激光二极管抽运的GaAs被动Q开关Nd：YVO4激光器

利用固体可饱和吸收体砷化镓（GaAs）作为被动调Q元件，实现了激光二极管抽运平－凹腔掺钕钒酸钇（Nd:YVO4）激光调Q运转，详细测量了砷化镓被动调QNd:YVO4激光输出特性，获得脉宽15ns，重复频率470kHz，光束质量M^2=1.31的激光输出，调Q激光运转阈值为500mW，并数值求解了砷化镓被动调Q速率方程，讨论了被动调Q机理以及调Q脉冲宽度和脉冲重复频率对抽运速率的依赖关系，理论计算结果与实验结果相一致。     

10-GHz Optical Comb in L-Band Region With Brillouin/Erbium-Doped Fibre Laser

A multiwavelength Brillouin/erbium fibre laser (BEFL) which operates in the long wavelength (L-band) region is demonstrated for potential applications in an L-band wavelength division multiplexing (WDM) communication system. The laser configuration consists of a long erbium-doped fibre to enable L-band amplification where two 3-dB couplers take a portion of the generated BEFL signal and re-inject it into the single mode fibre to seed a cascaded BEFL line in the same direction as the first BEFL line. A stable and strong laser comb of up to five lines with 10-GHz spacing has been obtained with a Brillouin pump (BP) of 9.2 mW and a 980 nm pump of 92 mW. The BEFL has shown a broad tuning range with a tuning characteristic for line #1 which is flat over a range greater than 9.9 nm.     

后退火温度对溅射沉积Pb(Zr0.52Ti0.48)O3铁电薄膜结构和性能的影响

在具有Ti缓冲层的Pt(111)底电极上,用射频溅射工艺在较低的衬底温度(370℃)和纯Ar气氛中沉积Pb(Zr0.52Ti0.48)O3(PZT)薄膜,沉积过程中基片架作15°摇摆以提高膜厚的均匀性。然后将样品在大气中进行5min快速热退火处理,退火温度550-680℃。用XRD、SEM分析薄膜的微结构,RT66A标准铁电测试系统测量样品的铁电和介电性能。结果表明,所沉积的Pt为(111)取向,仅当后退火温度高于580℃,沉积在Pt(111)上的PZT薄膜才能形成钙钛矿结构的铁电相,退火温度在580-600℃时结晶为(110)择优取向,退火温度高于600℃时结晶为(111)择优取向。PZT薄膜的极化强度随退火温度的升高而增加,但退火温度超过650℃时漏电流急剧上升,因此退火处理的温度对PZT薄膜的结构和性能有决定性的影响。     

The solution of the neutron transport equation in a slab with anisotropic scattering

The neutron transport equation for a slab geometry with the extremely anisotropic scattering kernel is considered. The albedo and transmission factors are calculated using the variation method. The effect of the extremely anisotropic parameter on the variation of the slab albedo and transmission factor is calculated. The obtained results are compared with the published data.     

Precise measurement of hyperfine structure in the state of Rb

We demonstrate a technique to measure hyperfine structure using a frequency-stabilized diode laser and an acousto-optic modulator locked to the frequency difference between two hyperfine peaks. We use this technique to measure hyperfine intervals in the 5 P _3/2 state of ⁸⁵Rb and obtain a precision of 20 kHz. We extract values for the magnetic-dipole coupling constant A = 25.038(5) MHz and the electric-quadrupole coupling constant B = 26.011(22) MHz. These values are a significant improvement over previous results. Received 6 March 2003 Published online 15 April 2003     

多棒串接固体激光器谐振腔的研究

运用矩阵光学的方法对多棒串接固体激光器的谐振腔参数及其在平平腔时的热稳条件进行了研究，并计算了六棒串接平平腔固体激光器的稳定区.结果证明：多棒串接固体激光器的稳定区和非稳区相互间隔，在平平腔总腔长、激光棒数量n和棒间距L一定的条件下，当采用对称结构时(L₁=L₂)，则谐振腔的每段稳定区均达到最大；且只要 平平腔满足L₁=L₂=L/2以及热焦距f在大于某个下限值f_m时，稳定性条件01< 关键词： 多棒串接固体激光器 稳定区 热稳条件     

射频激励扩散型冷却阵列波导CO2激光器技术

本文介绍了目前国内外研究者们提出的各种射频激励相干阵列波导ＣＯ２激光器技术，讨论了射频激励相干阵列波导ＣＯ２激光器技术的一个研究方向。     

类锂铝复合机制产生X光激光的等离子体状态

本文从速率方程出发,讨论了类锂铝复合等离子体的激发态结构,衰减常数,反转率和小信号增益等表征介质增益特性的物理量以及它们随电子温度,电子密度和光子逃逸几率的变化。找到了进行类锂铝离子通过复合机制产生X光激光设计应创造的等离子体状态目标区域。还讨论了这些物理量随原子序数变化的定标律。     

准分子激光泵浦的皮秒染料激光器

利用准分子激光泵浦猝灭式染料激光器，获得了３０ｐｓ的可调谐染料激光脉冲输出。     

人造参考星系统设计

简述了人造参考星系统，并用该系统作为大型望远镜主动光学和自适应光学的Ｓｈａｃｋ－Ｈａｒｔｍａｎ波面探测系统的光源。