Compiler compatible 5.66 Mb/mm2 8T 1R1W register file in 14 nm FinFET technology

1-read/1-write (1R1W) register file (RF) is a popular memory configuration in modern feature rich SoCs requiring significant amount of embedded memory. A memory compiler is constructed using the 8T RF bitcell spanning a range of instances from 32 b to 72 Kb. An 8T low-leakage bitcell of 0.106 μm² is used in a 14 nm FinFET technology with a 70 nm contacted gate pitch for high-density (HD) two-port (TP) RF memory compiler which achieves 5.66 Mb/mm² array density for a 72 Kb array which is the highest reported density in 14 nm FinFET technology. The density improvement is achieved by using techniques such as leaf-cell optimization (eliminating transistors), better architectural planning, top level connectivity through leaf-cell abutment and minimizing the number of unique leaf-cells. These techniques are fully compatible with memory compiler usage over the required span. Leakage power is minimized by using power-switches without degrading the density mentioned above. Self-induced supply voltage collapse technique is applied for write and a four stack static keeper is used for read Vmin improvement. Fabricated test chips using 14 nm process have demonstrated 2.33 GHz performance at 1.1 V/25 °C operation. Overall V_min of 550 mV is achieved with this design at 25 °C. The inbuilt power-switch improves leakage power by 12x in simulation. Approximately 8% die area of a leading 14 nm SoC in commercialization is occupied by these compiled RF instances.     

CDMA 1x EV-DO覆盖模型的分析与仿真

结合经过校正后的适合于本地无线环境的OKUMURA-HATA传播模型，建立起一种新的本地化基于1x EV—DO系统数据业务吞吐量分析的覆盖预测仿真模型，可应用于1xEV—DO系统的网络规划及系统性能分析。     

WCDMA系统接口信令消息的描述与实现

WCDMA作为第三代移动通信系统的主流标准，能够提供多种类型的多媒体服务。为了实现各种用户平面数据的传输，系统会提前通过控制平面对所需的无线资源进行分配。由于配置过程是通过接口之间发送控制平面应用协议消息来实现的，因此能否正确有效地对信令消息进行编解码成为保证系统稳定工作的关键因素。3GPP标准中，ASN．1语言被用来描述接口信令消息。首先简要介绍了WCDMA系统结构以及主要接口协议，重点描述了ASN．1存在的意义及其编解码规则，最后给出了基于ASN．1的开发环境下应用层网络协议的开发流程。     

基于PCI总线的扫描电镜图像采集系统

图像采集系统是扫描电镜的一个重要组成部分，用于控制扫描电镜的扫描电源，视频图像采集，数字化与显示，电镜主控计算机与底层微机板的通讯和电镜照相，本图像采集系统基于PCI总线接口设计，硬件主要设计采用FPGA技术，实现了数字电路的模块化设计，集成度和灵活性高，目前，电镜图像卡已达到所要求的设计水平。     

基于C6711处理器cdma2000 1X系统前向信道信号的处理

在cdma20001x前向信道中,要对一段信号进行传送,一般选用QPSK调制,因为QPSK调制比QAM更适合噪音环境。采用TI6000系列的TMS320C6711芯片处理前向信道信号,可以对复杂性和实时性较高的信号做采集、量化、编码、调制等实时处理,主要功能通过软件编程实现,从而使系统具有结构灵活、可靠性高、可扩展等优点。     

1/f noise in large-area Hg<Subscript>1−x</Subscript>Cd<Subscript>x</Subscript>Te photodiodes

The 1/f noise in photovoltaic (PV) molecular-beam epitaxy (MBE)-grown Hg_1−xCd_xTe double-layer planar heterostructure (DLPH) large-area detectors is a critical noise component with the potential to limit sensitivity of the cross-track infrared sounder (CrIS) instrument. Therefore, an understanding of the origins and mechanisms of noise currents in these PV detectors is of great importance. Excess low-frequency noise has been measured on a number of 1000-μm-diameter active-area detectors of varying “quality” (i.e., having a wide range of I-V characteristics at 78 K). The 1/f noise was measured as a function of cut-off wavelength under illuminated conditions. For short-wave infrared (SWIR) detectors at 98 K, minimal 1/f noise was measured when the total current was dominated by diffusion with white noise spectral density in the mid-10⁻¹⁵A/Hz^1/2 range. For SWIR detectors dominated by other than diffusion current, the ratio, α, of the noise current in unit bandwidth i_n(f = 1 Hz, V_d = −60 mV, and Δf = 1 Hz) to dark current I_d(V_d = −60 mV) was α_SW-d = i_n/I_d ∼ 1 × 10⁻³. The SWIR detectors measured at 0 mV under illuminated conditions had median α_SW-P = i_n/I_ph ∼ 7 × 10⁻⁶. For mid-wave infrared (MWIR) detectors, α_MW-d = i_n/I_d ∼ 2 × 10⁻⁴, due to tunneling current contributions to the 1/f noise. Measurements on forty-nine 1000-μm-diameter MWIR detectors under illuminated conditions at 98 K and −60 mV bias resulted in α_MW-P = i_n/I_ph = 4.16 ± 1.69 × 10⁻⁶. A significant point to note is that the photo-induced noise spectra are nearly identical at 0 mV and 100 mV reverse bias, with a noise-current-to-photocurrent ratio, α_MW-P, in the mid 10⁻⁶ range. For long-wave infrared (LWIR) detectors measured at 78 K, the ratio, α_LW-d = i_n/I_d ∼ 6 × 10⁻⁶, for the best performers. The majority of the LWIR detectors exhibited α_LW-d on the order of 2 × 10⁻⁵. The photo-induced 1/f noise had α_LW-P = i_n/I_ph ∼ 5 × 10⁻⁶. The value of the noise-current-to-dark-current ratio, α appears to increase with increasing bandgap. It is not clear if this is due to different current mechanisms impacting 1/f noise performance. Measurements on detectors of different bandgaps are needed at temperatures where diffusion current is the dominant current. Excess low-frequency noise measurements made as a function of detector reverse bias indicate 1/f noise may result primarily from the dominant current mechanism at each particular bias. The 1/f noise was not a direct function of the applied bias.     

基于VXI总线的超宽带线性调频信号源的设计

主要介绍了VXI总线C尺寸超宽带线性调频信号源的设计方法，重点描述了利用现场可编程逻辑器件FPAG和DSP设计VXI总线接口电路，以及数字波形存储直读技术在线性调频信号源中的应用。     

Synchronous Full-Scan for Asynchronous Handshake Circuits

Handshake circuits form a special class of asynchronous circuits that has enabled the industrial exploitation of the asynchronous potential such as low power, low electromagnetic emission, and increased cryptographic security. In this paper we present a test solution for handshake circuits that brings synchronous test-quality to asynchronous circuits. We add a synchronous mode of operation to handshake circuits that allows full controllability and observability during test. This technique is demonstrated on some industrial examples and gives over 99% stuck-at fault coverage, using test-pattern generators developed for synchronous circuits. The paper describes how such a full-scan mode can be achieved, including an approach to minimize the number of dummy latches in case latches are used in the data path of the handshake circuit.     

BaxSr（1—x）TiO3多层膜椭偏光谱研究

用溶胶－凝胶技术在Bi(100）衬底上制备了单层和渐变型多层的BaxSr(1-X)TiO3薄膜，其膜层组分分别为：Ba0.7Sr0.3TiO3,Ba0.8Sr0.2TiO,Ba0.9Sr0.1TiO3,BaTiO3，对生长制备出的多层BaxSr(1-X)TiO3薄膜进行了变角度椭偏光谱测量，通过椭偏光谱解谱分析研究，首次得到了BaxSr(1-X)TiO3多层膜结构不同膜层的膜厚和光学常数，其结果显示：椭偏光谱分析得到的不同膜层的膜厚与卢瑟福背向散射测量得到的结果基本相符；渐变型多层膜中BaTiO3薄膜的折射率比单层BaTiO3薄膜折射率大许多，与体BaTiO3的折射率相接近，这说明渐变型多层膜中BaTiO3薄膜的光学性质与体材料的光学性质接近。     

校园网宿舍网络管理模式的探讨

讨论了高校学生宿舍区网络的特点，结合天津商学院校园网的实践，讨论了校园网宿舍网络管理的模式。