Surface characterization of macroporous glycidyl methacrylate based copolymers by inverse gas chromatography

Two samples of macroporous crosslinked poly(glycidyl methacrylate-co-ethylene glycol dimethacrylate), PGME, with different porosity parameters were synthesized by suspension copolymerization and modified by ring-opening reaction of the pendant epoxy groups with ethylene diamine, EDA. Inverse gas chromatography at infinite dilution was used for the determination of adsorption properties of PGME, and copolymer modified with ethylene diamine, PGME-en. Thermodynamic parameters of adsorption, dispersive components of the surface free energies, and the acid/base constants for the copolymer samples were calculated. The calculated dispersive surface energy values, , for PGME and PGME-en are comparable with the literature data for nonconductive polymers.     

CH bond activation in the presence or absence of oxygen or nitrous oxide

The reaction of C₂H₆with lattice oxygen, O^2- (in the absence of gaseous oxygen), or “adsorbedℍ oxygen (in the presence of gaseous oxygen) over NiMoO₄ catalysts has been performed and compared to C₃H₈ activation. The results obtained indicate that adsorbed oxygen exhibits a higher reactivity to C₂H₆, while lattice oxygen is more reactive relative to C₃H₈. Kinetic studies of these two reactions in presence of molecular oxygen have indeed shown that the ethane oxidative dehydrogenation (ODH) is dependent on the oxygen partial pressure, whilst on the contrary propane ODH is not. In order to confirm the presence of “adsorbed” oxygen for ethane activation, ODH tests have been performed with N₂O. On increasing temperature, the O^- adsorbed species enhances the mild oxidation of ethane. The activation energy of ethane consumption E_C2H6, relative to propane (E_C3H8 = 133 kJ/mol) is 145 kJ/mol. A possible mechanism is proposed for the oxidative dehydrogenation of ethane. This revised version was published online in August 2006 with corrections to the Cover Date.     

Excess molar enthalpy of binary mixtures of hexane+ethyl benzene, <Emphasis Type="Italic">o</Emphasis>-xylene, <Emphasis Type="Italic">m</Emphasis>-xylene and <Emphasis Type="Italic">p</Emphasis>-xylene at 298.15 K

Summary This paper reports excess molar enthalpies of the binary systems hexane+ethyl benzene, hexane+o-xylene, hexane+m-xylene and hexane+p-xylene at 298.15 K and atmospheric pressure, over the whole composition range. The data was measured directly using a Calvet microcalorimeter. The excess magnitude was correlated to a Redlich-Kister type equation for each mixture. Also, we will discuss the results for the four mixtures studied here and by comparison with the same binary systems but containing propyl propanoate as first component. Finally, we will correlate our results with the Nitta-Chao and the three UNIFAC theoretical approximations.     

纤维素基磁性聚偕胺肟树脂的研究——循环吸溴中吸附与还原能力的变化

研究了酸式纤维素基磁性聚偕胺肟树脂（ＡＭＡＯ）在循环吸溴过程中吸附容量和还原能力的变化，发现原树脂的吸溴初速和溴的还原率比再生树脂高一倍以上，但第一次和第二次再生树脂的吸附速度和还原效率几乎相同，暗示着树脂吸溴后基本结构已发生了彻底的变化．树脂在循环使用时吸溴容量变化不大而溴的还原量却显著降低，表明ＡＭＡＯ作为吸溴剂有较高的实用价值．     

铑（Ⅲ）与2—（3,5—二氯—2—吡啶偶氮）—5—二甲氨基苯胺络合物的催化氢波

本文提出一种新的测定铑的催化氢波体系.先使Rh(Ⅲ)与3,5-diCl-PADMA在HAc-NaAc缓冲溶液中生成稳定的络合物,再以适量HclO_4将溶液酸化后进行极谱测定。利用正交试验法确定体系的最佳分析条件为:0.05 mol/L pH5.0的HAc-NaAc,1.6×10~(-5)mol/L3,5-diCl-PADMA,沸水浴加热15min.,4.4 mol/L HCIO4酸化。在此条件下的线性范围为1.9×10~(-11)～3.9×10~(-9)mol/L,检出限达5.8×10~(-12)mol/L。大量Cu(Ⅱ)、Ni(Ⅱ)、Fe(Ⅲ)及Co(Ⅱ)对体系的干扰可用EDTA消除。研究了催化波的性质,表明该波为Rh(Ⅲ)与3,5-diClPADMA络合物的催化氢波。     

Ce0.6Zr0.35Y0.05O2和Pr0.6Zr0.35Y0.05O2催化剂表面上CO氧化和18O-16O交换反应的研究

测定了在Ce0.6Zr0.4O2,Ce0.6Zr0.35Y0.05O2,Pr0.6Zr0.4O2和Pr0.6Zr0.35Y0.05O2 (分别表示为CZ,CYZ,PZ和PYZ)样品表面上的CO氧化反应和18O-16O 同位素交换反应.结果表明: 在CZ和PZ系列固熔中掺杂Y3 离子可以改善晶格氧的迁移速度;PZ和PZY的晶格氧比CZ 和CZY 的晶格氧具有更高的氧化反应活性.其原因是将Y3 掺杂到Ce0.6Zr0.4O2 或Pr0.6Zr0.4O2晶格中,增加了样品的氧空位浓度,从而提高了晶格氧的迁移性质,而PrOx比CeO2具有更低温度的氧化还原性质,因此PZ和PZY的晶格氧比CZ 和CZY 的晶格氧具有更高的氧化反应活性.     

K-Mo基催化剂的表面酸性与其合成醇选择性

对500℃和800℃焙烧制得的氧化态K－MoO3／γ－AlO3，K－MoO3／SiO2及非负载K－Mo催化剂进行硫化后，测试其合成醇活性．结果表明500℃焙烧制得的负载型催化剂显示较高的合成低碳烃活性和较低的合成低磷醇选择性，经800℃焙烧后，合成低磷醇的选择性大幅度提高．500℃焙烧的非负载K－Mo催化剂显示较高的合成醇选择性，经800℃焙烧后，促碳醇的选择性保持不变．用氨的吸附及TPD方法测定了各样品的酸性，并与催化剂活性对照，发现催化剂酸性越强，酸量越大，则其合成醇选择性越低．催化剂上的乙醇分解实验证实，催化剂的酸量大小与它的醇分解活性成正变关系，这些结果说明催化剂酸性对其合成醇性能有直接的影响．     

Improved quantification limits in chiral capillary electrochromatography by peak compression effects

The peak compression effect has been applied to improve quantification limits in chiral capillary electrochromatography (CEC). A stationary phase based on the chiral selector vancomycin (Chirobiotic V) was used for separations of the enantiomers of mianserin. By adding solvents with a low dielectric constant, e.g. 2-propanol or tetrahydrofuran, to the sample solution, peak compression could be induced. The plate numbers for the minor enantiomer increased from approximately 100,000 to 1.4-1.6 million plates/m, when the composition of the mobile phase was adjusted so that the analyte eluted within either one of two system zones originating from the sample solution. A 10-fold improvement in the quantification limit for the minor enantiomer was obtained compared to elution under non-focused conditions.     

基于课程标准的教学——以常见阴、阳离子的检验为例

以常见的阴、阳离子的检验为例，研究了如何实施基于标准的教学。校本教材的开发为标准、教材、教学、评价的一致性提供保障；以学生应知的和能做的驱动课堂活动；根据达成标准应有怎样的质量表现，试卷编制先于教学设计。课堂上，“教”“学”双方都明确学习目标，教师提供多种策略来满足学生多样的学习需要，如提供工具，搭建脚手架，并以“微”研究性学习的方式展开教学，给学生提供了充分的进步空间。     

雪崩光电探测器的击穿效应模型分析

基于CMOS工艺制备了空穴触发的Si基雪崩探测器(APD),基于不同工作温度下器件的击穿特性,建立空穴触发的雪崩器件的击穿效应模型。根据雪崩击穿模型和击穿电压测试结果,拟合曲线得到击穿电场与温度的关系参数(dE/dT),器件在250～320 K区间内,击穿电压与温度是正温度系数,器件发生雪崩击穿为主,dV/dT=23.3 mV/K,其值是由倍增区宽度以及载流子碰撞电离系数决定的。在50～140 K工作温度下,击穿电压是负温度系数,器件发生隧道击穿,dV/dT=-58.2 mV/K,其值主要受雪崩区电场的空间延伸和峰值电场两方面因素的影响。