乙醇-盐-水-5-Br-PADAP体系萃取分离测定钯

研究了在硫酸铵存在下 ,5 Br PADAP乙醇体系中Pd(Ⅱ )、Rh(Ⅲ )、Pt(Ⅳ )的萃取行为及乙醇溶液的分相条件 ,讨论了影响萃取率的各种因素 ,试验表明 ,室温下 ,一定 pH范围内 ,该体系中的Pd(Ⅱ )几乎可完全被乙醇相萃取 ,而Rh(Ⅲ )、Pt(Ⅳ )不被萃取或萃取率很低 ,从而可实现Pd(Ⅱ )、Rh(Ⅲ )、Pt(Ⅳ )混合离子的定量分离 ,同时建立了Pd(Ⅱ )的测定方法。乙醇相中Pd(Ⅱ ) 5 Br PADAP配合物表观摩尔吸光系数为 1.18× 10 5L·mol- 1·cm- 1,钯量在 0～ 9.6 0 μg/10ml范围内符合比耳定律 ,检出限为 0 .0 90 μg/10ml。用该法分离混合样和测定两种活性碳钯催化剂中钯 ,结果满意     

萃取动力学光度法测定活化剂铝——铝(Ⅲ)-过氧化氢-铜(Ⅱ)-邻氨基酚/氯仿体系

研究了在pH 5.5的弱酸性介质中, 利用Al(Ⅲ)对Cu(Ⅱ)催化H2O2氧化邻氨基酚显色的指示反应的活化作用.用萃取平衡控制反应时间、水相中邻氨基酚的浓度和反应进行的程度.通过在424 nm下测量有机相的吸光度,建立了萃取催化光度法测定活化剂铝的新方法.方法的线性范围为0.004～0.25 mg/L,检出限为1.6×10 -6 g/L.用于水样和茶叶中铝含量的测定,结果满意.     

重油催化裂化汽油中含氮化合物的分析

利用酸萃取技术浓缩分离重油催化裂化（RFCC）汽油中的氮化物，比较了两种萃取剂和两种油剂比对分离效果的影响，结果发现选用10％（体积分数）HCl作萃取剂，油剂比为10：1（体积比）时，碱性氮化物的提取率较高；浓缩分离出的氮化物用色谱－质谱联用方法对其进行了检测，结果表明RFCC汽油中的氮化物主要是C0－C2苯胺及少量吡啶类、喹啉类碱性氮化物。     

双冠醚研究(Ⅳ)——Schiff碱型和仲胺型双-(苯并15冠-5)对碱金属苦味酸盐的萃取行为

仲胺型双冠醚与四苯硼酸碱金属盐在丙酮溶液中。25℃下的电导说明它们与Na~+可能形成1∶1络合物(冠醚单元∶金属离子),而与K~+、Rb~+、Cs~+离子则形成2∶1络合物。用Schlff碱型和仲胺型双-(苯并15-冠-5)在水-氯仿体系中进行萃取,测量了分配比D和萃取平衡常数K,发现后者的K值均大于前者。双冠醚F_2对K~+的萃取能力最强,选择性最佳。     

铜、钴、镍同时分离工艺的研究

稀土体系三种元素同时分离的工艺最近已有发表,但非稀土方面的工作尚未见报导.对Cu、Co、Ni三种元素,通常是将Cu、Co作为一个组份与Ni分离.本工作对组成为Cu:Co:Ni=1:1:1的水相合成料液设计了两种工艺,进行了串级实验,实现了该三种元素的同时分离, 串级实验以HEH(EHP)作萃取剂,煤油为稀释剂,其它试剂均用分析纯.     

New macrocycles derived from biphenyl for pH-switched solvent extraction

Four new fluorescent macrocyclic ligands derived from biphenyl are described. The new compounds have been used in liquid-liquid extraction experiments and the influence of pH has been studied in those ligands containing carboxylic groups. The results obtained for the latter ligands have been compared with those observed in the presence of an external acid.     

Pressurized hot water extraction of berberine, baicalein and glycyrrhizin in medicinal plants

Pressurized hot water extraction (PHWE) using a laboratory made system was applied for the extraction of thermally labile and reasonably polar components such as berberine in coptidis rhizoma, glycyrrhizin in radix glycyrrhizae/liquorice and baicalein in scutellariae radix. PHWE was carried out dynamically at a flow of 1 ml/min, temperature between 95 and 140 °C, an applied pressure of 10-20 bar and extraction time of 40 min. Extraction by PHWE was found to give efficiencies comparable to Soxhlet extraction for baicalein in scutellariae radix and sonication for berberine in coptidis rhizoma, and glycyrrhizin in radix glycyrrhizae. Effects of ethanol added into the water used in PHWE were explored. Pressurized liquid extraction (PLE) with methanol as solvent was used for extraction of baicalein in scutellariae radix. The marker compounds present in the various medicinal plant extracts were determined by gradient elution HPLC.     

Determination of organotin compounds in biological samples using accelerated solvent extraction,sodium tetraethylborate ethylation,and multicapillary gas chromatography–flame photometric detection

A method has been developed for species-selective analysis of organotin compounds in solid, biological samples. The procedure is based on accelerated solvent extraction (ASE) of analytes and includes extraction of the tin species with a methanol–water (90% methanol) solution of acetic acid/sodium acetate containing tropolone (0.03% w/v), their ethylation with NaBEt₄, and separation and detection by GC–FPD. The analytical procedure was optimized with an unspiked sample of harbor porpoise (Phocoena phocoena) liver. Effects of ASE operational variables (extraction temperature and pressure, solvent composition, number of static extraction steps) are discussed. Method detection limits (MDL) were in the range 6–10 ng(Sn) g^–1 dry weight and 7–17 ng(Sn) g^–1 dry weight for butyl- and phenyltin compounds, respectively. Recoveries were comparable with or better than those obtained by use of other procedures reported in the literature. The analytical procedure was validated by analysis of NIES No. 11 (fish tissue) certified reference material.     

Polymer-coated hollow-fiber microextraction of estrogens in water samples with analysis by gas chromatography-mass spectrometry

A novel sorbent, dihydroxylated polymethylmethacrylate (DHPMM), coated on hollow-fiber membrane, is used for the polymer-coated hollow-fiber microextraction of trace amounts of natural and synthetic estrogens, such as diethylstilbestrol, estrone, 17beta-estradiol and 17alpha-ethynylestradiol, in aqueous samples. In this procedure, estrogens were extracted using the functionalized polar DHPMM polymer with derivatization using N-methyl-N-(trimethylsilyl)trifluoroacetamide followed by gas chromatography-mass spectrometric analysis. The detection limits for estrogens in aqueous sample were between 0.03 and 0.8 ng l(-1) and the calibration curves were linear over the concentration range 0.05-10 microgl(-1) and had correlation coefficients of >0.994. The relative standard deviations (RSDs) were <15% (n = 3). This simple, accurate, sensitive and selective analytical method is applicable to the determination of trace amounts of estrogens in reservoir and potable water samples.     

Separating Ag, B, Cd, Dy, Eu, and Sm in a Gd matrix using 2-ethylhexyl phosphonic acid mono-2-ethylhexyl ester extraction chromatography for ICP-AES analysis

The separation procedure for Ag, B, Cd, Dy, Eu and Sm as impurities in Gd matrix using ICP-AES technique with an extraction chromatographic column has been developed. The spectral interference of the Gd matrix on the elements was eliminated using a chromatography technique with 2-ethylhexyl phosphonic acid mono-2-ethylhexyl ester (PC-88A) as the mobile phase and XAD-16 resin as the stationary phase. Ag⁺, B₄O₇²⁻, and Cd²⁺ were eluted with 0.1 M HNO₃, while rare earth ions were not. The best eluent for separating Eu and Sm in the Gd matrix was 0.3 M HNO₃. The limit of quantitation for these elements was 0.6-3.0 ng mL⁻¹. The recovery of Ag, B, and Cd was 90-104% using 0.1 M HNO₃ as the eluent, while that of Eu, Gd, and Sm ranged from 100 to 102% with 0.3 M HNO₃. Dy was recovered quantitatively with 4 M HNO₃. The relative standard deviation of the methods for a set of three replicates was between 1.0 and 15.4% for the synthetic and standard Gd solutions. The proposed separation procedure was used to measure Ag, B, Cd, Dy, Eu, and Sm in a standard Gd solution.