高功率激光驱动器中小尺度自聚焦和噪声模型

 建立了一套线性的近似分析方法，研究高功率激光驱动器中强激光传输的小尺度自聚焦效应和相位噪声对光束传输和光束质量的影响，给出了系统噪声强度、B积分值与光束近场调制对比度之间的定量关系。研究表明,为保证输出光束质量，即近场调制对比度小于给定值，系统内的噪声强度必须符合一定的谱分布。     

液相添加剂对PTCR陶瓷电性能的影响

液相添加剂ＡＳＴ（Ａｌ２Ｏ３＋ＳｉＯ２＋ＴｉＯ２）对ＢａＴｉＯ３陶瓷材料电性能的影响很大，随着Ａｌ２Ｏ３含量的增加，材料的电性能降低；ＳｉＯ２、ＴｉＯ２的物理特性对材料电性能影响较大；过量ＴｉＯ２对材料ＰＴＣ效应有重要影响，适当过量ＴｉＯ２含量，可得到性能优良的ＰＴＣＲ陶瓷。     

几何位相非线性变化的实验研究

本文报道了Pancharatnam位相非线性变化的实验研究，实验结果与理论预言符合得很好。Pancharatnam位相的这种非线性可能在光开关中得到应用。     

Reflection of Surface Plasmon Polaritons by a Corner Reflector of Negative Index Materials

A novel type of corner reflector for the reflection of surface plasmon polariton (SPP) is proposed. The reflector consists of two layers of compensatory media whose permittivity and permeability take opposite signs to that of the corresponding layer of the SP waveguide. By rigorously solving Maxwell's equations, the reflected SPP is proved to exist. The transverse wave vector of the reflected SPP is always antiparallel to that of the incident SPP and no phase retardation is introduced.     

Analysis method of the effect of fabrication errors on a planar waveguide demultiplexer

The impact of fabrication errors on a planar waveguide demultiplexer is analyzed based on an analytical method. The explicit expression of the transfer function taking into account phase and amplitude errors is presented in order to analyze the loss and crosstalk of the demultiplexer caused by fabrication errors. A basic requirement for the demultiplexer with a certain crosstalk criterion can be easily obtained. Using an etched diffraction grating demultiplexer as an example, it is shown that the analytical results have a good agreement with results from a numerical method.     

Glass transitions and mixed phases in block SBS

Differential scanning calorimetry (DSC) does not allow for easy determination of the glass‐transition temperature (T_g) of the polystyrene (PS) block in styrene–butadiene–styrene (SBS) block copolymers. Modulated DSC (MDSC), which deconvolutes the standard DSC signal into reversing and nonreversing signals, was used to determine the (T_g) of both the polybutadiene (PB) and PS blocks in SBS. The T_g of the PB block was sharp, at ?92 °C, but that for the PS blocks was extremely broad, from ?60 to 125 °C with a maximum at 68 °C because of blending with PB. PS blocks were found only to exist in a mixed PS–PB phase. This concurred with the results from dynamic mechanical analysis. Annealing did not allow for a segregation of the PS blocks into a pure phase, but allowed for the segregation of the mixed phase into two mixed phases, one that was PB‐rich and the other that was PS‐rich. It is concluded that three phases coexist in SBS: PB, PB‐rich, and PS‐rich phases. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 43: 276–279, 2005     

关于多线性振荡奇异积分在加权Hardy-型空间上的一致估计

本文对一类具有光滑位相函数的多线性振荡奇异积分算子建立了一致的加权（H^1(R^n),L^1(R^n))估计及一致的加权（HKp(R^n),Kp(R^n)估计。     

Thermomagnetic hysteresis and electrical transport in amorphous films

We report resistivity and magnetization measurements on an amorphous Ni₇₄Mn₂₄Pt₂ thin film in the temperature range of 3–300 K. Two significant features are apparent in both the magnetic susceptibility and electrical resistivity. A low-temperature (low-T) anomaly is observed at about 40 K, where a cusp appears in the resistivity, while a concomitant step-like increase in zero-field-cooled (ZFC) magnetization (M) appears with increasing temperature. The low-T anomaly is attributed to a crossover from a pure re-entrant spin-glass within individual domains to a mixed ferro-spin-glass regime at lower temperatures. By contrast, the high-temperature (high-T) anomaly, signaled by the appearance of hysteresis below 250 K, corresponds to the freezing of transverse spins in individual domains acting independently. Between the low-T and high-T anomalies a small but discernable magnetic hysteresis is observed for warming vs. cooling in the field-cooled (FC) case. This behavior clearly indicates the presence of domain structure in the sample, while the disappearance of this hysteresis at lower temperatures indicates the complete freezing of the spin orientation of these domains. According to these results, we have divided the magnetic state of this sample into three regions: at temperatures above 250 K, the sample behaves like a soft ferromagnet, exhibiting M vs. H loops with very small hysteresis (less than 5 Oe). As the temperature is lowered into the intermediate region (the range 40–250 K), spins become frozen randomly and progressively within the individual domains. These domains behave independently, rather than as a cooperative behavior of the sample. Weak irreversibility sets in, indicating the onset of transverse spin freezing within the domains. At temperatures below 40 K, the M vs. H loops exhibit larger hysteresis, for both the ZFC and FC cases, as in a pure spin-glass. We have also demonstrated giant noise in the resistivity at temperatures just below 250 K. Such noise can originate from fluctuations of the domains near the film surface because of competing effective bulk and surface anisotropy fields. The large observed amplitude may be explained by means of a large ferromagnetic anisotropy in the resistivity due to the large spin–orbit effect seen in NiMn systems. Finally, the low-T peak in the resistivity has been analyzed using Fisher and Langer's expression based on the Friedel Model proposed for critical transitions in transition metals (s–d systems). The fitted results are in satisfactory agreement with the predictions of this model.     

非晶硅薄膜的低温快速晶化及其结构分析

在镀铝的廉价玻璃衬底上高速沉积的非晶硅薄膜在不同的温度下退火10min.退火温度为500℃时,薄膜表面形成了硅铝的混合相,非晶硅薄膜开始呈现了晶化现象 退火温度为550℃时,大部分(约80%)的非晶硅晶化为多晶硅,平均晶粒尺寸为500nm 退火温度为600℃时,几乎所有的非晶硅都转化为多晶硅,其平均晶粒尺寸约为15μm.