基于课程标准的教学——以常见阴、阳离子的检验为例

以常见的阴、阳离子的检验为例，研究了如何实施基于标准的教学。校本教材的开发为标准、教材、教学、评价的一致性提供保障；以学生应知的和能做的驱动课堂活动；根据达成标准应有怎样的质量表现，试卷编制先于教学设计。课堂上，“教”“学”双方都明确学习目标，教师提供多种策略来满足学生多样的学习需要，如提供工具，搭建脚手架，并以“微”研究性学习的方式展开教学，给学生提供了充分的进步空间。     

Economic modeling of board test strategies

A long and deep recession, coupled with continuous competitive pressure to reduce costs, is forcing many companies to review their test strategies. Testing costs have become a more significant proportion of the overall manufacturing cost even though manufacturing yields have increased dramatically over the past ten or twelve years. This causes attention to be focused on testing costs as a key source of cost reduction. The increased use of DFT and the integration of design and test are very positive moves towards controlling testing costs but other methods employed can often backfire. The increased use of low priced testers is one such method. The pressure to reduce costs, higher process yields and exhortations that testing adds no value can lead the test engineering manager to take the cheap route. In reality this can often turn out to be an expensive decision. The only way to avoid expensive mistakes is to perform an economic analysis of the alternative courses of action. In most cases this is done, but not always in the right manner or with the necessary amount of detail to make the comparisons meaningful. This article discusses the need for effective cost analysis of test strategies and highlights some of the pitfalls.     

雪崩光电探测器的击穿效应模型分析

基于CMOS工艺制备了空穴触发的Si基雪崩探测器(APD),基于不同工作温度下器件的击穿特性,建立空穴触发的雪崩器件的击穿效应模型。根据雪崩击穿模型和击穿电压测试结果,拟合曲线得到击穿电场与温度的关系参数(dE/dT),器件在250～320 K区间内,击穿电压与温度是正温度系数,器件发生雪崩击穿为主,dV/dT=23.3 mV/K,其值是由倍增区宽度以及载流子碰撞电离系数决定的。在50～140 K工作温度下,击穿电压是负温度系数,器件发生隧道击穿,dV/dT=-58.2 mV/K,其值主要受雪崩区电场的空间延伸和峰值电场两方面因素的影响。     

“数字电子技术基础”MOOC设计与应用

采用线上线下混合教学模式已经成为提升教学质量的必要手段。2021年3月数字电子技术基础在中国大学MOOC平台上线,基于项目教学法,重构知识体系,以4个精心设计的、循序渐进的、侧重不同知识点的、具有代表性的项目为课程脉络主线,讲解过程中广泛采用对比教学法、层次教学法、错误引导法,逐步引领学生建构知识体系。本MOOC课程可有效缓解学时不断减少与挑战度要求不断提高之间的矛盾。     

基于问题导向的在线教学研究

本文以“电力电子技术基础”的在线教学为例,开展以学生为中心的基于问题导向的教学方法优化实践。教学过程中,结合学校教师教学发展中心组织的EMI教师培训,对教学计划、教学重点进行了大力度的改进;同时,结合过程中与学生的交互、期末学生的反馈以及同行专家的建议,对本次的优化改进进行了教学分析、分析、反思和总结,以期不断提升本课程的教学质量,并为其它工科类课程的教学优化提供借鉴。     

Ab initio studies of small AlmFen clusters

The equilibrium geometrical structures of small Al_mFe_n clusters have been determined through ab initio calculation of the cluster total energy at the UB3LYP/Lanl2dz level. For dimers of iron and aluminum, the dissociation energies, the equilibrium atomic distances, and the vibrational frequencies were calculated. The agreement between calculations and experiments is reasonable. The ground stable geometrical structures of Fe₄, FeAl₃, Fe₃Al and Fe₂Al₂ clusters favor three-dimension configurations, but Al₄ tetramers are planar structures. The Al-rich tetramers are more stable than the other two composition tetramers. This is different from that of bulk alloys.     

铝(Ⅲ)-桑色素-十二烷基硫酸钠体系在滤纸基质的荧光反应研究及其分析应用

本文探讨了在滤纸基质上表面活性剂SLS对铝-桑色素荧光反应的增敏作用及最佳实验条件。铝含量在0～6.0ng范围的工作曲线呈良好的线性关系(r=0.9998),方法的检测限为0.001ng。含铝4.0ng的溶液11次测定结果的相对标准偏差为4.3％。方法用于含铝水样的测定获得满意结果,回收率为96.0～100.5％。     

Chromatographic separation and determination of Zr in bauxites and aluminum alloys

Summary A simple thin-layer chromatographic method for the complete separation of Zr from aluminum is described. The optimum solvent composition is evaluated by means of the simplex method of optimization. Quantitative determination and regression analysis is carried out.     

Kinetic and mechanistic study of the quasiliving cationic polymerization of styrene with the 2-phenyl-2-propanol/AlCl3 · OBu2 initiating system

The cationic polymerization of styrene with the 2-phenyl-2-propanol (CumOH)/AlCl₃ · OBu₂ initiating system at various dibutyl ether concentrations in a mixture of 1,2-dichloroethane and n-hexane (55:45 v/v) at −15 °C was investigated. The experimental results showed that an increase in dibutyl ether concentration leads to a noticeable decrease in the polymerization rate as well as to the more controlled polymerization in terms of molecular weight (M_n) and molecular weight distribution (MWD) evolutions. The kinetic investigation revealed that the polymerization proceeds in two stages. The first stage is characterized by high polymerization rate and slow initiation relative to propagation. During this stage molecular weight decreases or does not change and MWD increases with conversion. In the second stage considerably slower quasiliving polymerization of styrene occurs. The quasiliving nature of the styrene polymerization by the CumOH/AlCl₃ · OBu₂ system is proved and mechanistic scheme of the polymerization is proposed.     

一种新型双亚胺吡啶铁系催化剂的乙烯低聚研究

线性α 烯烃广泛地应用于洗涤剂、增塑剂、润滑油等精细化学品的合成以及作为共单体制备线性低密度聚乙烯 (ＬＬＤＰＥ) .目前工业上主要是应用ＳＨＯＰ法[1] 、Ｃｈｅｖｒｏｎ工艺和Ａｍｏｃｏ工艺[2 ] 通过乙烯低聚制备 .近些年发展起来的新型高活性后过渡金属乙烯低聚催化剂能够高选择性地制备线性α 烯烃[3 ,4] .Ｂｒｏｏｋｈａｒｔ等[4] 的研究表明 ,对于双亚胺吡啶铁系乙烯聚合催化剂而言 ,配体上苯基的邻位取代基位阻减小可以实现乙烯低聚 ,并具有高活性、高选择性以及理想的低聚产物分布 .本文的工作是从配体的空间位阻效应对催化剂…