Radiative lifetimes in Ce I and Ce II

New radiative lifetime measurements based on time-resolved laser-induced fluorescence techniques are reported for 18 even-parity levels belonging to the 4f5d^26p and 4f ²5d ² configurations of Ce I and 6 even-parity levels belonging to the 5d^26s, 4f5d6p, and 4f6s6p configurations of Ce II. Free neutral and singly ionized cerium atoms were produced by laser ablation. The Ce I and Ce II levels range in energy from 26 545 to 29 102 cm^-1, and 42 573 to 48 152 cm^-1, respectively. Received 25 September 2002 Published online 4 March 2003     

Cu~+、Ag~+、Au~+与乙硫醇的气相化学反应

利用激光溅射 分子束的技术 ,结合反射飞行时间质谱计 ,研究了Cu+、Ag+、Au+与乙硫醇的气相化学反应。结果显示这三种金属离子与 (CH3 CH2 SH) n 反应形成一系列团簇离子M+(CH3 CH2 SH) n,且团簇离子尺寸不一样。Ag+、Au+与乙硫醇的反应还生成了 (CH3 CH2 SH) +n ,由此推测Cu+、Ag+、Au+与乙硫醇团簇的反应存在两种通道 ,一种通道是生成M+(CH3 CH2 SH) n,另一种是生成 (CH3 CH2 SH) +n 。Cu+、Au+与乙硫醇的反应还生成了M+(H2 S) (M =Cu、Au) ,但是实验中没有观察到Ag+(H2 S) ,理论计算表明Ag+(H2 S)很不稳定。另外 ,分析产物离子M+(CH3 CH2 SH) n 的强度发现 ,n =1～ 2之间存在明显的强度突变现象     

HI—V族化合物半导体的高能重离子辐照缺陷研究·

用正电子湮没寿命谱技术研究了2.4×1O15/cm2、2.2×1016/cm2注量的85MeV19F离子辐照N型GaP和1.6×1016/cm 2注量的85MeV19F离子辐照P型InP所产生的辐照缺陷.结果表明:两种注量辐照在GaP中均产生较高浓度的单空位.其浓度随着辐照注量的增大而增加;辐照也在InP中产生较高浓度的单空位.     

γ-辐照对纯Y_2SiO_5和Eu~(3+)∶Y_2SiO_5晶体光谱性能的影响

研究了γ-辐照前后纯Y2SiO5和Eu3+掺杂的Y2SiO5晶体吸收光谱的变化,辐照后,未退火和氢气退火的纯Y2SiO5晶体在260~270 nm和320 nm波段产生了附加吸收峰,分别是由F心和O-心的吸收引起的;经过空气退火的纯YSO晶体中,由于消除了氧空位,因此辐照后没有出现色心吸收峰。在Eu3+∶Y2SiO5晶体中,不但有相同的F心和O-心吸收峰,而且还有Eu2+离子在300 nm和390 nm的吸收峰。随着辐照剂量的增加,色心附加吸收峰增强。空气退火能减少Eu3+∶Y2SiO5晶体中的色心,而氢气退火能增加色心。     

Hybrid numerical—experimental approach for investigation of dynamics of microcantilever relay system

The time average holography measurements of the vibrating microelectromechanical switch (MEMS) were performed in this study. Experimental measurement results exhibit good agreement with computer generated holographic interferogram analysis. The validation of experimental investigations versus numerical analysis provides the necessary background to analyze the dynamical characteristics of micromechanical systems in virtual numerical environments. Direct application of fringe counting techniques for reconstruction of motion from time average holograms cannot be straightforward if the analyzed micromechanical systems contain motion limiters. Modifications of a classical time average holographic technique enable qualitative analysis of MEMS and can be applied for investigation of dynamical properties of much broader classes of MEMS systems.     

Spectral features of laser induced plasma from YBa2Cu3O7 and GdBa2Cu3O7 highT c superconductors

Laser induced plasma emission spectra from highT _c superconducting samples of YBa₂Cu₃O₇ and GdBa₂Cu₃O₇ obtained with 1.06μm radiation from a Q switched Nd:YAG laser beam has been analysed. The results clearly show the presence of diatomic oxides in addition to ionized species of the constituent metals in the plasma thus produced.     

放射性9C束流不同贯穿深度上的线能谱测量

为阐述放射性⁹C束流应用于治癌的物理基础, 运用一个球形生物组织等效正比计数器测量了⁹C束流不同贯穿深度上的线能谱, 得到了沿束流贯穿深度上的剂量平均线能分布. 将实验测量得到的线能谱转换成为不同传能线密度在吸收剂量中所占份额的分布, 得到了该⁹C束流在不同贯穿深度上的剂量平均传能线密度分布. 将生物组织等效正比计数器测量得到的与先前通过平行板正比计数器测量得到的该⁹C束流的剂量平均传能线密度分布进行比较, 发现: 在束流入射通道上, 两者测量数据符合很好, 而在束流Bragg峰附近⁹C离子的沉积区域, 由组织等效正比计数器测量得到的剂量平均传能线密度值大于由平行板正比计数器测量得到的值.     

Effects of aldehyde or dipyrromethane substituents on the reaction course leading to meso-substituted porphyrins

To better understand the effects of diverse substituents on reactions leading to porphyrins, pyrrole+aldehyde condensations and related reactions of dipyrromethanes were examined. The course of pyrrole+aldehyde condensations was investigated by monitoring the yield of porphyrin (by UV-Vis spectroscopy), reaction of aldehyde (by TLC), and changes in the composition of oligomers (by laser desorption mass spectrometry). Reaction reversibility was examined via exchange experiments. Reversibility of reactions leading to porphyrin was further probed with studies of dipyrromethanes. The reaction course was found to depend on the nature of the substituent and the acid catalyst. Alkyl or electron-donating substituents displayed levels of reversibility (exchange/scrambling) on par or greater than that of the phenyl substituent, whereas electron-withdrawing or sterically bulky substituents exhibited little to no reversibility. The results obtained provide insight into the electronic and steric effects of different substituents and should facilitate the design of synthetic plans for preparing porphyrinic macrocycles.     

Application of polymer-supported triphenyl phosphine in the palladium-catalyzed cyanation reaction under microwave conditions

A variety of aryl nitriles were prepared in excellent yields from the palladium acetate catalyzed coupling of aryl halides with Zn(CN)₂ using polymer-supported triphenyl phosphine as the ligand and dimethylformamide as solvent under microwave irradiation conditions.     

Studies of photooxidative degradation of poly(vinyl chloride)/poly(ethylene oxide) blends

The photooxidative degradation of blends (in a full range of compositions) of amorphous poly(vinyl chloride) (PVC) with semicrystalline poly(ethylene oxide) (PEO) in the form of thin films is investigated using absorption spectroscopy (UV–visible and Fourier transform infrared) and atomic force microscopy (AFM). The amount of insoluble gel formed as a result of photocrosslinking is estimated gravimetrically. It is found that the PVC/PEO blendsí susceptibility to photooxidative degradation differs from that pure of the components and depends on the blend composition and morphology. Photoreactions such as degradation and oxidation are accelerated whereas dehydrochlorination is retarded in blends. The photocrosslinking efficiency in PVC/PEO blends is higher than in PVC; moreover, PEO is also involved in this process. AFM images showing the lamellar structure of semicrystalline PEO in the blend lead to the conclusion that the presence of PVC does not disturb the crystallization process of PEO. The changes induced by UV irradiation allow the observation of more of the distinct PEO crystallites. This is probably caused by recrystallization of short, more mobile chains in degraded PEO or by partial removal of the less stable amorphous phase from the film surface. These results confirm previous information on the miscibility of PVC with PEO. The mechanism of the interactions between the components and the blend photodegradation are discussed. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 585–602, 2004