Whole-wafer fabrication process for three-terminal double stacked tunnel junctions

A new fabrication process for three-terminal superconducting devices consisting of two Josephson junctions in a stacked configuration is reported. The process is based on the deposition of the whole Nb/Al_xO_y/Nb-Al/Al_xO_y/Nb multilayer on a Si crystalline wafer without any vacuum breaking. Lift-off techniques, anodization processes and a SiO film deposition have been adopted for patterning and insulating the two tunnel stacked junctions. Devices have been characterized in terms of current-voltage (I-V) curves and Josephson critical current vs. the externally applied magnetic field. They show high quality factors (V _m values up to 65 mV at 4.2 K), and good current uniformity. Received 5 June 2001     

On investigation of high Tc superconductors with Electron Paramagnetic Resonance spectrometers

Following the discovery of high T_c superconductors, many researchers have applied EPR spectrometers to investigate their properties using the regular instructions to operate the spectrometer. As no substantial information was obtained it was soon practically abandoned. Investigations performed recently with the EPR technique, using a different operating method than the conventional one and the introduction of a detailed theoretical study related to the interaction of the JV with the microwave magnetic field lead to new and important results related to properties of high anisotropy superconductors indicating that the EPR spectrometer can be used to investigate properties of high anisotropy superconductors. The failures when using conventional operating method to obtain meaningful results and the method used in the present work to carry out the measurements in a proper manner are presented. Some important results obtained in investigating high anisotropy superconductors by the EPR technique are presented.     

超导体/正常金属/半导体/正常金属/超导体结的研究

在约瑟夫逊效应的理论研究中,大体上有微观和宏观两种方法。采用的是宏观的方法。利用推广的Ja-cobson方法,讨论了超导体/正常金属/半导体/正常金属/超导体结的约瑟夫逊效应,并在小电流假设下,推导出了该结的电流密度与位相之间的关系。     

Construction of Ka-Band Preselected Harmonic Mixer

In this paper, a new method to realize pre-selected harmonic mixer is introduced. It includes a harmonic mixer, and a YIG turning filter (YTF) design. A digital driver is used for YTF, which can realize linearization modification and temperature compensation. The spectrum analyzer's out scanning voltage is given an A/D conversion and interface to digital driver.     

Millimeter-Wave Lange Coupler Design and Its Application in the Monolithic Image Rejection Mixer Design

This paper reports on the design of a Ka-band monolithic Lange coupler and its application in the monolithic fourth-harmonic image rejection mixer. Detailed design and analysis using Ansoft-HFSS simulator have been carried out. The simulated results of the Lange Coupler show the insert loss is better than −3.64 dB; the amplitude balance is less than 0.55 dB and the phase balance is less than 0.65° from the 90° phase difference over the 30 to 40 GHz frequency range. The Lange Coupler is employed in a monolithic image rejection mixer that is fabricated by a commercial 0.18-μm pseudomorphic high electron-mobility transistor (pHEMT) process. The chip size is 1.4 mm × 1.9 mm. The image rejection ratio (IMR) is from 15 to 34 dB in the RF frequency range of 30 to 40 GHz.     

一个带阻尼项Josephson振动的半经典模型

在双势阱模型的基础上考虑了Josephson流与凝聚体的相互作用而引起的阻尼效应,得出相对粒子数Z(t)的表达式,并用一个简单的碰撞模型得出Josephson振动的振幅和能量及随时间呈指数衰减,以及凝聚体的质量越大,衰减越慢。     

Short-Time Decoherence of Solid-State Qubit at Optimal Operation Points

We investigate the short-time decoherence of a solid-state qubit under Ohmic noise at optimal operation points. The decoherence is analyzed by maximum norm of the deviation density operator. It is shown that at the temperature T = 3 mK, the loss of the fidelity due to decoherence is much smaller than the DiVincenzo low decoherence criterion, which means that the mode/may be an optimal candidate of qubit for quantum computation.     

混频器设计中的关键技术研究

混频器已经在诸多领域中得到了广泛的应用,其技术指标的好坏直接影响到整机性能的发挥。从混频器的基本概念出发,分析了混频器设计中的关键技术,如噪声系数、变频损耗、动态范围、隔离度、混频失真等对接收机性能的影响,并从工程角度出发,指出在工程设计中应注意的要点。本文所得结论在工程应用中得到了验证。     

Anomalies and proximity effect in high-T C tunnel junctions

Summary Some of the main anomalies in conductance characteristics of high-T _C tunnel junctions are considered. Mainly, the extreme, depression of gap structures, the presence of conductance peaks in corrispondence to the counterelectrode gap, and ?zero-bias anomalies? will be examined. The possibility of application of the proximity McMillan model to describe the behaviour in conductance of high-T _C junctions is considered. Discussion and preliminary comparison with experimental data on YBCO junctions are also reported.     

超导量子干涉器件

超导现象是一种宏观量子现象.磁通量子化和约瑟夫森效应是两个最能体现这种宏观量子特性的物理现象.超导量子干涉器件(superconducting quantum interference device,SQUID)是利用这两个特性而形成的超导器件.SQUID器件在磁信号灵敏探测方面具有广泛的应用.本文简要介绍低温超导和高温超导SQUID器件的相关背景和发展现状以及应用领域.