Tailoring the dielectric properties and energy storage density of 1−x(0.94NaNbO3−0.06SZ)−xBi2O3 through substitution strategy

Energy storage using dielectric capacitors is a growing area of research and development. However, designing a highly performing dielectric capacitor is still a challenge. Despite the excellent results achieved in lead-based dielectrics, lead-free substitutes are essential because of the environmental concerns associated with lead-based products. The lead-free 1?x (0.94NaNbO₃? 0.06SrZrO₃)+ x Bi₂O₃ ceramics abbreviated NNSZ + xB for x = 0.0, 0.05, 0.1, 0.15, and 0.20 was fabricated via solid-state reaction. A recoverable energy density of 2.93 J cm?³ was obtained for NNSZ+0.1B, associated with high thermal stability (25–130 °C), excellent cycling (N = 10⁵), and high efficiency (η) of 83.5%. Moreover, the introduction of Bi₂O₃ significantly improved the electrical insulation (?_r at 1 kHz = 1608 and tan δ = 0.0038) and breakdown strength (380 kVcm?¹) of NNSZ+0.1B by minimizing the formation of sodium, bismuth, and oxygen vacancies. The results obtained in this study provide a benchmark for further investigations on NaNbO₃-based ceramics. More importantly, this study suggests that NNSZ + xB ceramics can be used in pulsed power technology.     

太阳运动模拟平台的单片机控制

针对用太阳运动模拟平台实现太阳运行位置的全面预测和重现这一问题,提出了采用单片机对该平台进行控制,电机通过变频实现不同时间段不同速率运动模拟太阳运行轨迹的方法。根据输入日期计算出太阳的高度角和方位角,并转换为驱动电机的脉冲数和频率,电机带动执行机构运动使模拟光源到达预定位置。用编码器测量电机实际脉冲,定期进行误差校正来提高系统的稳定性和精度,减少误差。经过实验验证,该平台能够使模拟光源按照预计的轨迹运动,得出该方法是可行的,所设计的程序具有可靠性的结论。     

Development of an energy-based approach for optimized frequency selection for fatigue testing on polymers – Exemplified on polyamide 6

Polymers and composite materials show temperature-dependent material properties. Therefore, the frequency resembles a critical part in fatigue testing, due to its influence on the self-heating of the polymeric material and thereby on the number of cycles to failure. The aim of this paper is the development of a testing method, which allows comparable results with varying frequencies. To minimize the self-heating effect on the fatigue behavior, a model was established for selecting optimized frequencies regarding the load-specific temperature increase of the specimen. A new energy-parameter, the induced energy-rate, was introduced and correlated to the load-specific increase in temperature in multiple and constant amplitude tests at ambient conditions. With this approach, it was possible to determine a threshold value for the newly defined induced energy-rate. A stress-specific model was developed and a limit frequency was calculated. The results were verified in multiple and constant amplitude tests and S/N-curves.     

Frequency estimation of sinusiode from wideband using sub-Nyquist sampling

A novel frequency estimation algorithm for wideband signal with sub-Nyquist sampling is proposed in this paper. With the aid of information provided by the auxiliary delayed sampling channel and the aliased frequency estimation for wideband signal with sub-Nyquist sampling, the frequency aliasing due to sub-Nyquist sampling can be solved. This method can reduce the complexity of the overall hardware at the cost of an auxiliary sampling channel. Furthermore, in order to alleviate the computation burden for its practicability, a more simplified algorithm is put forward and its validity is proved by our numerical simulation results. The Cramer-Rao Lower Bound （CRLB） of the frequency estimation is also derived at the end of this paper.     

Investigation of uplink radio resource management schemes for multi-services in TDD-CDMA systems employing smart antennas

In this paper, a theoretical analysis of Time Division Duplex-Code Division Multiple Access （TDD-CDMA） uplink capacity constraint is presented when employing the smart antenna techniques. The evaluation formulations of capacity and load for multi-services are proposed. In order to maximize the throughput, the objective of optimization is proposed, and an advanced uplink resource management algorithm is developed. The proposed algorithm based on the least interference admission control scheme focuses on the maximum throughput for the circuit switched multi-services. The simulation results show that the proposed strategy has a significant improvement in throughput when the optimum admission control threshold is set.     

An efficient radio resource management strategy for adaptive OFDM cellular systems

This paper presents an efficient Radio Resource Management （RRM） strategy for adaptive Orthogonal Frequency Division Multiplexing （OFDM） cellular systems. In the proposed strategy, only those users who have the same distance from their base stations can reuse a same subcarrier. This can guarantee the received Carrier-to-Interference ratio （C/I） of each subcarrier to be acceptable as required by system planning. Then by employing different modulation scheme on each subcarrier according to its received C/I, system spectral efficiency can be gracefully increased. Analytical and simulation results show that the spectral efficiency is improved by 40% without sacrificing the Bit Error Rate （BER） performance and call blocking probability and system capacity of the proposed strategy is better than conventional systems.     

卫星通信终端通用测试平台高速接口设计

卫星通信系统向多频段多体制发展的趋势对卫星通信终端测试平台的通用性提出了更高的要求,基于通用处理器的软件无线电(GPP-SDR)技术可用于解决该问题。但目前GPP-SDR处理器和射频前端之间的高速数据传输仍是主要的技术瓶颈。本文针对卫星通信终端通用测试平台需求,提出了基于中断机制的PCI-e高速传输方法和流程设计,并通过移植Xenomai操作系统对高速接口传输的实时性进行优化;设计了一系列的测试实验对所设计接口的实际传输速率和中断丢失概率等指标进行测试。实验结果验证了所提方案具备高速率和低时延的传输特性,能够很好地满足当前卫星通信终端通用测试需求。     

Hydrodynamics of a flexible cylinder under modulated vortex-induced vibrations

Both amplitude modulation and frequency modulation of Vortex-induced Vibration (VIV) are observed in a recent model test of a flexible cylinder under oscillatory flow, but its hydrodynamics has not yet been broached in detail. This paper employs the Forgetting Factor Least Squares (FF-LS) method for identification of time-varying hydrodynamics of a flexible cylinder under modulated VIV. The FF-LS method’s applicability to accurately identify time-varying hydrodynamic coefficients is demonstrated through an elastically mounted rigid cylinder under flow with a given modulated motion. Furthermore, we propose a framework to predict instantaneous amplitude (envelope) and frequency using time-varying hydrodynamic coefficients to establish their analytical relationship. This prediction method is further extended to a highly tensioned flexible cylinder through Fourier series expansion in the spatial domain. By performing the identification procedure for all sampled data of a flexible cylinder undergoing oscillatory flow, we obtain the corresponding time-varying hydrodynamics in the cross-flow direction considering the amplitude and frequency modulation. The results show that, under modulated VIV, hydrodynamic coefficients of the flexible cylinder also show time-varying characteristics. We further investigate differences between identified hydrodynamic coefficients and those obtained from the database of a cylinder with modulated motion under flow. Prediction results using these identified time-varying coefficients reveal that the time-varying excitation coefficients mainly influence the amplitude modulation, and the time-varying added-mass coefficients contain the major information of frequency modulation. These results further suggest including the temporal derivative of the instantaneous amplitude as one determining parameter in building databases to improve the prediction of modulated VIV.     

Capturing the experimental behaviour of a point-absorber WEC by simplified numerical models

The paper presents a wave basin experiment of a direct-driven point-absorber wave energy converter moving in six degrees of freedom. The goal of the work is to study the dynamics and energy absorption of the wave energy converter, and to verify under which conditions numerical models restricted to heave can capture the behaviour of a point-absorber moving in six degrees of freedom. Several regular and irregular long-crested waves and different damping values of the power take-off system have been tested. We collected data in terms of power output, device motion in six degrees of freedom and wave elevation at different points of the wave basin. A single-body numerical model in the frequency domain and a two-body model in the time domain are used in the study. Motion instabilities due to parametric resonance observed during the experiments are discussed and analysis of the buoy motion in terms of the Mathieu instability is also presented. Our results show that the simplified models can reproduce the body dynamics of the studied converter as long as the transverse non-linear instabilities are not excited, which typically is the case in irregular waves. The performance of the more complex time domain model is able to reproduce both the buoy and PTO dynamics, while the simpler frequency domain model can only reproduce the PTO dynamics for specific cases. Finally, we show that the two-body dynamics of the studied wave energy converter affects the power absorption significantly, and that common assumptions in the numerical models, such as stiff mooring line or that the float moves only in heave, may lead to incorrect predictions for certain sea states.