Quantitative determination of paraffin oil in blood by capillary gas chromatography

A capillary gas chromatographic method is described for the quantitative determination of liquid paraffin in blood. Paraffin is extracted from blood into n-heptane. After solvent evaporation and dissolution of the residue in 100–200 μl n-heptane one μl is injected into a gas chromatograph fitted with a fused silica capillary column (Permabond® OV-1-CB-0.1, 10 m × 0.32 mm i.d.) and flame ionization detector. Analysis is performed by using an oven program [50°C (3 min)?285°C (5 min), rise 10%min]. The sensitivity (1.5 ng hexadecane) and the reproducibility prove the applicability of the method for the determination of liquid paraffin in blood and for the study of the stability of the liquid paraffin hollow fiber membranes used in an extracorporeal liver support system.     

Diagnosis of OH Radical by Optical Emission Spectroscopy in Atmospheric Pressure Unsaturated Humid Air Corona Discharge and its Implication to Desulphurization of Flue Gas

OH radical in the corona discharge with pipe–nozzle–plate electrode has been diagnosed by optical emission spectroscopy. Spatial variations of OH radical emission in discharge gap have been measured. Relative intensity of OH radical emission spectroscopy increases with increasing water vapor flux injected into the reactor or intensity of electric field supported. In positive pulsed corona discharge, relative intensity is higher than that in positive DC corona discharge and lower than that in negative DC corona discharge. Strongest intensity of OH radical spectrum appears within the range of 5 mm near the discharge nozzle- electrode. In addition, it is proved that the efficiency of desulphurization from flue gas by pulsed corona discharge plasma processes can be improved when OH radical is produced in the reactor.     

Determination of thermodynamic properties of macroporous glycidyl methacrylate‐based copolymers by inverse gas chromatography

Macroporous crosslinked poly(glycidyl methacrylate‐co‐ethylene glycol dimethacrylate) (PGME) was synthesized by suspension copolymerization and modified by ring‐opening reaction of the pendant epoxy groups with ethylene diamine (EDA). Inverse gas chromatography (IGC) at infinite dilution was applied to determine the thermodynamic interactions of PGME and modified copolymer, PGME‐en. The specific surface areas of the initial and modified copolymer samples were determined by the BET method, from low‐temperature nitrogen adsorption isotherms. The specific retention volumes, V, of 10 organic compounds of different chemical nature and polarity (nonpolar, donor, or acceptor) were determined in the temperature range 333–413 K. The weight fraction activity coefficients of test sorbates, , and Flory–Huggins interaction parameters, , were calculated and discussed in terms of interactions of sorbates with PGME and PGME‐en. Also, the partial molar free energy, , partial molar heat of mixing, , sorption molar free energy, ΔG, sorption enthalpy ΔH, and sorption entropy, ΔS, were calculated. Glass transitions in PGME and PGME‐en, determined from IGC data, were observed in the temperature range 373–393 K and 363–373 K, respectively. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 43: 2524–2533, 2005     

利用差异衍生同步分析醛糖和酮糖

建立了一种可同时对醛、酮糖进行精确定性和定量分析的方法。以肌醇作为内标，用80％乙醇超声提取，利用醋酸酐和HMDS＋TMCS（1：3）进行差异衍生，在EI源下用SIM模式进行GC／MS分析。结果表明：11种标准单糖在1—4mg／L范围内线性良好；仪器检出限：醛糖在8．15—22．4μg／L之间；酮糖为2．32μg／L和3．47μg/L；高、中、低3个量的平均回收率在73．0％-95．7％，相对标准偏差在3．1％-10．0％。对枸杞游离单糖进行测定，各单糖含量分别在0．26—368．6mg／g。该方法弥补了以前单糖分析中的缺陷，对既含有醛糖又含有酮糖的样品可同时进行精确的定性定量分析。     

毛细管气相色谱法分离分析二甲砜和二甲亚砜

采用毛细管气相色谱法对间接电氧化法合成的二甲砜及反应物二甲亚砜进行了分离分析。研究了分离二甲砜、二甲亚砜的最佳条件，内标法定量。两种化合物的线性范围在2－30μg，且有较好的精密度。     

Recent Results on Fast Flow Gas-Phase Partial Oxidation of Lower Alkanes

Recent experimental results and kinetic modeling of fast flow gas-phase oxidation of methane and other lower alkanes to methanol and other oxygenates are discussed,alongside with prospects and possible areas for applications of the processes.     

聚合物复合材料填充剂的表面性质及其分散性的研究

本文通过反气相色谱技术研究了未处理的、硅烷偶联剂处理的和钛酸酯偶联剂处理的三种Al(OH)_3粉末的表面性质,并通过塑化仪和扫描电子显微镜研究了Al(OH)_3填充聚丙烯体系的流变行为及其在聚丙烯中的分散效果.结果表明Al(OH)_3的表面性质对其在聚丙烯介质中的分散效果有着重要的影响.     

The effect of low concentrations of a polyatomic gas in argon on erosion on copper cathodes in a magnetically rotated arc

Experimental results are presented for electrode erosion on copper cathodes in magnetically rotated arcs in argon, dry air, nitrogen, ammonia, and carbon monoxide as well mixtures of the above with argon. Water-saturated argon was also used. Erosion rates were determined by weight loss after chemical cleaning, and the runs were sufficiently long (between 5 to 60 min) to represent steady-state operation. Arc currents of 100 A and gas pressures of 1.1 atm. were used. Pure argon gave the highest erosion rates and the lowest arc velocities. Small concentrations of any of the diatomic gases in argon greatly increased the arc velocity and decreased the erosion rates. The results suggest that erosion is primarily a thermal phenomenon but that the surface chemistry can greatly influence erosion rates by modifying arc behavior.     

The use of TG-FTIR technique for the assessment of hydrogen bromide emissions in the combustion of BFRs

The TG-FTIR technique was used in the present study to investigate the thermal degradation behaviour of materials containing brominated flame retardants under fire conditions. Time-temperature profiles and oxygen concentrations typical of selected fire scenarios were reproduced in the thermogravimetric analyzer, while the characterization of the gaseous products generated was performed by the simultaneous FTIR analysis. FTIR analysis combined with the use of specific calibration procedures allowed the quantitative estimation of the gaseous products evolved as a function of experimental conditions. The results obtained allowed the straightforward assessment and the comparison of the quantities of hydrogen bromide formed in the oxidation and thermal degradation of pure brominated flame retardants and of flame retarded materials of industrial interest. Hydrogen bromide yields resulted dependent on the experimental conditions used, such as oxygen concentration and heating rate. Although TG-FTIR experiments only provide a representation of the actual heterogeneous combustion products in real fire conditions, the coupled TG-FTIR technique proved to be a straightforward experimental methodology allowing one to obtain reference data on the nature and quantities of the macropollutants generated in a fire. This revised version was published online in July 2006 with corrections to the Cover Date.     

溴代及胺交联聚苯醚（PPO）膜的气体透过行为

对聚苯醚(PPO)进行了苯环溴代、甲基溴代以及胺交联,发现苯环溴代可提高O_2、N_2透过率(P),而选择性(α)基本不变。甲基溴代则相反,P降低、α有明显提高。调节两者比例可得到P、α兼优的O_2、N_2分离膜。甲基溴代后进一步胺交联可得到α更高、耐溶剂的膜材料。