金刚石膜厚度尺寸对热残余应力的影响

 采用有限元方法对钼基体上不同厚度（20~1 000 μm）金刚石膜的热残余应力进行了全面的模拟与分析,得出了它们在膜内分布的等值线图,研究了金刚石膜厚度尺寸对整个膜内的最大主拉应力和界面处每个应力分量最大值的影响。结果表明：在整个膜内,最大主拉应力的位置出现在膜的表面、界面或侧面,其值随膜厚度的增加而增大;在界面处,最大轴向应力随膜厚度的增加而增大,而最大径向压应力、最大周向压应力和最大剪应力则随膜厚度的增加而减小,其中最大剪应力减幅较小;膜厚度越大时,以上各量随厚度增（减）的速度越慢。其结论对于在金刚石膜的制备中合理地选择厚度、有效地进行应力控制有一定的参考价值。     

强脉冲X射线辐照在Si-SiO2中感生的界面态及退火消除

 利用强脉冲X射线对Si-SiO₂界面进行了辐照，测量了界面态曲线和退火曲线。实验显示，经过强脉冲X射线对Si-SiO₂界面进行的辐照，在Si-SiO₂界面感生出新的界面态，感生界面态的增加与辐照剂量成正比，并且易出现饱和现象。总结出了感生界面态密度产额Dit随辐照剂量D变化的分布式，并定性分析了Dit随D变化的行为。随后进行的退火实验表明，强脉冲X射线辐照感生出的界面态越多，退火时这些界面态就消除得越快。退火过程显示有滞后现象，即辐照剂量大的阈电压漂移，在退火后恢复的绝对值，要小于辐照剂量小的阈电压漂移。导出了阈电压漂移随退火时间变化的关系，定性解释了滞后现象。     

SrTiO3金属-绝缘体-半导体结构的介电与界面特性

采用金属有机分解法在p型Si衬底上制备了SrTiO3（STO）薄膜.研究了STO薄膜金属 绝缘体 半导体(MIS)结构的介电和界面特性.结果表明，STO薄膜显示出优异的介电性能，在10kHz处的介电常数约为105，损耗低于001，这来源于多晶结构和良好的结晶性；MIS结构中的固定电荷密度Nf和界面态密度Dit分别约为15×1012cm-2和(14—35)×1012cm-2eV-1，这主要与Si/STO界面处形成的低介电常数界面层有关. 关键词： SrTiO3薄膜 MIS结构 介电性能 Si/STO界面     

有限元计算中疏密网格过渡方法研究

工程计算中出于节省计算量的目的,往往需要在一个有限元模型中布置粗细不同的网格。为保证计算结果的准确性,必须保证网格突变情况下的位移协调问题。本文工作之一是在强天驰界面过渡单元的基础上,引入虚拟节点和子单元,在子单元中应用节理元思想,提出了基于最小势能原理的弹簧节理单元法。简化了积分运算,避免了精度要求极高的坐标转换,从而提高了方法的精度和实用性;二是提出了基于位移约束的主从自由度法,简便实用,只需简单的矩阵运算即可实现。两种方法均实现了不同尺寸网格间位移的协调性和刚度的匹配,从而使之满足有限元收敛准则,且生成的刚度阵具有对称性及带状性。算例证明两种方法精度良好,并可方便地应用于求解大规模工程问题。     

MOS器件辐照过程和辐照后效应模拟

模拟MOS器件脉冲电离辐射响应和长时间恢复效应.假设隧道电子从硅进入氧化层和界面态的建立是辐射效应的恢复机理.在整个退火恢复期,采用卷积模型并考虑了栅偏置压的效应.模拟结果表明:退火过程所加栅偏压的大小以及隧道电子效应与建立的界面态所占比例的不同影响器件的恢复率.     

基于P300的便携式中文输入系统

目前有关中文BCI输入系统的研究仅有拼音输入和笔画输入两种,且都克服不了中文输入速率较低、不便携等问题.据此提出了基于P300的五笔中文输入系统.此系统通过低成本OpenBCI套件,使用Wi-Fi协议传输脑电数据,在移动设备上实现刺激界面,并使用卷积神经网络处理脑电信号.实验表明,该系统具有高中文输入速率、高准确率以及...     

Effect of Coconut Protein and Xanthan Gum,Soybean Polysaccharide and Gelatin Interactions in Oil-Water Interface

We report on our study of the interactions between coconut protein extracted from coconut meat and three hydrocolloids (gelatin, xanthan gum, and soybean polysaccharide) and their interfacial adsorption and emulsification properties. We used Zeta potential, fluorescence spectroscopy scanning and ITC to investigate the interactions between a fixed concentration (1%) of coconut protein and varying concentrations of hydrocolloid. Through the interfacial tension and interfacial viscoelasticity, the interfacial properties of the hydrocolloid and coconut protein composite solution were explored. The physical stability of the corresponding emulsion is predicted through microstructure and stability analysis. Xanthan gum forms a flocculent complex with coconut protein under acidic conditions. Soy polysaccharides specifically bind to coconut protein. Under acidic conditions, this complex is stabilized through the steric hindrance of soy polysaccharides. Due to gelatin-coconut protein interactions, the isoelectric point of this complex changes. The interfacial tension results show that as time increases, the interfacial tensions of the three composite solutions decrease. The increase in the concentration of xanthan gum makes the interfacial tension decrease first and then increase. The addition of soybean polysaccharides reduces the interfacial tension of coconut protein. The addition of xanthan gum forms a stronger elastic interface film. Emulsion characterization showed that the gelatin-added system showed better stability. However, the addition of xanthan gum caused stratification quickly, and the addition of soybean polysaccharides also led to instability because the addition of polysaccharides led to a decrease in thermodynamic compatibility. This research lays the foundation for future research into coconut milk production technology.     

发射机嵌入式远程监控系统的以太网接口设计

针对传统的广播发射机远程监控系统常需用PC机联入Internet而形成接入成本高、体积大等诸多弊端,介绍了一种低成本、小体积的广播发射机嵌入式远程监控系统。详细阐述了由ARM处理器S3C2410A作为主控芯片,RTL8019AS作为以太网接口芯片等实现以太网接口的硬件电路设计。软件设计中,在介绍Linux微内核的定制与裁剪的基础上,给出了Linux下RTL8019AS驱动程序实现的具体步骤,最终实现了嵌入式以太网的数据传输。该设计已经成功应用在广播发射机远程监控系统中,系统性能稳定可靠。     

Binary Controls on Interfacial Magnetism in Manganite Heterostructures

The complex interfacial correlations provide new routes toward tunable functionalities. Here, the wide range of tunabilities for magnetic properties are presented, including Curie temperature (from 245 to 320 K), coercive field (from 2 to 205 Oe), and saturated magnetic moment (from 0.9 to 2.8 µ_B Mn^?1), in a 9‐unit‐cell La_2/3Sr_1/3MnO₃ (LSMO) layer via modifying interfacial boundary conditions. Moreover, the LSMO/PbTiO₃‐based multilayers and superlattices that consist of PbTiO₃/LSMO/NdGaO₃ and PbTiO₃/LSMO/PbTiO₃ interfaces are characterized by two distinct Curie temperatures and coercive fields. The results reveal the feasibility of the interface‐resolved strategy based on boundary modification in fabricating potential devices with multiple accessible states for information storage. The wide‐range modulations on magnetic properties at LSMO/titanate interfaces are explained in terms of binary controls arising from the oxygen octahedral coupling (OOC) and magnetoelectric coupling (MEC). The results not only shed some light on understanding interfacial correlations in oxide heterostructures, but also pave an alternative path for exploring multiple accessible states in all‐oxide‐based electronic devices.     

基于多RS-485的水文监测系统

水文监测在需要测量多个水文数据的同时,测试点的数量也在增加.为了解决RS-485总线节点不够用的问题,本文利用PC机控制多个独立RS-485总线,采用硬件线路切换的方式,实现对各总线中节点互不干扰的监控.采用VB6.0编写的主监控程序,实现了对各个RS-485总线的监测与控制.