WCDMA系统中SPT数字滤波器的一种设计方法

相对于传统的数字滤波器实现方法,符号的2次幂和(SPT)滤波器用移位寄存器替代乘法器,因而资源消耗少、速度快,更加适于专用集成电路(ASIC)设计.介绍了一种适用于宽带码分多址(WCDMA)前向信道中给定基带成形滤波器单位脉冲响应后设计SPT滤波器的方法.相对于传统的理想SPT系数优化方法,此方法更适于给定单位脉冲响应后SPT滤波器的设计,计算复杂度低;仿真结果显示,相对于更加简单的四舍五入方法,此算法在性能上又有可观的增益.     

基于频率采样技术的FIR数字滤波器优化设计

本文提出了一种FIR数字滤波器满意优化设计方法，将滤波器过渡带样本值作为优化变量，通过设计通带、过渡带和阻带性能指标满意度函数和综合满意度函数，构造出满意优化模型，并用本文提出的新量子遗传算法搜索满意解，FIR高通和带阻数字滤波器的设计结果表明，采用满意优化方法设计的FIR滤波器的性能优于传统方法。     

Experimental Research on Erbium-doped Superfluorescent Fiber Source

The effects of the variations in fiber length, fiber mirror reflectance on efficiency and output power are experimentally investigated for erbium-doped double pass backward superfluorescent fiber sources (SFSs). The influence of fiber length on mean wavelength stability (MWS) has also been demonstrated. By incorporating a short section of un-pumped erbium-doped fiber (EDF) at the output port, the pump power dependent on MWS becomes independent of pumped EDF length. This is a novel phenomenon that hasn‘t been reported up to now,and should be helpful to SFS fabrication and theory analysis. By using a fiber Michelson interferometer as spectrum slicing component,a multi-wavelength fiber source (MWFS) with ～20 channels (from 1542nm to 1559nm) is got. The MWFS has a channel spacing of ～0. 8 nm which satisfies ITUstandard. The intensity fluctuation among channels is less than 0.5dB,and the extinction ratio of all channels is above 14dB. This kind of MWFS should be useful to wavelength division multiplexing systems.     

用Tow-Thomas电路设计含有限非零传输零点有源滤波器的方法

Tow-Thomas电路是一种实现全极点滤波器的典型电路。本文给出了用Tow-Thoms电路设计含有限非零传输零点有源滤波器的方法，从而使Tow-Thomas电路可用于单片集成滤波器电路。而文中给出的公式可用于计算外接元件。设计实例表明了文中给出的计算公式的正确性。     

滤波器对偏振模色散的补偿

根据耦合非线性薛定谔方程 ,本文研究了偏振模色散如何影响各种码型的频谱 ,分析了滑频滤波器和固定滤波器对偏振模色散的补偿作用。研究结果表明 :偏振模色散对不同码型的频谱影响是不一样的 ,对色散管理孤子的频谱影响最大 ,产生新的频率分量也最多 ,而且每个新频率分量都较强 ,比入射频谱展宽许多 ;滑频滤波器和固定滤波器对偏振模色散都具有补偿作用 ,使最大可传输距离成倍增加 ,两种滤波器对偏振模色散的补偿作用相差较小 ;但是对色散管理孤子系统中的偏振模色散补偿效果最佳。     

Local adsorption sites and bondlength changes in Ni(1 0 0)/H/CO and Ni(1 0 0)/CO

The local adsorption geometry of CO adsorbed in different states on Ni(1 0 0) and on Ni(1 0 0) precovered with atomic hydrogen has been determined by C 1s (and O 1s) scanned-energy mode photoelectron diffraction, using the photoelectron binding energy changes to characterise the different states. The results confirm previous spectroscopic assignments of local atop and bridge sites both with and without coadsorbed hydrogen. The measured Ni–C bondlengths for the Ni(1 0 0)/CO states show an increase of 0.16 ± 0.04 Å in going from atop to bridge sites, while comparison with similar results for Ni(1 1 1)/CO for threefold coordinated adsorption sites show a further lengthening of the bond by 0.05 ± 0.04 Å. These changes in the Ni–CO chemisorption bondlength with bond order (for approximately constant adsorption energy) are consistent with the standard Pauling rules. However, comparison of CO adsorbed in the atop geometry with and without coadsorbed hydrogen shows that the coadsorption increases the Ni–C bondlength by only 0.06 ± 0.04 Å, despite the decrease in adsorption energy of a factor of 2 or more. This result is also reproduced by density functional theory slab calculations. The results of both the experiments and the density functional theory calculations show that CO adsorption onto the Ni(1 0 0)/H surface is accompanied by significant structural modification; the low desorption energy may then be attributed to the energy cost of this restructuring rather than weak local bonding.     

介绍两种画中画插入播出器

介绍画中画插入播出器的工作原理及设计思想，并给出了实际的电原理图。     

自动线性跟踪Butterworth有源滤波器研究

滤波是通信、测试、数据采集和实时控制等领域至关重要的环节。通常的模拟滤波器，由于截止频率固定，在某些宽频率动态范围且有实时性要求的应用场合，往往达不到预期的滤波效果，有时甚至影响整个系统的正常运行。本文从有源滤波器的机理分析入手，提出了一种由单片机参与的滤波系统，它能自动跟踪输入信号频率，线性地选择合适的滤波器截止频率，弥补了原有滤波器的不足。     

Fluorination of diamond — C4F9I and CF3I photochemistry on diamond (100)

The radiation-induced decomposition of C₄F₉I and CF₃I overlayers at 119 K on diamond (100) surfaces has been shown to be an efficient route to fluorination of the diamond surface. X-ray photoelectron spectroscopy has been used for photoactivation as well as for studying the photodecomposition of the fluoroalkyl iodide molecules, the attachment of the photofragments to the diamond surface, and the thermal decomposition of the fluoroalkyl ligands. Measured chemical shifts agree well with ab initio calculations of both C 1s and F 1s binding energies. It is found that chemisorbed CF₃ groups on diamond (100) decompose by 300 K whereas C₄F₉ groups decompose over the range 300 to 700 K and this reactivity difference is rationalized on steric grounds. Both of these thermal decomposition processes produce surface C---F bonds on the diamond. The surface C---F species thermally decompose over a wide temperature range extending up to 1500 K. Hydrogen passivation of the diamond surface is ineffective in preventing free radical attack from the photodissociated products of the fluoroalkyl iodides; I atoms produced photolytically abstract H from surface C---H bonds to yield hydrogen iodide at 119 K allowing diamond fluorination. The attachment of chemisorbed F species to the diamond (100) surface causes band bending as the surface states are occupied as a result of chemisorption. This results in a shift to higher binding energy of the diamond-related C 1s levels present in the surface and subsurface regions which are sampled by XPS on the diamond. The use of photoactivation of fluoroalkyl iodides for the fluorination of diamond surfaces provides a convenient route compared to other methods involving the action of atomic F, molecular F₂, XeF₂ and F-containing plasmas.     

新型微波有源滤波器综合方法

本文给出了一种新颖的微波有源滤波器的拓扑结构及综合方法，并对有源滤波电路进行了计算机模拟，结果表明本文给出的微波有源滤波器电路具有优良的的窄带滤波特性，通带内正向增益大于１０ｄＢ，带外抑制大于３０ｄＢ。