1.30μmDFB激光器组件的设计和制做及其工作原理

本文自行设计和制作了１．３０μｍＤＦＢ激光器组件的讨论了光隔离和光耦合原理。由于采用的激光器－光隔离器－光纤的一体化结构，大大增加了该组件的可用性。在实验中得到高达５５％的耦合效率。     

Chemical imaging in biology and medicine using ion microscopy

The ability to quantitatively map the distribution of elements on the micrometer scale and smaller with high sensitivity and isotopic discrimination is unique to ion microscopy. The information contained in ion images can be crucial to the study of the solid state, where chemical heterogeneity is often directly related to observed behavior. The tools of digital image processing allow the extraction of quantitative information from the image data. These techniques coupled with improved instrumentation for the detection of ion images drastically increase the problem solving capabilities of the ion microscope. The use of such methods and instrumentation in the ion microscopic analyses of cell cultures and tissues of biological and biomedical relevance will be discussed.     

取代基效应(SCS)与乙烯-α-烯烃共聚物的序列结构Ⅲ.定量分析

本文在分析乙烯-α-烯烃共聚物序列结构时,把代表共单体反接单元的亚甲基(CH₂)βγ和γδ分别归属给了二元组VV和三元组EEV。与此同时,CH₂-δδ和δδ⁺归属给了二元组EE。表征乙烯长序列的CH₂-δ⁺δ⁺分属二元组EE和三元组EEE,对应峰强度在EE和EEE之间的分配是处理序列分布的关键。在本文中运用序列结构的Bovey关系和Randall统计进行演算,求得了修正值△的数学表达式,严格解和近似解。在规则链条件下得到的近似解与G.J.Ray的结果完全相同。当共单体含量较少时,谱峰强度Iδ⁺δ⁺的分配接近相等。在二元组和三元组的水平上,乙烯-α-稀烃共聚物的¹³C NMR谱中共有十三个峰,属于CH₂的有十个,属于CH的有三个。利用这些谱峰的强度数据可以建立一套计算公式,由此提供共聚物序列结构的全部信息。因此这是一个研究乙烯-α-烯烃共聚物序列结构的普适方法。     

Mechanosynthesis of YIG and GdIG: A Structural and Mössbauer Study

We have investigated the mechanosynthesis of gadolinium and yttrium iron garnets by high-energy ball-milling of α-Fe₂O₃ and Gd₂O₃ or α-Fe₂O₃ and Y₂O₃, respectively, followed by short thermal annealings conducted at moderate temperatures. The samples were characterized by X-ray diffraction and Mössbauer spectroscopy, in order to determine the influence of the milling time and annealing conditions on the final products. For as-milled samples of each rare-earth system, the results revealed the formation of perovskite phases, in relative amounts that depend on the milling time. The formation of garnet phases was observed in as-annealed samples treated at 1000°C for 2 h or 1100°C for 3 h, i.e., at very modest annealing requirements when compared with ordinary solid-state-reaction processes performed without previous high-energy milling. Also, the occurrence was verified of a milling time for which the relative amount of garnet phases formed by annealing was maximized. This time depends on the rare-earth composing the garnet phase and on the annealing temperature.     

Behaviors of the positive temperature coefficient of resistance of poly(styrene‐co‐n‐butylacrylate) filled with Ni‐plated core‐shell polymeric particles

Conductive composite films of poly(styrene‐co‐n‐butylacrylate) copolymers filled with low‐density, Ni‐plated core‐shell polymeric particles were prepared and their behaviors of positive temperature coefficient of resistance (PTCR) were investigated. When the conductive fillers in the composite film were loaded beyond the critical volume, 10 up to 25 vol %, composite films exhibited a unique electrical resistant transition behavior, which the electrical resistance rapidly increased by several orders of magnitude at the critical temperature. The PTCR transition temperature, in general, occurred before the glass transition temperature of polymer matrix. Further increased the conductive filler loading to 30 vol %, the overpacked conduction paths were formed in the entire composite and the PTCR effects became blurred. While the composite film treated with thermal cycle several times from room temperature up to 120 °C, the electrical resistivity increased accompanied with the shift of the PTCR transition to lower temperature. The reason might have been caused by the formed interfacial cracks within the composite film. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 322–329, 2007     

Mimicking catalase and catecholase enzymes by copper(II)-containing complexes

An imidazolate-bridged copper(II)-zinc(II) complex (Cu(II)-diethylenetriamino-μ-imidazolato-Zn(II)-tris(2-aminoethyl)amine perchlorate (denoted as “Cu,Zn complex”) and a simple copper(II) complex (Cu(II)-tris(2-aminoethyl) amine chloride (“Cu-tren”) were prepared and immobilised on silica gel (by hydrogen or covalent bonds) and montmorillonite (by ion exchange). The immobilised substances were characterised by FT-IR spectroscopy and their thermal characteristics were also studied. The obtained materials were tested in two probe reactions: catalytic oxidation of 3,5-di-tert-butyl catechol (DTBC) (catecholase activity) and the decomposition of hydrogen peroxide (catalase activity). It was found that the catecholase activity of the Cu,Zn complex increased considerably upon immobilization on silica gel via hydrogen bonds and intercalation by ion exchange among the layers of montmorillonite. The imidazolate-bridged copper(II)-zinc(II) complex and its immobilised versions were inactive in hydrogen peroxide decomposition. The Cu(II)-tris(2-aminoethyl)amine chloride complex displayed good catalase activity; however, immobilisation could not improve it.     

Micromechanics of ferroelectric polymer-based electrostrictive composites

Electrostriction refers to the strain induced in a dielectric by electric polarization, which is usually very small for practical application. In this paper, we present a micromechanical analysis on the effective electrostriction of a ferroelectric polyvinylidene fluoride trifluoroethylene [P(VDF-TrFE)] polymer-based composite, where the exact connections between the effective electrostrictive coefficients and effective elastic moduli are established, and numerical algorithm for the prediction of the effective electrostrictive coefficients of the composite in terms of its microstructural information is developed. From our calculations, enhanced electrostriction in the composite has been demonstrated, and optimal microstructure for electrostriction enhancement has been identified. Our analysis provides a mechanism for the electrostriction enhancement, where the electrostrictive strain several times higher than that of polymer matrix can be obtained, if the microstructure of the composites can be carefully tailored.     

采用级联原子滤光器的新型卫星激光链路系统研究

提出级联佛克脱型原子滤光器(Linked VADOF)的新构想。从理论上分析并计算了级联佛克脱型原子滤光器的透射谱。结果表明，级联佛克脱型原子滤光器将佛克脱型原子滤光器的多峰改造为单峰结构，具有比佛克脱型原子滤光器更窄的线宽和更高的噪声抑制比。将这种新型结构应用于激光信标锁频。该锁频方案提高了信标光频率的稳定性。在此基础上，给出了发射端采用级联佛克脱型原子滤光器锁频，接收端采用法拉第型原子滤光器(FADOF)滤光的新型卫星激光链路系统。外场初步联调实验表明了该系统的可行性。     

利用光纤数字同步传送网2.048 Mbit/s支路传送高精度标准时间信号

首次提出一种利用光同步数字传送网的2.048Mbit/s信号传送高精度时间编码信号的方法和实验结果。它可以使整个通信网的交换机、计费系统、网管系统、基站控制器等设备实现与UTC的时间同步。目前的实验证明,时间同步的不确定度优于±5μs。