一种低频 空间定向及高灵敏遥感方法研究

本文提出一种低频、空间定向及高灵敏的遥感方法。文中介绍了传感器及其二次仪表设计原理和关键技术。由作者研制的本检测系统,在空气中的定向接收灵敏度,离1米处高达120mV/μPa,比HP4905A型机的输出信噪比高8倍.     

Coupled channel description of O+Nd scattering around the Coulomb barrier using a complex microscopic potential

Angular distributions of elastic scattering and inelastic scattering from 2⁺₁ state are measured for ¹⁶O+^142,144,146Nd systems at several energies in the vicinity of the Coulomb barrier. The angular distributions are systematically analyzed in coupled channel framework. Renormalized double folded real optical and coupling potentials with DDM3Y interaction have been used in the calculation. Relevant nuclear densities needed to generate the potentials are derived from shell model wavefunctions. A truncated shell model calculation has been performed and the calculated energy levels are compared with the experimental ones. To simulate the absorption, a ‘hybrid’ approach is adopted. The contribution to the imaginary potential of couplings to the inelastic channels, other than the 2⁺₁ target excitation channel, is calculated in the Feshbach formalism. This calculated imaginary potential along with a short ranged volume Woods–Saxon potential to simulate the absorption in fusion channel reproduces the angular distributions for ¹⁶O+¹⁴⁶Nd quite well. But for ¹⁶O+^142,144Nd systems additional surface absorption is found to be necessary to fit the angular distribution data. The variations of this additional absorption term with incident energy and the mass of the target are explored.     

Ageing of wet-synthesized oxide powders

Wet chemical synthesis of precursor oxide ceramics is a method to obtain small particulate powders. Such powders are far more prone to ageing in air than more traditional precursors. Thermogravimetric analysis is used to highlight the species responsible for the ageing of ceramic precursors. Indeed water and carbon dioxide are observed to evolve from aged powders. Ceramics obtained from aged precursors can reach a very low final density with respect to the theoretical value. A large degree of the original sintering properties can be recovered after washing the aged powders with ethanol in a basic medium.     

500.8 nmNd∶YAG青光激光器光学薄膜的设计与制备

从双波长激光运转及和频的机理出发，对LD泵浦Nd∶YAG，LBO腔内和频500.8 nm〖JP2〗青光激光器所使用的光学薄膜进行了设计和制备.在激光反射镜的设计上，为了达到最佳的和频输出，对膜系要求进行了深入分析.采用对谐振腔一端面反射率固定不变并通过对另一腔镜基频光的透射率进行调谐的方法, 在给出合理初始结构后，利用计算机对膜厚进行了优化.并采用双离子束溅射沉积的方法，通过时间监控膜厚法成功制备出青光激光器所使用的全介质激光反射膜, 在室温下实现946 nm和1064 nm双波长连续运转，并通过Ⅰ类临界相位匹配LBO晶体腔内和频在国内首次实现500.8 nm青色激光连续输出.当泵浦注入功率为1.4 W时和频青光最大输出达20 mW.     

Nd∶NaR(WO_4)_2晶体生长(R=Bi,Y)

采用提拉法生长出了掺钕钨酸铋钠[Nd∶NaBi(WO4)2,简称Nd∶NBW]和掺钕钨酸钇钠[Nd∶NaY(WO4)2,简称Nd∶NYW]晶体,并给出了制备无开裂优质Nd∶NBW和Nd∶NYW晶体的最佳生长工艺参数。从XRD分析得到Nd∶NBW和Nd∶NYW晶体的晶胞参数,并分析了晶体的拉曼光谱,认为二者结构基本相同,为四方晶系、白钨矿结构、I41/a空间群。由吸收光谱可以看出,Nd∶NBW在802nm有较强的吸收峰,Nd∶NYW在804nm、752nm、586nm附近有较强、较宽的吸收峰,二者均适合于LD泵浦;计算了晶体中Nd3+的吸收截面积。     

Nd:LuVO_4晶体的拉曼光谱研究

采用不同的几何配置测量了Nd:LuVO4晶体的室温拉曼光谱,根据群论对称性分类计算了该晶体的红外和拉曼活性振动模并与实验结果做了比较,指认了测定的特征谱线。测量并分析了Nd:LuVO4晶体A1g全对称类的高温拉曼光谱,讨论了拉曼频移随温度变化的关系,认为晶体的热膨胀是引起拉曼频移变化的主要原因。     

掺钕钆镓石榴石激光陶瓷粉体的研究

优质的纳米前驱体是生成良好透明陶瓷的关键。采用Sol-gel法制得颗粒均匀、粒度小、无团聚、分散性好的Nd:GGG激光陶瓷前驱粉体。对透明陶瓷前驱体进行测试XRD分析,与标准JCPDS卡片对比表明样品属于立方晶系,空间群Ia3d,晶格常数为:A=123.7nm。粉体的最佳烧成温度为1000℃,煅烧时间8h。SEM观察发现,样品纯度高、单分散、颗粒均匀且近似球形,符合制备透明陶瓷的粉体要求。     

彩色透明微晶玻璃的吸收光谱

在Li2O-Al2O3-SiO2系统玻璃中掺入少量晶核剂TiO2,ZrO2,P2O5，再掺入稀土离子和过渡金属离子作为着色剂，在高温下溶制得到彩色透明玻璃，对上述玻璃进行微晶化处理，用差热分析（DTA）确定其晶化温度，测定与讨论了所获彩色透明微晶玻璃在紫外波段至近红外波段的吸收光谱特性，研究结果表明，玻璃微晶化后，由于基质玻璃对光的微弱散射，引起吸收的增强，但不改变稀土离子和过渡金属离子的本征吸收峰位。     

金刚石窗口冷却Yb3+∶YAG DPSSL设计

针对高功率二极管重复率抽运的V型非稳腔Yb3+∶YAG激光头，提出了利用金刚石窗口冷却和直接水冷相结合的复合冷却设计.在YAG片的抽运面进行直接水冷，同时在激光提取面利用金刚石窗口冷却介质.金刚石优异的导热性能不仅能够有效地冷却激光介质，还能消除横向的温度梯度，解决了高功率激光器冷却和高功率抽运的矛盾.模拟结果表明对掺杂10 at %厚度为1.6 mm的Yb3+∶YAG片在抽运功率密度为20 kW/cm2，重复频率为10 Hz的条件下，要将最高温度控制在可接受的范围内（比如320 K），周围冷却水的对流换热系数约为4000 W/m2K.     

The effect of microscopic features upon the transmissivity of enclosed laser ablated laminated metallised polymer films

A vacuum-deposited aluminium layer (20 nm) is sandwiched between two layers of laminated oriented polypropylene (OPP) film whose thickness varies from 20 to 40 μm. Selected areas of this sealed system were transparentised by the redistribution of the aluminium layer without breaking the seal or causing damage to the OPP film using a 75 W Q-switched Nd:YAG laser. The resultant transparentised films contain aluminium particles, distorted polymer areas and intact areas of the vacuum-coated aluminium layer. This paper investigates the effect of microscopic features upon the overall transmissivity of the laser-treated films and hence the quality of the transparentisation process.