Hepatobiliary excretion and brain distribution of caffeine in rats using microdialysis

To investigate the pharmacokinetic mechanism of hepatobiliary excretion and brain distribution of caffeine, this study uses a method based on microdialysis technique and liquid chromatography that allows continuous and concurrent in vivo monitoring of extracellular caffeine in the blood, brain and bile of anesthetized rats following the administration of caffeine (3 or 10 mg/kg, i.v.) through the femoral vein. Dialysates of the blood, brain and bile were directly injected onto the liquid chromatographic system and no further clean-up procedures were required. The study design consisted of two groups of six rats in parallel: the rats of the control group received caffeine (3 or 10 mg/kg, i.v.) alone and those of the cyclosporine treated-group were injected cyclosporine (10 mg/kg, i.v.) 10 min prior to caffeine administration (3 or 10 mg/kg, i.v.). The decline of caffeine in the blood, brain striatum and bile suggested that caffeine had rapid exchange and equilibration between the peripheral compartment and the central nervous system. In addition, the results indicated that caffeine underwent hepatobiliary excretion and was distributed into brain. When cyclosporine was co-administered, the pharmacokinetic parameters were not significantly altered. The results of this study reveal that the pharmacokinetic mechanism of hepatobiliary excretion and brain distribution of caffeine might not relate to P-glycoprotein.     

吡啶酮系偶氮类化合物可见吸收光谱的预测

利用密度泛函的B3LYP方法, 在6-311G*基组水平对吡啶酮系偶氮类化合物进行构型优化, 并进行了自然键轨道(NBO)分析, 然后用TDDFT方法和ZINDO/S方法分别计算了它们的可见吸收光谱, 结果均与实验值十分吻合. 通过对比发现, 对于最高吸收波长的计算, ZINDO/S能以较快的速度得到较好的结果. 在用ZINDO/S计算的过程中, 回归分析发现π-π重叠加权因子(OWF_π-π)与染料分子吡啶环上两个羰基氧原子平均电荷Z_O有较好的线性关系: OWF_π-π＝0.11425－1.04178ZO, 这一关系不仅可从量子化学的角度进行解释, 而且可用于同类染料可见吸收光谱的预测. 分子轨道的研究表明, 这些化合物的最高可见吸收波长主要对应着共轭体系中给电子体到受电子体的电子跃迁.     

The Effect of Nb Loading on Catalytic Properties of Ni/Ce0.75Zr0.25O2 Catalyst for Methane Partial Oxidation

In this study,the effect of Nb loading on the catalytic activity of Ce_(0.75)Zr_(0.25)O_2-supported Ni catalysts was studied for methane partial oxidation.The catalysts were characterized by BET,H_2 chemisorption,XRD,TPR,TEM and tested for methane partial oxidation to syngas in the temperature range of 400-800℃at atmospheric pressure.The results showed that the activity of methane partial oxidation on the catalysts was apparently dependent on Nb loading.It seemed that the addition of Nb lowered the catalytic activity for methane partial oxidation and increased the extent of carbon deposition. This might be due to the strong interaction between NiO and Nb-modified support and reduction of surface oxygen reducibility.     

Extraction-spectrophotometric determination of iron with 2-(2′-benzothiazolylazo)-4,6-dimethylphenol

An extraction-spectrophotometric method for the determination of trace amounts of iron based on its extraction into chloroform with 2-(2-benzothiazolylazo)-4,6-dimethylphenol (BTADMP) from a pH 6.5 medium has been developed. The extracted 12 FeBTADMP complex species allow the determination of 4–30gmg of iron (=3.92×10⁴1·mol^–1·cm^–1 at 790 nm). The method is highly selective and has been applied to the determination of iron in polymineral-polyvitamin pharmaceutical products.     

Methane polymerization with a hollow cathode: Influence of the cathode metal

Methane, mixed with argon, has been polymerized by means of a hollow-cathode discharge system. Two types of cathodes were studied; one was made of a solid solution of 81% tungsten and 19% platinum, while the other was of pure tungsten. Under identical operating conditions, a higher polymer yield was found in the case of the platinum cathode (90% against 70% for tungsten). The work function of the solid solution was estimated to be 6.3 eV, compared with 4.4 eV for tungsten. In terms of the data available, the thermionic current, which is the main source of energetic electrons, is about one order of magnitude lower for the solid solution cathode when compared with the tungsten cathode thermionic current. However, the polymer yield observed is higher in the former case. The concentration of the CH species in the hollow cathode was found to differ greatly for the cathodes tested and was about 5 times higher in the case of tungsten-platinum cathodes. Since no excited platinum vapor could be detected in the gas phase, the increase in CH concentration was attributed to a catalytic effect of the cathode inside surface. An evaluation of the plasma polymer deposition rate yields 70 nm·s^–1 for the platinum-tungsten type hollow cathode and 42 nm·s^–1 for the tungsten one. In both cases, the deposition rate is much higher than those obtained from the most widely used methods for plasma polymer deposition (0.10–1.0 nm·s^–1) implying methane-argon mixtures, and is comparable to the results obtained with a new type of plasma polymer deposition reactor described in the literature.     

Dipole moments ofα,ω-dibromoalkanes

Dipole moments for,-dibromoalkanes containing 10, 12, 14, 18, 20 and 24 carbon atoms were determined in benzene solution at 25.00±0.05 °C. The experimental values of the dipole moments were found to compare well with the theoretical values calculated from Hayman and Eliezer's theory.     

In-capillary micro solid-phase extraction and capillary electrophoresis separation of heterocyclic aromatic amines with nanospray mass spectrometric detection

A miniaturised technique to analyse and detect heterocyclic aromatic amines (HAs) using micro solid-phase extraction (SPE) coupled on-line (in-capillary) to capillary electrophoresis (CE) separation with nanospray (nESI) mass spectrometry (MS) detection has been developed. HAs are mutagenic and carcinogenic compounds formed at low levels in protein-rich food during cooking. Due to the low concentrations of HAs and the high complexity of the matrix in which they exist, sensitive and selective analytical methods are required for quantification. SPE was performed on a packed bed of C₁₈ particles inside the CE capillary, which minimised the dead volume. The on-line coupling of SPE, CE and nESI-MS reduced the time for extraction and identification to less than half an hour, which will allow for screening of several samples per day. The new technique provides short analysis time, low sample and solvent consumption, and HAs in standard solutions were easily detected at 12–17 fmol injections, and in spiked urine samples at 750–810 fmol injections.     

Crystal and Molecular Structure of (BzlMe3N) 2 + [Fe2OCl6]2-

The crystal and molecular structure of (BzlMe₃N) ₂ ⁺ [Fe₂OCl₆]^2- has been determined. The asymmetric unit contains two benzyltrimethylammonium cations and two half -oxo-bis(trichloro-iron(III)) anions. The bridging -oxygen atoms of these anions are located over crystallographic symmetry elements. Therefore, the two anions resulting from the symmetry operations correspond to two different conformers presenting angular and linear dispositions of the Fe-O-Fe bond angle. Mössbauer spectrum consists of two asymmetric lines that are adequately simulated by two equally populated quadrupole doublets associated with the two iron sites.     

Photophysical characterization of mixed micelles of n-butanol/SDS and n-hexanol/SDS. A study at low alcohol concentrations

 The effect of the addition of n-butanol (BuOH) and n-hexanol (HexOH) on the micellization of sodium dodecylsulfate (SDS) has been investigated using fluorescence quenching methods. The binding constants were calculated using an expression which relates the total concentration of alcohols and the micelle concentration. The values of K were 4.67 and 17.6 M^-1 for BuOH/SDS and HexOH/SDS, similar to values obtained by other methods. The cmc of SDS decreases on addition of alcohols and goes through a minimum for the BuOH/SDS system. Micellar aggregation numbers (N) were determined from linear plots of Ln (I ⁰/I) against [Quencher] at low alcohol concentrations. For 15 mM SDS, in the presence of BuOH the N values decrease on addition of alcohol up to 0.2 M. For HexOH, N can be assumed to be constant up to 4.8 mM, after which N decreases. The polarity of the micellar core containing alcohol was evaluated from the I ₁/I ₃ ratio of monomeric pyrene. The effect of addition of the alcohol causes a decrease in the I ₁/I ₃, which corresponds to a decrease in the polarity of the pyrene solubilization site. Received: 28 October 1996 Accepted: 10 January 1997