Fast Capillary Gas Chromatography: Comparison of Different Approaches

Savings in analysis time in capillary GC have always been an important issue for chromatographers since the introduction of capillary columns by Golay in 1958. In laboratories where gas chromatographic techniques are routinely applied as an analytical technique, every reduction of analysis time, without significant loss of resolution, can be translated into a higher sample throughput and hence reduce the laboratory operating costs. In this contribution, three different approaches for obtaining fast GC separations are investigated. First, a narrow-bore column is used under conventional GC operating conditions. Secondly, the same narrow-bore column is used under typical fast GC conditions. Here, a high oven temperature programming rate is used. The third approach uses a recent new development in GC instrumentation: Flash-2D-GC. Here the column is placed inside a metal tube, which is resistively heated. With this system, a temperature programming rate of 100°/s is possible. The results obtained with each of these three approaches are compared with results obtained on a column with conventional dimensions. This comparison takes retention times as well as plate numbers and resolution into consideration.     

Fourier interferometric stimulation (FIS) in biology and medicine

A continuously scanning Michelson interferometer was developed to modulate an intensive light source spectrally. The interferogram is used as a stimulus to investigate spectral sensitivities in insects and man. The FIS-method is fast and precise and shows many advantages which are partly based on the advantages of Fourier spectroscopy. The existing applications are summarized.     

水发食品中甲醛现场测定的样品快速前处理新方法研究

提出了一种用于现场测定水发食品中甲醛含量的样品快速前处理新方法,采用乙酸锌和亚铁氰化钾沉淀样品中的蛋白质和脂肪,在弱酸性介质和沸水浴条件下提取了样品中的甲醛,并与乙酰丙酮立即发生显色反应.研究了不同样品前处理方法对甲醛提取和测定的影响,探讨了水发食品中的甲醛本底值及其是否被人为添加甲醛的判断标准.此方法的特点是样品前处理与显色反应同时进行,在10min内即可完成对水发食品中甲醛含量的定量测定.     

Dephosphorylation of intact glycoprotein to greatly improve digestion efficiency coupled with matrix-assisted laser desorption/ionization–Fourier transform ion cyclotron resonance mass spectrometric analysis

Sialylation is essential for a variety of cellular functions. Herein, we used bovine fetuin with three potential N-linked glycosylation sites containing complex-type glycan structures, four potential O-linked glycosylation sites and six potential phosphorylation sites as a model compound to develop a highly-efficient digestion strategy for sialylated glycoproteins and efficient enrichment strategy for sialylated glycopeptides using titanium dioxide. The former according to the process of alkaline phosphatase digestion followed by tryptic digestion and then proteinase K digestion could greatly improve the enzymatic efficiency on fetuin, and the latter could obviously enhance the enrichment efficiency for multisialylated glycopeptides using phosphoric acid solution as elution buffer. The mass spectra of the enriched glycopeptides derived from fetuin reveal that several series of the ion clusters with mass difference of 291 Da correspond to the presence of multisialylated glycopeptides. In addition, the approach was applied to characterize the sialylated status of α2-macroglobulin and transferrin, respectively, from the sera of healthy subjects and sex- and age-matched patients with thyroid cancer, and their spectra indicate that the change in the amount of the glycoforms containing different number of sialic acid (SA) residues from one glycosylation site may be used to differentiate between healthy subjects and cancer cases.     

Characterization of lead and lead leaching properties of lead glazed ceramics from the Solis Valley, Mexico, using inductively coupled plasma-mass spectrometry (ICP-MS) and diffuse reflectance infrared Fourier transform spectroscopy (DRIFT)

Ingestion of relatively small amounts of lead is now recognized to cause significant neurological and cognitive effects in humans. Large quantities may be fatal, yet lead poisoning, especially of children, is still a major public health concern in many parts of the world. In rural Mexican communities lead oxide (PbO) is added to ceramic glaze as a fluxing agent, lowering starting firing temperatures to 500 °C. The purpose of this study is to characterize the lead chemical forms in ceramic glazes from the Solis Valley, Mexico, to investigate lead leaching properties of these ceramics, and to demonstrate the applicability of lead isotope signatures as a means of tracing lead source origins. Ceramics were collected from the rural village of Santa Maria de Canchesda, State of Mexico, Mexico. Dried liquid glazes, post-fired glaze material, and pure PbO were analyzed by diffuse reflectance infrared Fourier transform spectroscopy (DRIFT). Results from DRIFT analysis indicate that PbO (1429 cm⁻¹ band) is the active form of lead found in liquid glazes and ceramics. Some shifting of 1429 cm⁻¹ PbO peak to lower wavenumbers occurs in post-fired ceramics, and this may be due to the formation of lead bisilicate during firing. Ceramics samples were leached in 0.02 M citric acid solution for 1 min, and leached lead concentrations were measured using inductively coupled plasma-mass spectrometry (ICP-MS). Lead concentrations in these leachates varied from 0.4-80.4 μg ml⁻¹, while the control pottery from the US leached only 0.1 μg ml⁻¹ lead. Elemental distributions on glaze surfaces were identified by laser ablation (LA)-ICP-MS. Nitric acid extracts of soils, teeth, and ceramic glazes were analyzed for lead isotope ratios (²⁰⁷Pb/²⁰⁶Pb vs. ²⁰⁸Pb/²⁰⁶Pb) using ICP-MS. Similarities of tooth and ceramic lead isotope ratios indicate that ceramics may be a substantial source of body lead burden in the Solis Valley. This study demonstrates the applicability of lead isotope ratios for lead source identification, and it identifies potential health risks from ceramic use induced lead toxicity within the Solis Valley.     

Determination of the diffusion coefficient of water into atelocollagen type I thin films by attenuated total reflection Fourier transform infrared spectroscopy

 The diffusion coefficient of water into thin polymer layers of glutar aldehyde cross-linked atelocollagen type I matrix (sample 1, the typical layer thickness was about 0.065 × 10⁻³ m) at 23 °C was 1.142 × 10⁻¹⁰ m² s⁻¹. At twice the concentration of the cross-linking agent (sample 2) the diffusion coefficient was 2.795 × 10⁻¹⁰ m² s⁻¹. This increase was attributed to the more ordered morphology and the creation of ordered microvoids in the film. A larger surface area is then available for the transport of diffusing molecules, allowing a higher penetration rate of the solvent. Received: 11 January 2000/Accepted: 6 May 2000     

Fast GC for the analysis of fats and oils

Fast and conventional GC techniques were both applied to ten different lipidic matrices and the results then compared. The fats and oils were of fish, animal, and vegetable origin and were all simultaneously transesterified with acidic methanol before performing batch analysis of the fatty acid methyl esters (FAMEs) obtained. All FAMEs samples were consecutively analyzed three times by each method. The fast method significantly reduced the time required for analysis by a factor of 5 while maintaining a similar resolution. Furthermore, the reproducibility of relative quantitative data was measured on going from one method to the other. Peak identification was achieved through conventional GC‐MS in combination with linear retention index values contained in a home library and information derived from comprehensive 2D GC group patterns.     

In situ FTIR diagnostics of the radio-frequency plasma decomposition of N2O

The decomposition of N₂O in a 13.56-MHz parallel-plate system was studied usingin situ Fourier transform infrared (FTIR) spectroscopy. Areas of two infrared absorption bands of N₂O recorded at 8 cm^–1 resolution were used to estimate relative gas-phase dissociation as a function of rf power and flow rate at 500 mT. Flow rate was found to strongly affect band areas over the range of powers investigated (10–90 W). The effect of rf power on band areas diminished above 40 W, probably due to poor plasma confinement. Distortion of the band shapes by the plasma permitted rotational temperatures to be estimated. Rotational temperature increased essentially linearly with power at constant flow rate, reaching 450 K at 80 W, but was independent of flow rate at constant power. Rotational temperatures were also found to depend on the temperature of the electrodes, which were heated by plasma exposure. No infrared-active product species were observed even under batch conditions where all N₂O was irreversibly dissociated. This lack of detectable products and a 50% pressure rise observed in a batch study suggest that N₂ and O₂ are the primary stable discharge products.     

Fourier transform spectroscopy using image sensors

Multichannel Fourier transform spectrometers utilizing image sensing devices are reviewed along with the instrumental design concepts. Although the idea itself is fairly simple, a photographic plate in holographic spectroscopy is replaced by an image sensor, there are stringent requirements to be satisfied in order to realize the system for field use. Mainly two types of the instrument, which are characterized by the Sagnac common-path interferometer and the polarization interferometer optics, respectively, are described with regard to their system performances. Examples of the system operation introduced show that Fourier transform spectrometers without mechanical moving parts play an important role in a variety of spectroscopic applications under severe surroundings. In a summary, methods for the resolution enhancement and comments on the signal-to-noise ratio are also included.     

Unlocking Charge Transfer Limitations for Extreme Fast Charging of Li-Ion Batteries

Extreme fast charging (XFC) of high-energy Li-ion batteries is a key enabler of electrified transportation. While previous studies mainly focused on improving Li ion mass transport in electrodes and electrolytes, the limitations of charge transfer across electrode–electrolyte interfaces remain underexplored. Herein we unravel how charge transfer kinetics dictates the fast rechargeability of Li-ion cells. Li ion transfer across the cathode–electrolyte interface is found to be rate-limiting during XFC, but the charge transfer energy barrier at both the cathode and anode have to be reduced simultaneously to prevent Li plating, which is achieved through electrolyte engineering. By unlocking charge transfer limitations, 184 Wh kg⁻¹ pouch cells demonstrate stable XFC (10-min charge to 80 %) which is otherwise unachievable, and the lifetime of 245 Wh kg⁻¹ 21700 cells is quintupled during fast charging (25-min charge to 80 %).