Degradation of 4-Chlorophenol using a Gas–Liquid Gliding Arc Discharge Plasma Reactor

The gas–liquid gliding arc discharge plasma is used directly to study degradation and dechlorination of 4-Chlorophenol (4-CP) in solution. The typical AC waveforms of discharge voltage and current revealed that the discharge behavior was not definitely periodic. The chemical oxygen demand (COD) abatement of 4-CP solution with stainless steel electrode is higher than that with aluminum or brass electrode; When air was used as carrier gas the COD abated from 1,679.2 to 190 mg/L (i.e., 88.68% abatement) after 76 min plasma treatment; Increasing gas–liquid mixing rate could also increase the degradation of 4-CP; adding appropriate amounts of Fe²⁺ or iron chips to the solution were found to be favorable for 4-CP degradation. The main intermediates of 4-CP degradation are p-benzoquinone, hydroquinone, 4-chlorocatechol, p-chloronitrobenzene, and ring cleavage products (acetic acid, glycol, propanone, and others). Furthermore, possible pathways of 4-CP degradation in solution are proposed.     

Fluorescence monitoring of ultrasound degradation processes

Ultrasound-based water treatment is often applied for degradation of stable organic pollutants, such as polycyclic aromatic hydrocarbons and halogenated compounds. Monitoring the degradation process, during the application of ultrasound radiation, is of considerable economical interest. In this work, the possibility of performing on-line spectral analysis during sonication was examined and it was found that direct absorption or fluorescence readings are misleading. Optical monitoring is strongly affected by the absorption and scattering of light by cavitation micro-bubbles and ultrasound induced particulates. A model was developed to account for these effects and to allow for on-line fluorescence analysis. The model takes into account the absorption and scattering coefficients of the micro-bubbles and particulates, as well as their time dependent concentration. The model parameters are found from independent measurements where the pollutants are added to already sonicated pure water. Then, the model is tested for predicting the actual fluorescence behavior during the sonication process. It has been shown that the model allows for recovery of the true degradation data, as obtained by off-line HPLC measurements.     

Thermal degradation of polystyrene in the presence of hydrogen by catalyst in solution

For the first time, low temperature degradation (170-240 °C) of polystyrene in benzene is carried out in the presence of hydrogen using iron(III) oxide catalyst. The effect of temperature, catalyst loading and polymer loading on degradation are studied in hydrogen atmosphere. Degradation is also carried out at different initial hydrogen partial pressure. The time dependent molecular weight is calculated using viscosity average method. It is found that the degradation is enhanced considerably in the presence of hydrogen and followed random degradation chain scission. A random degradation kinetic model of Kelen [Kelen T. Polymer degradation. New York: Van Nostrand Reinhold Company; 1983.] is used to estimate the degradation rate constants. Empirical correlations are proposed to account for the effect of catalyst loading and initial hydrogen partial pressure on degradation. The true thermal degradation rate constants are calculated using these proposed correlations at given catalyst loading and initial hydrogen partial pressure with varying temperature. The frequency factor and activation energy are also determined using Arrhenius equation considering the true thermal degradation rate constants.     

Thermal oxidation of cellulose investigated by chemiluminescence. The effect of magnesium and calcium carbonates and of different pHs

Whatman cellulose impregnated with calcium and magnesium carbonates was oxidized and chemiluminescence accompanying this oxidation has been measured. It was shown that magnesium ions in deacidified cellulose pulp promote the light emission significantly. On the other hand, acid papers give the more pronounced light signals at temperatures close to ambient. The relation between chemiluminescence runs and paper degradation has been implicated, with an attempt to extrapolate half-lives of paper samples to conditions close to ambient. To cite this article: J. Rychlý et al., C. R. Chimie 9 (2006).     

In vitro ageing and degradation of PEG-PLA diblock copolymer-based nanoparticles

Diblock copolymers composed of poly(oxy-ethylene) (POE) and poly(dl-lactic acid) segments were synthesized by anionic polymerization of d,l-lactide using the oxyanion formed by reaction of the monohydroxyl monomethoxy-poly(ethylene glycol) on sodium hydride. For comparison, a similar copolymer was prepared by using tin octoate to catalyze the lactide polymerization. The copolymers were used to make nanoparticles, which were stored at 4 °C. After a few months under these storage conditions, a dramatic decrease of the poly(ethylene glycol) content was observed, however, the mean diameter of the nanoparticles was not affected. The degradation of the nanoparticles was investigated in vitro under conditions selected to mimic physiological conditions. Changes of characteristics were monitored by ¹H NMR, SEC, DLLS and CZE on nanoparticles and/or on the degradation by-products dissolved in the ageing medium. According to their nanometric dimensions, the microparticles degraded very slowly and there was no difference in behaviour between the sodium hydride and the stannous octoate-derived copolymers.     

Thermogravimetric analysis of PVC/ELNR blends

The thermal behaviour of a series of solution-cast blends of polyvinyl chloride/epoxidised liquid natural rubber (ELNR) of different mole percentage of epoxidation has been examined using thermogravimetric analysis. Thermal degradation is found to occur through a two-step route in which the first step corresponds to the dehydrochlorination of PVC to form a polyene and the second step is attributed to the decomposition of the ELNR and the polyene. Introduction of 20 and 50 mol% of epoxy group into the liquid NR is found to enhance the thermal stability of PVC. Probable mechanisms of degradation have been suggested on the basis of the kinetic analysis of the degradation studies. It is found that the mechanism is influenced by the epoxy content of the blend system. Activation energy for the degradation and the entropy change have also been reported.     

The state of conservation of painted surfaces in the presence of accelerated ageing processes monitored by use of FT-Raman spectroscopy and multivariate control charts

A new method has been developed for monitoring the degradation of paintings. Two inorganic pigments (ultramarine blue and red ochre) were blended with linseed oil and spread on canvas. Each canvas was subjected to simulated accelerated ageing in the presence of typical degradation agents (UV radiation and acidic solution). Periodically the painted surfaces were analysed by FT-Raman, to investigate the status of the surface. The data obtained were analysed by principal component analysis (PCA). Finally the Shewhart and cumulative sum control charts based on the relevant principal components (PC) and the so called scores monitoring and residuals tracking (SMART) charts were built. The method based on the use of PC to describe the process was found to enable identification of the presence of relevant modification occurring on the surface of the samples studied.Electronic supplementary material Supplementary material is available for this article at     

Stability of anthocyanins extracted from grape skins

Summary The extractability and stability of anthocyanins from the skins ofVitis vinifera were determined at different pH values. Anthocyanins were extracted using acetone, partitioned with chloroform and pre-purified by solid-phase extraction (SPE). They were analysed by RP-HPLC, and the kinetic parameters of decomposition were calculated. The total monomeric anthocyanin content was determined by spectrophotometry. Anthocianins were well separated by RP-HPLC. The efficiency of extraction depended strongly on the pH of the extracting agent and on the character of the pigment to be extracted. The amount of anthocyanins decreased with increasing duration of storage, more so at elevated temperatures. Presented at Balaton Symposium '01 on High-Performance Separation Methods Siófok, Hungary, September 2–4, 2001.     

Thermal degradation kinetics of polyimide containing 2,6-benzobisoxazole units

A novel polyimide (PI) based on 2,6-bis(p-aminophenyl)-benzo[1,2-d;5,4-d′]bisoxazole has been synthesized via a conventional two-stage procedure with bis(ether anhydrides) (HQDPA). The intermediate poly(amic acid) had inherent viscosities of 1.70 dl/g and could be thermally converted into light yellow polyimide film. The resulted polyimide showed excellent thermal stability, and the glass transition temperatures (T_g) were above 283 °C, the 5% weight loss temperature of the polymer was at 572 °C in N₂. The thermal degradation of the polyimide was studied by thermogravimetric analysis (TGA) in order to determine the actual reaction mechanisms of the decomposition process. The activation energy of the solid-state process was determined using Flynn-Wall-Ozawa method, which does not require knowledge of the reaction mechanism, which resulted to be 361.36 kJ/mol. The activation energy of different mechanism models and pre-exponential factor (A) were determined by Coats-Redfern method. Compared with the value obtained from the Ozawa method, the actual reaction mechanism obeyed nucleation and growth model, Avrami-Erofeev function (A₃) with integral form g(X) = [−ln(1−X)]³.     

Product analysis and mechanism of toluene degradation by low temperature plasma with single dielectric barrier discharge

A single dielectric barrier discharge (DBD) low-temperature plasma reactor was set up, and toluene was selected as the representative substance for volatile organic compounds (VOCs), to study the reaction products and degradation mechanism of VOCs degradation by low-temperature plasma. Different parameters effect on the concentration of O₃ and NO_x during the degradation of toluene were studied. The exhaust in the process of toluene degradation was continuously detected and analyzed, and the degradation mechanism of toluene was explored. The results showed that the concentration of O₃ increased with the increase of the power density and discharge voltage of the plasma device. However, as the initial concentration of toluene increased, the concentration of O₃ basically keep steady. The concentration of NO_x in the by-products increased with the discharge voltage, power density, and initial concentration of toluene in the plasma device, and the concentration of NO₂ was much higher than the concentration of NO. The degradation process of toluene was detected and analyzed. The results showed that the degradation mechanism of toluene by plasma includes high energy electron bombardment reaction, active radical reaction and ion molecule reaction. Among them, the effect of high-energy electrons on toluene degradation is the largest, followed by the effect of free radicals, in which oxygen radicals participated in the reaction mainly through the formation of C–O bond, CO bond, (CO)–O– bond and –OH radical, while nitrogen radicals participate in the reaction mainly through the formation of C–NH₂, (CNH)- bond, CN bond and C–NO₂ bond. The results can provide some data supports for the study of low-temperature plasma degradation of VOCs.