Prefiltration technique via aggregation for constructing low‐density high‐quality factorized sparse approximate inverse preconditionings

This paper considers a new approach to a priori sparsification of the sparsity pattern of the factorized approximate inverses (FSAI) preconditioner using the so‐called vector aggregation technique. The suggested approach consists in construction of the FSAI preconditioner to the aggregated matrix with a prescribed sparsity pattern. Then small entries of the computed ‘aggregated’ FSAI preconditioning matrix are dropped, and the resulting pointwise sparsity pattern is used to construct the low‐density block sparsity pattern of the FSAI preconditioning matrix to the original matrix. This approach allows to minimize (sometimes significantly) the construction costs of low‐density high‐quality FSAI preconditioners. Numerical results with sample matrices from structural mechanics and thin shell problems are presented. Copyright © 2002 John Wiley & Sons, Ltd.     

一种新的超分辨记录点的读出技术

提出一种新的超分辨记录点的读出技术—超分辨反射膜技术，详细分析了其原理。用该技术，以Sb为超分辨反射膜，SiN为介电层，在激光波长为632．8nm和光学头的数值也径为0．40的读出光学系统中实现了直径为380nm的超分辨记录点的读出。同时研究了Sb薄膜厚度对读出信噪比的影响规律，发现最佳的Sb薄膜厚度为28～30nm，所得的信噪比为38～40dB。     

An Area Optimization Method for Digital Filter Design

In this paper, we propose an efficient design method for area optimization in a digital filter. The conventional methods to reduce the number of adders in a filter have the problem of a long critical path delay caused by the deep logic depth of the filter due to adder sharing. Furthermore, there is such a disadvantage that they use the transposed direct form (TDF) filter which needs more registers than those of the direct form (DF) filter. In this paper, we present a hybrid structure of a TDF and DF based on the flattened coefficients method so that it can reduce the number of flip‐flops and full‐adders without additional critical path delay. We also propose a resource sharing method and sharing‐pattern searching algorithm to reduce the number of adders without deepening the logic depth. Simulation results show that the proposed structure can save the number of adders and registers by 22 and 26%, respectively, compared to the best one used in the past.     

First Harmonic (2f) Characterisation of Resonant Frequency and Q-Factor of Micromechanical Transducers

In this paper, the response to the first harmonic component (2f) of the electrostatic force in single terminal driven electrostatic comb-drive and parallel-plate drive was used as a signal to extract device parameters, namely, the Q-factor and resonant frequency instead of the fundamental (1f) resonance response. It is shown that the difficulty in motional measurement due to electrical cross-talk (parasitics) using 1f measurement can be overcome with a higher signal-to-noise ratio of the 2f signal. Both atmospheric (low-Q) and reduced pressure environment were investigated using off-chip electronics and lock-in amplifier. The measurements were done on the electrostatic comb-drive and capacitive parallel plate sensing plates that form the two core modules of a yaw rate sensor (dual-axis resonator). The effects of AC and DC bias voltages on the measured response have been investigated. Experimental amplitude and phase response data have been analysed using the Lorentzian curve-fit, Resonance Curve Area (RCA) method, the half-power bandwidth method (3 dB) and the Nyquist plot for data fitting and determination of the Q-factor and resonance frequency.     

微区电阻测试方法及新测试仪研制

文章对国内外开展微区薄层电阻测试的方法进行了综述，特别对改进范德堡四探针技术方法的测试原理、测试过程与测试结果进行了论述与分析，对微区电阻测试方法的进一步发展提出了一种可操作的方法，并研制出新型四探针测试样机。     

LDA抽运Nd:YLF再生放大器的实验研究

研制了一台激光二极管列阵(LDA)抽运的Nd:YLF再生放大器。再生放大器工作波长1053 nm，重复频率1 Hz，输出4 ns宽基横模TEM00激光脉冲的能量为2 mJ。总放大倍数达到了1×10 7，输出能量稳定性优于±4.7%(峰值)。给出了再生放大器的实验装置和有关实验结果。     

Chip-calorimeter for small samples

A method for measuring heat capacities of small samples using a chip-calorimeter and a heat pulse technique is described. The theoretical background to calculate the heat transport properties and the heat capacity of the sample from the pulse response function is given. Problems and potentials of the method are discussed. An example is given.     

On a question of Gross

Using the notion of weighted sharing of sets we prove two uniqueness theorems which improve the results proved by Fang and Qiu [H. Qiu, M. Fang, A unicity theorem for meromorphic functions, Bull. Malaysian Math. Sci. Soc. 25 (2002) 31-38], Lahiri and Banerjee [I. Lahiri, A. Banerjee, Uniqueness of meromorphic functions with deficient poles, Kyungpook Math. J. 44 (2004) 575-584] and Yi and Lin [H.X. Yi, W.C. Lin, Uniqueness theorems concerning a question of Gross, Proc. Japan Acad. Ser. A 80 (2004) 136-140] and thus provide an answer to the question of Gross [F. Gross, Factorization of meromorphic functions and some open problems, in: Proc. Conf. Univ. Kentucky, Lexington, KY, 1976, in: Lecture Notes in Math., vol. 599, Springer, Berlin, 1977, pp. 51-69], under a weaker hypothesis.     

电子直线加速器磁控管频率稳定的自适应线性神经元方法

 电子直线加速器电子束能量的稳定与否取决于功率源工作频率的稳定性,磁控管在短时间内的散谱和轻微跳谱造成稳频系统的控制精度下降,最后电子束的扫描均匀度下降。引入自适应线性神经元方法(ADALINE)和噪声对消技术以消除对工作频率长期稳定性的影响,从而保证了电子束的扫描均匀度。     

停流—荧光动力学分析法测定痕量钛的研究

利用自行组装的停流-荧光动力学分析仪,采用停流法汇合流体动力注入技术,研究了钛与3.5-二溴水杨基荧光酮的荧光增强动力学反应性质,讨论了流速、进样时间对方法灵敏度和精密度的影响,提出了一个快速、简便、精确测定钛的分析方法,并用于稀土样品及合成样品中痕量钛的测定.方法检测限为8×10~(-3)ppm,大多数元素的干扰均可用动力学方法消除.