溶液中某些镉(II)的混合配体配合物的稳定性研究: 关于混合配体配合物相对稳定性定量表征的讨论

本文用pH电位法研究了在70%(v/v)乙醇-水溶液中Cd(II)与维生素D3(VD3)和乙二胺(en)或2,2'-联吡啶(bipy)在37±0.1℃和离子强度为0.10(KNO3)条件下, 三元混配配合物的稳定性。结果表明, 上述混合配位体系均形成稳定的1:1:1型混配配合物, 且△logK值均为较大的正值(分别为+1.06和+1.54), 但相应的logX值却并不很大(分别为2.18和2.83)。从统计效应和配合物分子内的配体间疏水相互作用, 讨论了造成这种反应常结果的可能原因, 并针对如何判断三元混配配合物相对稳定性高低等问题提出了作者的见解。     

The research on the high quality TiO2, MoO3-doped WO3 electrochromic film

The high quality TiO2, MoO3-doped WO3 electrochromic film was prepared by the sol–gel method for the first time. The sol, which has hydrogen peroxide (H2O2) and oxalic acid (H2C2O4), was very stable at room temperature and quite suitable for the deposition of films. The WO3 electrochromic film prepared from this doped sol had excellent performance, such as short response time, no cracks, good adhesion to the substrate, high coloring efficiency and longevity of service.     

丽春红G-高碘酸钾催化光度法测定痕量锇

以Os(Ⅳ )催化高碘酸钾氧化丽春红G(PG)的褪色反应为基础 ,在 90℃加热 1 2min和 5 0 0nm波长处采用固定时间法测定丽春红G吸收值的降低 ,建立了测定痕量锇 (Ⅳ )的新方法。锇 (Ⅳ )的质量浓度在 0～ 0 48μg/L范围内呈良好的线性关系 ,检出限为 6 2× 1 0 - 9mg/L。对 0 4μg/L锇 (Ⅳ )测定的相对标准偏差为 0 71 % (n =1 1 )。催化反应对Os(Ⅳ )和丽春红G均为一级反应 ,催化反应的表观活化能为 78 80kJ/mol。所提出的方法在蒸馏分离后已应用于某些岩矿及冶金产品中锇的测定     

助熔剂对Y3Al5O12：Ce荧光粉性能的影响

在还原气氛下采用高温固相反应法合成了白光LED用黄色荧光粉Y3Al5O12:Ce(YAG:Ce)研究了助熔剂对YAG：Ce荧光粉发光特性的影响，。XRD的测量结果表明加入合适的助熔剂有利于YAG:Ce荧光粉的晶化，并且不引入杂相，选择BaF2和H3BO3同时使用效果要好于单独使用一种助熔剂，助熔剂的加入可增大YAG：Ce荧光粉的激发和发射光谱强度，并能有效降低荧光粉的中心粒径（D50）控制粉体的粒径分布，适用于白光LED的制造。     

Synthesis and Characterization of the Chiral Skeleton Cluster [NiRuMo(CO)_5(μ_3-S)(η~5-C_5H_5)(η~5-C_5H_4COCH_3)]

1 INTRODUCTION The chemistry of transition metal cluster has enjoyed an exceptional growth since the mid 1970s[1, 2], especially in recent years the structural and bonding aspects of mixed-metal tetrahedral skeleton clusters have been extensively studied[3]. One important reason is that such chiral cluster can induce an asymmetric catalysis potentially. In our research group, considerable efforts have been directed to the synthesis of chiral tetrahedral clusters containing four different…     

THERMAL PROPERTY, MISCIBILITY AND CRYSTALLIZATION BEHAVIOR OF POLY（3-HYDROXYBUTYRATE-co- 3-YDROXYHEXANOATE） AND POLY（BUTYLENE SUCCINATE-ADIPATE） （PHBHHX/PBSA） BLENDS

Blends of poly(3-hydroxybutyrate-co-3-hydroxyhexanoate) (PHBHHx) and poly(butylene succinate-adipate) (PBSA), both biodegradable semicrystalline polyesters, were prepared with the ratio of PHBHHx/PBSA ranging from 80/20 to 20/80 by melt mixing method. Differential scanning calorimetry (DSC), thermogravimetry analysis (TGA), dynamic mechanical thermal analysis (DMA), polarizing optical microscopy (POM) and wide angle X-ray diffractometer (WAXD) were used to study the miscibility and crystallization behavior of PHBHHx/PBSA blends. Experimental results indicate that PHBHHx is immiscible with PBSA as shown by the almost unchanged glass transition temperature and the biphasic melt.     

固体超强酸催化剂SO_4~(2-)/TiO_2-WO_3的制备及其催化性能研究

制备了固体超强酸催化剂SO2 -4/TiO2 WO3 ,并以丁酸丁酯的合成作为探针反应 ,系统考察了WO3 的含量、硫酸浸渍浓度、焙烧温度等制备条件对SO2 -4/TiO2 WO3 催化活性的影响 .实验表明 :制备催化剂的适宜条件为m(H2 WO4) =12 5 % ,硫酸浸渍浓度为 1 0mol·L-1,焙烧温度为 5 80℃ ,活化时间 3h .利用优化条件下制备的催化剂SO2 -4/TiO2 WO3 催化合成缩醛 (酮 ) ,在醛 /酮与二元醇 (乙二醇 ,1,2 丙二醇 )的投料摩尔比为 1∶1 5 ,催化剂的用量占反应物总投料质量的 0 5 % ,反应时间为 1h条件下 ,2 甲基 2 乙氧羰甲基 1,3 二氧环戊烷的收率为 78 7% ,2 ,4 二甲基 2 乙氧羰甲基 1,3 二氧环戊烷的收率为 83 0 % ,环己酮 -乙二醇缩酮的收率为 85 9% ,环己酮 1,2 丙二醇缩酮的收率为 84 6% ,丁酮 -乙二醇缩酮的收率为70 7% ,丁酮 1,2 丙二醇缩酮的收率为 88 3 % ,2 丙基 1,3 二氧环戊烷的收率为 80 6% ,4 甲基 2 丙基 1,3 二氧环戊烷的收率为 79 6% ,2 异丙基 1,3 二氧环戊烷的收率为 64 2 % ,4 甲基 2 异丙基 1,3 二氧环戊烷的收率为 83 3 % ,2 苯基 1,3 二氧环戊烷的收率为 75 3 % ,4 甲基 2 苯基 1,3 二氧环戊烷的收率为 95 1% .     

Morphology Control over the Organic Nanoparticles of 1,3-Diphenyl-5-（9-anthryl）-2-pyrazoline

The organic nanoparticles of a blue-light-emitting molecule, 1,3-diphenyl-5-(9-anthryl)-2-pyrazuline, were prepared by reprecipitation method using acetonitrile as the solvent for the molecular precursor. Three morphologies, spherical, doughnut-shaped and cubic, could be observed on the silicon substrate forthe nanoparfides by the volume-controlled addition of acetonitrile. The evolution of particle morphology as a function of acetonitrile addition was attributed to the variation of the growth habits of the particles in the different environment. The nanoparticles exhibit the novel photoluminescence spectra as compared to those of monomer and the bulk crystals.