.     

微机在应变测量中的应用

微机在应变测量中的应用，采用上位机和下位机组合方式．上位机为一台ＩＢＭ－ＰＣ／ＸＴ微机，用于对数据进行后处理．下位机以Ｚ８０－ＣＰＵ为控制器，由传感器、转换器、接口及外设等组成数据采集器，实施对应变、压力和位移等参数的采集、显示和打印（即数据的预处理）．上位机和下位机之间的数据传输，采用串行的方式，通过ＲＳ－２３２接口完成．本文主要以应变的采集处理为例，介绍系统功能、硬件配置及软件设计．     

采用热处理方法提高MEH-PPV单层聚合物有机发光二极管发光性能的研究

对以MEH－PPV为发光层的单层聚合物有机发光二极管（OLED）器件在最佳条件下进行真空热处理，并用金相显微镜观察施加电压后器件的阴极表面形貌。发现处理后的器件阴极表面的气泡及黑斑明显减少。器件的发光性能显著提高。与未经处理的器件相比，最大相对发光强度提高了一个数量级、启亮电压降低了2．0V，半寿命提高了12．7倍。初步分析表明热处理方法提高器件发光性能的主要原因在于有效地减少了器件在工作过程中由于焦耳热产生的某些气体，从而减少阴极表面气泡及黑斑的出现，另一方面，热处理方法也增强了有机发光层与阴极接触界面的结合力，提高电子注入水平。     

串行接口LED数码管及键盘管理器件ZLG7289A的原理与应用

介绍了LED数码管及键盘管理器ZLG7289A的原理与应用。该芯片具有SPI串行接口，可同时驱动8位共阴式数码管(或64只独立LED)，还可连接多达64键的键盘矩阵，单块芯片即可完成LED显示、键盘接口等全部功能。文章给出了ZLG7289A的特点、引脚功能、指令说明和经典电路．并以单片机AT89C51为例，给出了其接口电路及相应源程序。     

NiCuZn铁氧体和银内电极的共烧行为

NiCuZn铁氧体正作为磁介质广泛地应用于低烧多层片式电感，因此有必要对其与银内电极的共烧行为进行研究。该文主要介绍NiCuZn铁氧体／银内电极多层复合体共烧过程中的烧结收缩、界面反应、扩散对介质性能的影响。尖晶石结构中存在相当数量的空位，这为银离子提供了一定的溶解度，因此在共烧过程中银对铁氧体的相组成影响较小。银对铁氧体性能的影响体现在两个方面。一方面是由于银具有相对低的烧结温度，从而在烧结过程中起到助烧剂的作用，促进致密化过程，提高烧结体的密度和磁导率；另一方面，银促使铁氧体中的铜在晶界处析出，导致晶界处应力，使磁导率降低，晶粒生长也被一定程度地抑制。     

TMS320F240串口通信特征及其应用

主要论述了TMS320F240串行外设接口模块的特点，并通过与MCS5l单片机通信，实现液晶显示。     

示差半微分循环伏安法研究琥珀酰胆碱在水/硝基苯界面的传递行为

研究了油/水界面电解的示差半微分循环伏安行为。在0.01mol/L LiCl(w)-0.01mol/L TBATCIPB(nb)体系“电位窗”比TBATPB(nb)向正方向扩展约50mV,残余电流基本消除,使“电位窗”内的平台向左右拓宽约50mV。算得界面电容约为16μF/cm~2。考察了琥珀酰胆碱离子在w/nb界面的传递伏安特性,结果与一般半微分循环伏安法相似。但峰形改善,检测限降低一个数量级(1×10~(-6)mol/L),相对标准偏差在5％以内,可用于定量测定琥珀酰胆碱。