Electrogenerated Chemiluminescence Based on Tris(2,2′-bipyridyl) Ruthenium(II) with Hydroxyl Carboxylic Acid

Upon the electrochemical oxidation of tris(2,2′-bipyridyl) ruthenium(II) [Ru(bpy)²⁺₃] and hydroxyl carboxylic acids, for instance, citric acid, tartaric acid, malic acid, and -gluconic acid, bright electrochemiluminescences (ECLs) were observed. Different luminescent reactions were presented depending on the applied potential. The light emission was mainly caused by the reaction between alkoxide radical ion and Ru(bpy)³⁺₃below the potential +1.80 V (vs Ag/AgCl). The luminescence intensity obviously increased because of the more complex reaction process. The luminescence wavelength of 608 nm, which could be found either at higher potential than +1.80 V or in the potential range from +1.30 to +1.80 V, confirmed that ECL was caused by Ru(bpy)²⁺₃*. The factors which affect the determination and HPLC separation of the four acids were also investigated.     

Biosensors for environmental pollutants and food contaminants

This review article provides an overview of the most recent literature on biosensors for environmental pollutants and food contaminants. Due to the large number of publications, only papers published between 2000 and January 2003 were considered. Also, while not all of the published literature could be reviewed here, over 200 references are cited to provide a good overview of research undertaken in the last two years. Older publications are covered by a number of earlier review articles. This article provides an introduction into the field including specific consideration of the application areas, describes the typical biosensor assay format used, and is subsequently structured according to the biorecognition elements used (i.e., nucleic acids, enzymes, whole cells, tissue and whole organisms, antibodies and receptors, and biomimetic materials). In addition, a section on microbiosensing systems is provided. Since only very few microbiosensors with applications in environmental and food systems have been published, enabling technology is also covered in this article.Abbreviations BOD biological oxygen demand - cfu colony forming units - DNP dinitrophenol - GFP green fluorescent protein - NASBA nucleic acid sequence-based amplification - PCR polymerase chain reaction - ppt parts per trillion - QCM quartz crystal microbalance - SPR surface plasmon resonance     

Surface chemical analysis of raw cotton fibres and associated materials

The surface chemical composition of raw unscoured cotton was successfully investigated by the surface analytical techniques X-ray Photoelectron Spectroscopy (XPS) and Time of Flight Secondary Ion Mass Spectrometry (ToF-SIMS). The presence of non-cellulosic material at the fibre surface was established and determined to be a complex mixture of fatty acids, alcohols, alkanes, esters and glycerides. The effect of scouring and bleaching was to reduce the surface concentration of these materials but even after aqueous processing some non-cellulosic material residue was still detected at the fibre surface.     

The molecular and crystal structures of two diastereomeric 3,4-dihydropyrromethenones

The molecular and crystal structures of the two racemic diastereomeric 3,4-dihydropyrromethenone derivatives1 and2 of configurations (Z) and (E) were determined at 93 K (1, 2) and at room temperature (1). From an analysis of the crystallographically observed temperature coefficients a pseudorotation flexibility of the pyrrolidinone ring in the crystal is deduced. In both compounds a nearly orthogonal arrangement between the two heterocyclic ring systems is observed, which is ascribed to the steric bulk of the substituents in positions 1 and 3 of the pyrrolidinone ring.Herrn Prof.Josef Schurz zum 60. Geburtstag gewidmet.     

Integrated Dust Analysis by Physical Methods

Environmental analyses show that the air which we breathe, and which is so essential to life, is in general a mixture of gaseous, liquid, and solid components. The solid airborne particles, whose concentration, homogeneity, chemical composition, size, and shape can vary over wide ranges, and whose origin may be “natural” or “artificial” are referred to as “dust”. Dust particles can act, inter alia, as condensation nuclei, catalysts, and directly as hazardous materials. Unfortunately, we still know far too little about dust. Dust analysis is extremely difficult and challenging, even for modern analytical chemistry; it is still far from being fully automated. The simultaneous determination of as many “dust parameters” as possible, and particularly the synoptic consideration of all available data against a background of physicochemical and technological knowledge on the development, transformation, and effects of dust, are summarized as “integrated dust analysis”.     

停留—催化反应速差动力学法同时测定Fe,Mo

根据Ｆｅ（Ⅲ）、Ｍｏ（Ⅵ）对Ｈ２Ｏ２氧化邻氨基酚的催化反应速率不同，结合流动注射停留技术，建立了同时测定Ｆｅ（Ⅲ）、Ｍｏ（Ⅵ）的速差动力学分光光度法．测定铁和钼的线性范围分别为０．１～２．５μｇ／ｍＬ和０．５～１５μｇ／ｍＬ．除Ｗ（Ⅵ）的允许量较小外，其它离子不干扰测定．用本法测定了合成样液中铁和钼含量，结果满意．     

4-Hydroxy-2-quinolones 131. Bromination of 3-allyl-4-hydroxy-2-oxo-1,2-dihydroquinoline

The bromination of 3-allyl-4-hydroxy-2-oxo-1,2-dihydroquinoline by molecular bromine is accompanied by the closure of a five membered furan ring and gives the corresponding 2-bromomethyl-3,9-dihydro-2H-furo[2,3-b]quinolin-4-one. __________ Translated from Khimiya Geterotsiklicheskikh Soedinenii, No. 11, pp. 1677–1686, November, 2007.     

Conformational Study of Naringenin in the Isolated and Solvated States by Semiempirical and Ab Initio Methods

Naringenin is a natural widespread flavanone occurring in different foodstuffs that presents several important biological activities. Although its properties are well documented, its mechanisms of action are still controversial. The present article reports a conformational analysis of naringenin, using the semiempirical AM1 and ab initio methods, at the Hartree–Fock level of theory. The 3-21G, 3-21G*, 6-31G, and 6-31G** basis sets were used. The electron correlation effects were included through the Møller–Plesset second-order perturbation theory. The solvation of naringenin has been investigated through the standard SCRF, the supermolecule (SM), and the combined SM/SCRF models. The results have shown that there are two degenerate forms of naringenin, differing mainly by the orientation of a hydroxyl group (C4—OH). The energy barrier for the interconversion between them is ca. 6 kcal.mol^–1, suggesting some conjugation between the -system of the aromatic B ring and the hydroxyl group (C4—OH).     

3,5-diBr-PADAP作锆(Ⅳ)显色剂的分光光度法研究与应用

本文研究了在非离子表面活性剂存在下,用3,5-diBr-PADAP作锆显色剂的胶束增溶分光光度法。在pH1.0～2.0的HCl介质中,配合物吸光度最大且稳定,最大吸收值在610nm处。Zr(Ⅳ)与试剂形成1:2的配合物,摩尔吸光系数为1.10×10~5L·mol~(-1)·cm~(-1),zr(Ⅳ)量在0～30μg/25mL范围内遵守比尔定律。采用钽试剂一苯苹取分离法,适合于钽铌矿中微量锆的测定。     

Microcalorimetry, energetics and binding studies of DNA-dimethyltin dichloride complexes

The interaction of dimethyltin dichloride (Me₂SnCl₂) with calf thymus DNA was studied at 27 °C, pH 7.6 using various techniques including isothermal titration calorimetry (ITC) and UV-Vis, fluorescence and IR spectrophotometries. The binding isotherm and enthalpy curve for Me₂SnCl₂-DNA interaction was a biphasic transition process. This was determined by the analysis of the binding data with the Hill equation. The first phase of the enthalpy curve (exothermic process) was consistent with the first set of binding site, the second phase (endothermic process, less exothermicity) was consistent with second set of binding site from the cited interactions. Our results showed that the first set of binding sites is occupied by one mole of ligand bound per near 1 base pair of DNA. The DNA-ethidium bromide (EB) complex, in the presence of Me₂SnCl₂, caused the quenching of the fluorescence emission. The Scatchard plots illustrated a non-intercalating manner for such quenching. The DNA-EB complex results indicated that the binding of Me₂SnCl₂ is with the phosphate groups of DNA at low ligand concentrations (<9 mM). This was confirmed with the IR spectrophotometric spectra. However, the binding at higher ligand concentrations (>9 mM) was with the base groups of DNA. Therefore, these results suggest that the Me₂SnCl₂ binding to DNA at low concentrations occurs through an outside interaction by an exothermic process. However, the partial unfolding of the DNA caused at higher concentrations of Me₂SnCl₂ is through an endothermic process involving interactions with the base groups.