Formal Mathematical Analysis of the Existence of the Common Intersection Point in Relation to Determining the Parameters Describing Ion Adsorption at the Oxide/Electrolyte Interface: Comparison of the Triple and Four-Layer Models

For most oxide/electrolyte systems potentiometric titration curves measured for different ionic strengths have a Common Intersection Point (CIP) which corresponds to the Point of Zero Charge (PZC). However, there are systems where a CIP exists but the surface charge at this point does not equal zero (PZC CIP). In this paper theoretical analysis of the systems in which the PZC and CIP do not coincide is presented. It is based on the well-known 2-pK surface charging approach and Triple Layer Model (TLM) as well as the Four Layer Model (FLM) of the electric double layer. The appropriate mathematical criterion for CIP existence was applied with detailed derivations, both for TLM and FLM. Having determined in this manner the parameter values, one can draw proper conclusions about the features of oxide/electrolyte adsorption systems, in which PZC and CIP do not coincide. The values of adsorption parameters are found by fitting simultaneously the obtained theoretical expressions to both of the experimental titration isotherms, and to the individual isotherms of electrolyte cation adsorption measured using radiometric methods.     

Design considerations and an example of application of an in-house made TG-MS interface

The design, the abilities and a characteristic application of an in-house made interface for combining thermogravimetry (TG) with mass spectrometry (MS) are presented. The TG-MS interface consists mainly of three co-axial tubes. The position of the intermediate tube was determined after calculation of the temperature profile at the TG furnace exit tube. The inner tube position was determined taking into consideration its protection against condensation of heavy molecules and the time delay for the transfer of the evolved gases. This interface allows either continuous sampling and transferring of the evolved gases from the TG to the MS or repetitive introduction of short sampling pulses of TG evolved gases to MS. The interface is capable of coupling various commercial instruments. In the present work two configurations of this interface are demonstrated. Finally an example of application of this interface on forest fuel pyrolysis is presented. This revised version was published online in July 2006 with corrections to the Cover Date.     

二维液相色谱接口的改进及其在蛋白质组学研究中的应用

随着蛋白质组学、本草物质组学等组学概念的提出,所需分析的样品的成分越来越复杂,因此具有强大分离能力的多维液相色谱技术受到人们越来越多的关注。二维液相色谱中第二维的分离性能和速度是整个分离系统性能的关键。基于捕集柱模式,我们采用经特殊设计的流路系统,使得双捕集柱型接口具有预分离的功能。样品从第一维流出以后被富集在捕集柱1的柱头,经过脱盐后,正冲捕集柱,捕集柱1与第二维色谱柱联用对富集的样品进行分离,增加了第二维分离效率。当捕集柱上的样品全部被洗脱到第二维色谱柱上时,捕集柱2已经完成对第一维洗脱液中样品的捕集和脱盐,此时将阀进行切换,捕集柱2与第二维色谱柱直接相连进行洗脱。循环切换捕集柱1和捕集柱2,维持较高的阀切换频率,实现了第二维色谱柱的连续洗脱。因此保证了第二维分离具有较快速度,同时具有较高的分离效率。使用35 mm长捕集柱和十通阀为接口,以弱阴离子交换(WAX)色谱为第一维分离模式,以反相(RP)色谱为第二维分离模式,构建了WAX-RP二维液相色谱系统(2D-LC system)。以小鼠血清为样品对系统进行了初步评价。色谱流出曲线出现了明显的界面现象,这是由于捕集柱流动相中含有的较多盐分流出时的背景吸收造成的。同时,由于界面两侧的流动相黏度不同产生了黏性指进(VF)现象。当第二维色谱柱长度为50 mm时,理论上可将第二维分离效能提高70%。该接口可以应用于多种二维液相色谱模式,适用于蛋白质组学和本草物质组学研究中对于复杂样品的分离分析。     

土壤颗粒表面电场作用下固-液界面Mg2+-K+与Ca2+-K+交换动力学的比较研究

通过恒流法研究了不同表面电场作用下Mg2+、Ca2+吸附动力学. 结果发现: (1)实验初期阶段是强静电力作用下的零级动力学过程和一定反应时间后的弱静电力作用下的一级动力学过程, 且零级速率过程和一级速率过程之间存在明显的转折点; (2)不同电解质构成中Ca2+的吸附速率明显快于Mg2+的, 平衡吸附量也大于Mg2+的, 且Ca2+在土壤颗粒表面的覆盖度比Mg2+在土壤颗粒表面的覆盖度高; (3)离子的相对有效电荷系数与土壤颗粒表面电场作用的不同是各体系中Ca2+、Mg2+吸附动力学有差别的根本原因; (4)根据离子吸附的理论模型可以分别计算出速率系数、平衡吸附量、离子在土壤颗粒表面的覆盖度以及固定液的体积, 这些参数可以定量评估土壤颗粒表面电场对离子吸附动力学的影响.     

Li2CO3添加剂对石墨电极性能的影响

运用电化学阻抗谱(EIS)和循环伏安法(CV)研究了在1mol/LLiPF6-EC(碳酸乙烯酯):DMC(碳酸二甲酯)电解液中添加Li2CO3对石墨电极性能的影响及机制.CV研究结果表明,在1mol/LLiPF6-EC:DMC电解液中添加Li2CO3能够有效抑制石墨电极首次充放电过程中碳酸乙烯酯(EC)的单电子还原过程,即还原分解产生乙烯和碳酸锂的过程,进而改善石墨电极的电化学循环性能.EIS研究结果表明,在添加Li2CO3的1mol/LLiPF6-EC:DMC电解液中,石墨电极表面的固体电解质相界面膜(SEI膜)具有较强的黏弹性,可以更好地适应锂离子嵌入过程中石墨颗粒体积的微小变化,从而使锂离子的嵌入过程更容易进行.     

Dissolved oxygen amperometric sensor based on layer-by-layer assembly using host-guest supramolecular interactions

The development of a simple, efficient and sensitive sensor for dissolved oxygen is proposed using the host-guest binding of a supramolecular complex at a host surface by combining a self-assembled monolayer (SAM) of mono-(6-deoxy-6-mercapto)-β-cyclodextrin (βCDSH), iron (III) tetra-(N-methyl-4-pyridyl)-porphyrin (FeTMPyP) and cyclodextrin-functionalized gold nanoparticles (CDAuNP). The supramolecular modified electrode showed excellent catalytic activity for oxygen reduction. The reduction potential of oxygen was shifted about 200 mV toward less negative values with this modified electrode, presenting a peak current much higher than those observed on a bare gold electrode. Cyclic voltammetry and rotating disk electrode (RDE) experiments indicated that the oxygen reduction reaction involves probably 4-electrons with a rate constant (k_obs) of 7 × 10⁴ mol⁻¹ L s⁻¹. A linear response range from 0.2 up to 6.5 mg L⁻¹, with a sensitivity of 5.5 μA L mg⁻¹ (or 77.5 μA cm⁻² L mg⁻¹) and a detection limit of 0.02 mg L⁻¹ was obtained with this sensor. The repeatability of the proposed sensor, evaluated in terms of relative standard deviation was 3.0% for 10 measurements of a solution of 6.5 mg L⁻¹ oxygen.     

电化学表面增强拉曼光谱-现状和展望

许多和能源、生命相关的过程都强烈依赖于电化学荷电界面的结构和性能.自从表面增强拉曼光谱效应发现后,就很快地被应用于电化学界面的原位研究,即从分子水平上深入表征各种表面(或界面)的结构和过程,如鉴别物种在表面的键合、构型和取向等.最近十年,纳米科技的飞速发展为SERS技术提供了丰富的基底以及检测和表征方法,从而推动了与纳米科学密切相关的电化学SERS领域令人瞩目的发展.本文系统介绍Au和Ag的SERS、过渡金属薄层SERS、纯过渡金属SERS、核壳结构SERS和已经可以应用于单晶表面研究的gap-modeSERS、TERS和SHINERS,其中穿插着介绍电化学SERS的历史发展、现状和存在的问题及其展望,为电化学SERS研究提供较为全面的详细的参考.     

Electrochemical reactions at the electrode/solution interface:Theory and applications to water electrolysis and oxygen reduction

Theoretical simulations on complex electrochemical processes have been developed on the basis of the understanding in electrochemistry,which has benefited from quantum mechanics calculations.This article reviews the recent progress on the theory and applications in electrocatalysis.Two representative reactions,namely water electrolysis and oxygen reduction,are selected to illustrate how the theoretical methods are applied to electrocatalytic reactions.The microscopic nature of these electrochemical reaction...     

聚合物/水两相界面自由基引发聚合制备不对称粒子

报导了一种新的制备不对称粒子的简单方法. 首先, 利用旋转涂膜法在云母片表面涂上一层聚4-乙烯基吡啶(P4VP)薄膜, 并且P4VP薄膜中分散有自由基引发剂偶氮二异丁腈(AIBN)和二乙烯基苯(DVB); 然后将云母片插入溶解有N-异丙基丙烯酰胺(NIPAM)的水溶液, 在氮气保护下升高温度, 实施自由基聚合. 聚合起始阶段, AIBN分解的自由基主要是在P4VP薄膜中引发DVB聚合. 由于相分离, DVB聚合后形成的PDVB在P4VP中形成粒子. 随着聚合的进行, 由于PDVB粒子的不断长大或向水/P4VP界面迁移, 使得粒子的一侧暴露在水相中. 在界面上, PDVB粒子上的大分子自由基或AIBN新分解产生的自由基与PDVB中剩余双键继续反应形成的大分子自由基引发水相中的NIPAM反应, 从而在粒子的一侧形成PNIPAM接枝; 而PDVB粒子的另一侧则嵌在P4VP膜中, 不会参加接枝反应. 最后, 实施与P4VP层分离后即可得到两亲性的PDVB-PNIPAM不对称粒子.     

Effect of SDBS on interfacial electron transfer at the liquid/liquid interface by thin layer method

The effect of an adsorbed anionic surfactant sodium dodecyl benzene sulfonate(SDBS) on electron transfer(ET) reaction between ferricyanide aqueous solution and decamethylferrocene(DMFc) located on the adjacent organic phase was investigated for the first time by thin layer method.The adsorption of SDBS at the interface resulted in a decay in the cathodic plateau current of bimolecular reaction with increasing concentrations of SDBS in aqueous phase.However,the rate constant of electron transfer(k_(et)) i...