蛋壳膜固相萃取-高效液相色谱法测定R-精噁唑禾草灵

采用蛋壳膜固相萃取-高效液相色谱法测定除草剂R-精噁唑禾草灵的含量。优化的试验条件如下:①固相萃取时间为80min;②洗脱剂甲醇的用量为1mL;③样品溶液的酸度为pH 7;④样品溶液的体积为25~100mL。以C18色谱柱为分离柱,以甲醇-水(80+20)混合液为流动相,在检测波长236nm处进行测定。R-精噁唑禾草灵质量浓度在5.00~50.0μg·L-1范围内与峰面积呈线性关系,方法检出限(3S/N)为1.2μg·L-1。方法用于水样和小麦粉样品分析,加标回收率在75.4%~95.2%之间,测定值的相对标准偏差(n=5)在3.7%~5.8%之间。     

中国化学会第17届反应性高分子学术讨论会征文启事

正经中国化学会批准,中国化学会第17届反应性高分子学术讨论会定于2014年7月18~21日在常州大学召开,欢迎您报名参加,并欢迎您就下列内容踊跃投稿:1.离子交换材料、吸附材料、高分子催化剂、高分子试剂2.生物医用高分子材料3.新型反应性高分子(如高分子膜、纤维等分离材料)4.反应性高分子的合成、应用及表征论文摘要要求具有创新性、指导性,凡已在国内外学术会议上报     

尼龙6纳米纤维膜的制备及其对己烷雌酚的吸附性能研究

采用静电纺丝设备制备尼龙6纳米纤维膜。用静、动态吸附方法,研究了尼龙6纳米纤维膜对己烷雌酚的吸附性能,考察了吸附时间、初始浓度及介质p H值对尼龙6纳米纤维膜吸附己烷雌酚的影响。结果表明,初始浓度为2mg/L时,尼龙6纳米纤维膜吸附己烷雌酚的过程符合准一级动力学模型;当初始浓度在5~20mg/L范围内,吸附过程符合准二级动力学模型。尼龙6纳米纤维膜吸附己烷雌酚的过程符合Freundlich等温吸附模型。     

Gold nanoparticles-enhanced bisphenol A electrochemical biosensor based on tyrosinase immobilized onto self-assembled monolayers-modified gold electrode

A novel electrochemical sensor based on the immobilization of tyrosinase(tyr) onto gold nanoparticles(nano-Au) and thioctic acid amide(T-NH2) self-assembled monolayers(SAMs)-modified gold electrode has been developed for the determination of bisphenol A(BPA).It was found that the nano-Au could significantly enhance the electrochemical response of tyr/nano-Au/T-NH2/Au electrode to BPA,and the enhancement effect of nano-Au on the current response was also related to the enzyme.The results indicated that the biosensor could be used as a detector for BPA determination with a linear range from3.99 ×10-7mol/L to 2.34 ×10-4mol/L and a detection limit of 1.33×10-7mol/L.In addition,this biosensor showed good reproducibility.     

Preparation and characterization of Ti0.7Sn0.3O2 as catalyst support for oxygen reduction reaction

Sn-doped TiO_2 nanoparticles with high surface area of 125.7 m~2·g~(-1) are synthesized via a simple one-step hydrothermai method and explored as the cathode catalyst support for proton exchange membrane fuel cells.The synthesized support materials are studied by X-ray diffraction analysis,energy dispersive X-ray spectroscopy and transmission electron microscopy.It is found that the conductivity has been greatly improved by the addition of 30 mol%Sn and Pt nanoparticles are well dispersed on Ti_(0.7)Sn_(0.3)O_2 support with an average size of 2.44 run.Electrochemical studies show that the Ti_(0.7)Sn_(0.3)O_2 nanoparticles have excellent electrochemical stability under a high potential compared to Vulcan XC-72.The as-synthesized Pt/Ti_(0.7)Sn_(0.3)O_2 exhibits high and stable electrocatalytic activity for the oxygen reduction reaction.The Pt/Ti_(0.7)Sn_(0.3)O_2 catalyst reserves most of its electrochemically active surface area(ECA),and its half wave potential difference is 11 mV,which is lower than that of Pt/XC-72(36 mV) under 10 h potential hold at 1.4 V vs.NHE.In addition,the ECA degradation of Pt/Ti_(0.7)Sn_(0.3)O_2is 1.9 times lower than commercial Pt/XC-72 under 500 potential cycles between 0.6 V and 1.2 V vs.NHE.Therefore,the as synthesized Pt/Ti_(0.7)Sn_(0.3)O_2 can be considered as a promising alternative cathode,catalyst for proton exchange membrane fuel cells.     

卟啉化聚合物纤维膜负载TiO_2光催化剂的制备及其光催化性能研究

通过烯基铁卟啉分别和苯乙烯、丙烯腈及甲基丙烯酸甲酯共聚制备三种卟啉化聚合物,然后利用静电纺丝技术将这三种卟啉共聚物与TiO2颗粒共纺制备卟啉共聚物纤维膜负载TiO2光催化剂。扫描电子显微镜(SEM)表征结果显示卟啉共聚物纤维负载TiO2催化剂都具有良好的纤维结构,纤维直径约为1.0-2.0μm。X-射线衍射仪(XRD)则表明TiO2的晶型在纺丝前后都没有受到明显影响。对甲基橙溶液的催化降解实验结果显示:铁卟啉-丙烯腈共聚物负载TiO2催化剂的光催化活性最高,而且铁卟啉的含量对催化剂催化活性起着非常重要的作用。优化后的铁卟啉-丙烯腈共聚物纤维膜负载TiO2光催化剂对甲基橙溶液的脱色率达到76.3%,同时纤维膜结构有利于催化剂的回收和重复使用。     

混合基质水处理膜:材料、制备与性能

以反渗透、纳滤为代表的膜技术已广泛应用于海水和苦咸水脱盐等水处理过程。通过将纳米颗粒添加到传统复合膜基质中,可以制备具有高分离性能和耐污染性的新型膜材料。混合基质膜结合了无机材料及有机聚合物各自的优点,是新型水处理膜材料的发展方向。本文综述了添加无机纳米颗粒的混合基质反渗透、纳滤及正渗透膜的研究进展,详细讨论了不同类型纳米材料的性质和功能,分析了表面有机改性对改善纳米材料分散性以及与聚合物基质相容性的作用,探讨了纳米材料添加方式和膜制备方法对膜结构和性能的影响。在此基础上,进一步探究了混合基质膜的成膜及分离机理,归纳了目前研究中存在的主要问题,并对未来水处理膜材料的研发方向提出了建议。     

基于锑薄膜覆盖铅笔芯电极对Cd(Ⅱ)和Pb(Ⅱ)高灵敏度的检测(英文)

在铅笔芯上通过实时沉积锑薄膜,使用方波阳极溶出伏安法(SWASV)对Cd(Ⅱ)和Pb(Ⅱ)进行同时检测.沉积时间为180 s时,Cd(Ⅱ)和Pb(Ⅱ)的最低检测限分别为0.075μg·L-1和0.13μg·L-1,较铋膜修饰的铅笔芯电极低.在低pH值溶液(pH 2.0)中重现性好.该电极可成功用于测定自来水中的Cd(Ⅱ)和Pb(Ⅱ)含量.     

铅镉重金属离子在铋膜电极上的相互影响

采用原位镀铋电极的方式,以玻碳电极为工作电极,通过改变Cd2+和Pb2+的比例,考察不同Pb2+和Cd2+浓度条件下,两者同时存在时的相互影响。实验发现,Cd2+和Pb2+同时存在时,存在相互的影响,特别是对于Cd2+的检测,由于Pb2+较正的析出电位,对于Cd2+的析出有一定的辅助作用。考察了Cd2+和Pb2+单独存在时的分析性能,Pb2+沉积时间为60 s时,在1~80μg/L范围内呈线性关系,检出限为0.5μg/L;Cd2+的沉积时间为120 s,在1~25μg/L和30~200μg/L范围内有良好的线性关系,检出限为1.0μg/L。考察了铋膜电极在不同实际水样中对Pb2+和Cd2+的分析,获得了较好的一致性。     

Morphology Evolution of Poly（vinylidene fluoride） Membranes during Supercritical CO2 Assisted Phase Inversion

A supercritical carbon dioxide（Sc CO2） assisted phase inversion was developed to produce microporous poly（vinylidene fluoride）（PVDF） membranes whose morphology characteristics arise from both liquid-liquid demixing and solid-liquid demixing（crystallization）. This result was confirmed by Fourier transform infrared spectroscopy（FTIR）, from which both α and β crystals were found. As revealed by contact angle experiment, the PVDF membranes prepared via Sc CO2 assisted phase inversion were more hydrophobic compared with the control membrane produced via conventional immersionprecipitation technique. In particular, the sample with 15 wt% PVDF prepared at 45 °C and 13 MPa exhibited a contact angle of 142°, which was mainly caused by the multilevel micro- and nano- structure. The effects of polyethylene glycol（PEG）, polyvinyl pyrrolidone（PVP） and lithium chloride（Li Cl） on the structures and crystal form were investigated. PVP promoted the formation of β phase crystal form, while PEG boosts the evolution of α phase. Li Cl restrained the crystallization degree of PVDF membrane under Sc CO2.