STRUCTURES OF CIRCULANT INVERSE M-MATRICES

In this paper, we present a useful result on the structures of circulant inverse Mmatrices. It is shown that if the n × n nonnegative circulant matrix A = Circ[c0, c1,… , c（n- 1）] is not a positive matrix and not equal to c0I, then A is an inverse M-matrix if and only if there exists a positive integer k, which is a proper factor of n, such that cjk 〉 0 for j=0,1…, [n-k/k], the other ci are zero and Circ[co, ck,… , c（n-k）] is an inverse M-matrix. The result is then extended to the so-called generalized circulant inverse M-matrices.     

Functional neuroimaging of inner fields-of-view with 2D-selective RF excitations

Echo-planar imaging is widely used in functional neuroimaging but suffers from its pronounced sensitivity to field inhomogeneities that cause geometric distortions and image blurring which both limit the effective in-plane resolution achievable. In this work, it is shown how inner-field-of-view techniques based on 2D-selective RF excitations (2DRF) can be applied to reduce the field-of-view in the phase-encoding direction without aliasing and increase the in-plane resolution accordingly. Free-induction-decay (FID) EPI and echo-train-shifted (T2*-weighted) and standard (T2-weighted) spin-echo (SE) EPI with in-plane resolutions of up to 0.5×1.0 mm² (slice thickness 5 mm) were acquired at 3 T. Unwanted signal contributions of 2DRF side excitations were shifted out of the object (FID-EPI) or of the refocusing plane by tilting the excitation plane (SE-EPI). Brain activation in healthy volunteers was investigated with checkerboard and finger-tapping block-design paradigms. Brain activation could be detected with all sequences and contrasts, most reliably with FID-EPI due to its higher signal amplitude and the longer 2DRF excitation that are more sensitive to magnetic field inhomogeneities. In conclusion, inner-FOV EPI based on 2DRF excitations could help to improve the spatial resolution of fMRI of focal target regions, e.g. for applications in the spinal cord.     

过模慢波结构频率反射特性及谐振腔的影响

利用有限元方法求解:S-参数矩阵,研究了过模慢波结构对圆波导TM01,TM02模的反射特性,分析了在慢波结构末端加入谐振腔后,由于两端口的不对称性而造成的对反射特性影响。结果表明,在TM01的π模频率附近,慢波结构和谐振腔组成的系统对无谐振腔一侧端口入射TM01模的反射增大,而对有谐振腔一侧端口入射TM01模的反射减小。根据计算结果,解释了普通多波切伦柯夫振荡器所用慢波结构周期数较多的原因,说明了在多波切伦柯夫振荡器中引入谐振腔后,不但可以减少所用慢波结构周期数,而且有利于提高微波输出效率。     

The Determination of Trace Elements by Flame Atomic Absorption Spectrometry: Effect of the Composition of Standard Solution Matrices

Abstract

The effect of using solution matrices in calibration standards different from those employed for the extraction steps in the determination of Cd, Cr, Cu, Ni and Zn were tested. Cu and Zn are little affected by matrix effects but, if the extractant is ammonium acetate, the use of other matrices may result in too high Cd, Cr and Ni values.     

Field Study on Mobility and Persistence of Linuron and Monolinuron in Agricultural Soil

Abstract

A field site equipped with suction cup lysimeters was installed at Treviglio (BG) to assess the migration capacity of the herbicides linuron and monolinuron from topsoil to groundwater and to verify the appearance of their relevant transformation products in soil and water samples. A constant hydraulic head was applied in order to develop water saturation conditions in the upper layers. KCl was used as a tracer to evaluate water infiltration velocity through the vertical soil profile. The constant hydraulic head accelerated infiltration rates, while herbicide concentrations reached maximum contamination because soil adsorption capacity was underdeveloped. The results indicated two main processes of pesticide transport: firstly transport due mainly to water infiltration through macropores; secondly the transport driven by matrix flow. Linuron was found to be the most mobile herbicide, while chloroanilines were found to be the major transformation products of the herbicides considered.     

Zur Anreicherung der stabilen Isotope des Schwefels durch Fest-Flüissig-Austausch unter Verwendung von Ionenaustauschern

An verschiedenen Systemen chemischer Verbindungen wurden Versuche zur Anreicherung des stabilen Isotopes ³⁴S unter Verwendung der Ionenaustauscher Wofatit L 150, SBW und SBK nach den Methoden der Frontalchromatographie und der Bandenverdrāngungschromatographie ausgeführt. Beim Isotopenaustauschsystem Hydrogensulfit (am Ionenaustauscher)/Schwefeldioxid (in wäβriger Lösung) wurden Verfahrensweise und Betriebsparameter hinsichtlich des Anreicherungsgrades optimiert. Mit Hilfe einer einfachen Methode gelang es, aus den Versuchsergebnissen Werle für den elementaren Trennfaktor und die Trennstufenhöhe zu berechnen.     

Die Untersuchung einer Laboratoriumsanlage nach dem Heiß-Kalt-System mit einfachem Durchfluß der Fluide

Es wird ein Heiβ-Kalt-System mit einfachem Durchfluβ der Fluide untersucht. Dabei wird gezeigt, daβ zwischen den Isotopenkonzentrationen des Gases und der Flüssigkeit lineare Beziehungen bestehen. Eine Möglichkeit zur experimentellen Bestimmung der realen Werte der Parameter der Kolonne wird angegeben.     

Füllstandsmessung mit Streustrahlungssonden

Es wird die Abhängigkeit der Impulsdichte vom Füllstand bei Meßanordnungen mit γ-Streustrahlungssonden verschiedener Länge untersucht. Verwendet werden die Nuklide ⁶⁰Co und ¹³⁷Cs. Ein nahezu linearer Anstieg der Impulsdichte mit dem Füllstand wird bei Füllgütern kleiner Ordnungszahl nur bei Sondenlängen L ≥ μ₀ ^?1.erzielt. Der Einfluß des Schüttwinkels und der Dichte des Füllgutes wird diskutiert.     

Poly(phenylene oxide) copolymer anion exchange membranes

Poly(phenylene oxide) block and random copolymers are synthesized by oxidative polymerization of 2,6-dimethylphenol and 2,6-diphenylphenol for potential alkaline exchange membrane application. The copolymers are functionalized on the methyl substituted repeat units through a two-step process to produce pendent quaternary ammonium cationic groups. The amount of quaternary ammonium cations and the ion exchange capacity are quantified through titration measurements. Ionic conductivity of the copolymer membranes is measured by electrochemical impedance spectroscopy. Block copolymers show increased bromide conductivity at higher ion exchange capacities compared with the random copolymer analogs. The bromide conductivity for a block copolymer film with an ion exchange capacity of 1.27 mequiv/g reaches 26 mS/cm at 90 °C and 95% relative humidity. The hydroxide conductivity for the same film was measured to be 84 mS/cm at 80 °C and 95% relative humidity. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2013, 51, 1770–1778, 2013     

Flexible active matrix addressed displays manufactured by printing and coating techniques

A flexible electrochromic active matrix addressed display, including 8 × 8 pixels, is demonstrated by using solution processing based on standard printing and coating manufacturing techniques. Each organic electrochromic display (OECD) pixel and its corresponding organic electrochemical transistor (OECT) are located on different sides of the flexible PET substrate. Electronic vias generated through the plastic substrate connects each OECD pixel with one addressing OECT. When comparing this display with actively addressed OECDs with all its components located on the same side, the present approach based on this electronic via substrate provides an enhanced pixel resolution and a relatively more simplified manufacturing process. © 2012 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys, 2012