基于分段信噪比加权的GPS定位方法

在基于GPS的飞行器定位中,GPS卫星的情况与地面不同,传统的GPS选星算法有局限性.为了实现飞行器快速、可靠的定位,提出了一种新的基于分段信噪比加权的GPS定位方法.实验表明,相对传统选星算法,本方法的定位稳定性更好、精度更高、计算时间较短,能够满足飞行器快速、可靠定位的要求.     

Füllstandsmessung mit Streustrahlungssonden

Es wird die Abhängigkeit der Impulsdichte vom Füllstand bei Meßanordnungen mit γ-Streustrahlungssonden verschiedener Länge untersucht. Verwendet werden die Nuklide ⁶⁰Co und ¹³⁷Cs. Ein nahezu linearer Anstieg der Impulsdichte mit dem Füllstand wird bei Füllgütern kleiner Ordnungszahl nur bei Sondenlängen L ≥ μ₀ ^?1.erzielt. Der Einfluß des Schüttwinkels und der Dichte des Füllgutes wird diskutiert.     

Probenchemische Methode zur Bestimmung von 15N an in Gesteinen fixiertem Stickstoff

Zur Klärung geologischer Prozesse werden in zunchmendem Maße die Isotopenvariationen des Stickstoffs herangezogen. Da der größte Teil des Stickstoffs der Gesteine in gebundener Form als Ammoniumstickstoff [1–6] vorliegt, kommt der Untersuchung der Isotopenvariationen desselben eine große Bedeutung zu.     

Über den Einfluß von Isotopieeffekten auf die Verbreitung der Isotope in der Natur

Die Isotopenzusammensetzung der chemischen Elemente in ihren natürlichen Vorkommen wird von kernphysikalischen Vorgängen, vom Einfall extraterrestrischer Materie und, namentlich bei den leichten Elementen (etwa bis zum Chlor), von kinetischen und thermodynamischen Isotopieeffekten beeinfluβt. Deshalb ist die Kenntnis der in der Natur wirkenden Isotopieeffekte eine entscheidende Voraussetzung für das Verständnis der Gesetzmäβigkeiten der Verbreitung der Isotope in der Natur und für die Anwendung dieser Gesetzmäβigkeiten als Mittel der geo- und kosmoswissenschaftlichen Forschung und der Umweltforschung [1].     

REACTION OF LITHIUM DERIVATIVE OF DIETHYL PHENYLMETHANE-PHOSPHONATE WITH KETONES

Abstract

The reaction of the lithium derivative of diethyl ester of phenylmethanephosphonic acid (1-Li) with alkanones, cycloalkanones, alkylaryl and diarylketones 2s-b is studied at -70°C in THF. The corresponding adducts-diethyl esters of l-phenyl-2,2-dialkyl(phenyl)-2-hydroxyethanephosphonic acids 3s-h are isolated, their yields being usually higher at short reaction time. The olefination of 3-Li as well as of 3 (both by thermolysis or in acidic media) proceeds in low degree, while in the case of 3-Na the yields of alkenes 4 are good. The relative configurations of 3b. 31 and 3g are determined by IR and NMR-spectra, as well as by their stereospecific olefination. “Threo”-stereoselectivity of the addition stage of the reaction of 1-Li with 2b, 21 and 2g is observed, the “threo”/“erythro” ratio remaining independent on the reaction time.     

A new method for the determination of the 34S/32S ratio of water-soluble sulphur in soil

A new method for the determination of the ³⁴S/³²S ratio of water-extractable sulphate in soil is described. Soils are extracted directly with deionized water, which is evaporated down. The remaining residue is then rehydrated and transferred to tin cups containing an adsorbent and mixed with an oxygen donor (V₂O₅). Samples are then analysed using a continuous flow isotope ratio mass spectrometer. The new method requires around 10?g soil per determination, compared to much larger amounts (up to kilograms) of soil required for the previous methods. Sample preparation and subsequent analysis is quick and efficient. The method is demonstrated using a number of soils collected from around the world to provide a range of determined δ³⁴S values. The δ³⁴S values of water-extractable sulphur were broadly similar to those of the soil total sulphur.     

Improve on/off ratio of organic heterojunction transistors by adopting single-sandwich configuration

Organic heterojunction transistors (OHJTs) based on 5,5′″-bis(naphtha-2-yl)-2,2′:5″,2′″-quaterthiophene (NaT₄)/copper-hexadecafluoro-phthalocyanine (F₁₆CuPc) heterojunction were fabricated in single-sandwich and sandwich configurations, respectively. All the devices operated in depletion-accumulation (normally-on) mode. High field-effect mobility of 0.35 cm²/Vs was obtained for all devices, which was higher than that, 0.20 cm²/Vs of the devices with NaT₄ as active layer. The on/off ratio of 1 × 10⁵ was obtained for OHJTs with single-sandwich configuration, which is three orders of magnitude higher than that of OHJTs with sandwich configuration. Compared with OHJTs with sandwich configuration, the higher on/off ratio was mainly determined by the lower off state current in OHJTs with single-sandwich configuration. In OHJTs with single-sandwich configuration, the well-type shield effect of the source and drain electrodes caused a very narrow empty region in F₁₆CuPc film, which is responsible for the lower off state current.     

A numerical investigation of the influence of the aspect ratio in three‐dimensional separated flows

The influence of aspect ratio in three‐dimensional, numerical experiments of separated flows is studied in the case of the backward‐facing step at Reynolds numbers 600, 800, and 950. The computational domain is designed as an actual laboratory experiment. The governing equations are the steady state, isothermal, and incompressible Navier–Stokes equations. The expansion ratio of the computational domain is 1:2. The aspect ratio varies from 1:10 to 1:40. The results of the computations focus on the spanwise variations of the length and the strength of the two eddies along the lower and upper wall. It is concluded that both numerical and laboratory experiments should be designed with an aspect ratio of at least 1:20, if only the accuracy of the position of the detachment and the re‐attachment points matters. If the accuracy of the shear‐stress distributions is also taken into account, then an aspect ratio of at least 1:30 should be chosen. Finally, if the magnitudes of the vortex centers are also considered, then only the aspect ratio of 1:40 qualifies for a realization of two‐dimensional flow conditions in the plane of symmetry. This is contrary to the common practice in the field, at least from the side of laboratory experiments, where an aspect ratio of 1:10 is still considered adequate for this purpose. Copyright © 2011 John Wiley & Sons, Ltd.     

SYNTHESIS AND PROPERTIES OF ANILING ANILING AND 0-AMINOBENZENESULFONIC ACID COPOLYMER*

Poly(aniline- co-o-aminobenzenesulfonic acid) (PAOABSA) as a water soluble conducting polymerwas synthesized by chemical polymerization. The productivity and the room-temperature conductivity of thecopolymer were measured as a function of the reaction conditions, such as reaction temperature, the ratio ofoxidant to monomer and the degree of sulfonation defined as the ratio of sulfur to nitrogen atoms(S/N). Themain results obtained are summarized as follows : (1) lower reaction temperature (at about 0℃) is favorablefor the enhancement of the room-temperature conductivity of the copolymer; (2) higher content of oxidant isunfavorable for increasing the room-temperature conductivity of the copolymer; (3) both productivity androom-temperature conductivity of the copolymer decrease with increase of the degree of sulfonation whichwas always lower than 0.5 even an excess of o-aminobenzenesulfonic acid was added, probably because thereactivity ratio of aniline (γ=2.99± 0.05) is much higher than that of o-aminobenzenesulfonic acid (γ_2 = 0.06±0.02) estimated by using Fineman-Ross method and least square method.     

平板电视机安全检测中垂直力试验的研究

电视机对应的安全标准GB8898/IEC60065中的第19.2条有“在任意一个伸出或凹进的水平表面上的任何一点,以能产生最大倾倒力矩的方式施加100N垂直向下的力,只要从该点到防滑表面的距离不超过75cm”的要求,经分析认为该试验不适用于平板电视机。与上述试验相关的CTL决议1082中用平板电视机作为图示样品并不适宜,该决议只是解释了最不利位置的问题。