Tuning of NaTaO_3 Band Structure through Mn~（2＋） Ion Doping and the Enhanced Visible Light Response

Pure and Mn-doped NaTaO3 nanoparticles were synthesized by a simple hydro- thermal method. XRD and XPS results suggested that manganese ions were successfully doped into the NaTaO3 crystalline in Mn2＋ state. UV-vis diffuse reflectance spectra revealed the obvious red-shift in the series of manganese doped NaTaO3 nanoparticles, resulting in a decrease in the band gap of NaTaO3 with the increase of Mn2＋ doping concentration. The photo-degradation experiment indicated that manganese doped NaTaO3 showed good photocatalytic performance and methylene blue（MB） degradation is improved with lower doping concentration of manganese ions under visible light. The simulation of energy band structure by density functional theory unfolded that the substitution of Ta5＋ ions by Mn2＋ ions resulted in an intermediate band（IB） below the bottom of the conduction band（CB）, which was mainly attributed to the state of Mn 3d.     

Synthesis,Crystal Structure and Luminescent Property of Cadmium Complex Based on 2-（2-（1Hbenzo[d]imidazol-2-yl）benzyl）-1H-benzo[d]-imidazole

The complex [Cd(bbb)Cl2]·DMF·H2O, where bbb is 2-(2-(1H-benzo[d]imidazol-2-yl)benzyl)-1H-benzo[d]imidazole, was synthesized and characterized by X-ray single-crystal structure analyses. For the complex: C24H25Cl2CdN5O2, Mr = 598.77, crystal system, triclinic, space group P1, a = 9.9878(12), b = 10.0008(12), c = 13.2217(15) , α = 80.674(2), β = 72.158(2), γ = 86.776(2)°, V = 1240.5(3) 3, Z = 2, Dc = 1.598 g/cm3, λ = 0.71073, μ(MoKα) = 1.127 mm–1, F(000) = 600, S = 1.04, R = 0.0905 and wR = 0.3088 for 4805 observed reflections with I 2σ(I). It is a neutral complex. The distorted tetrahedral geometry of cadmium ion is coordinated by two nitrogen atoms of ligand and two chloride ions. The complex emits blue green luminescence with emission peaks at 480 nm in DMF solution.     

pH-Sensitive Wettability Induced by Topologicaland Chemical Transition on the Self AssembledSurface of Block Copolymer简

pH-sensitive wettability of polystyrene-b-poly（4-vinylpyridine） （PS-b-P4VP） self assembled films, exhibiting superoleophobicity under water and hydrophilicity at low pH value, and oleophobicity under water and hydrophobicity at neutral condition, has been realized. The wettability properties resulted from the surface topological and chemical transition, which were confirmed by in situ AFM measurements under water at different pH. At low pH, P4VP chains, which were confined in the hexagonal-packed nanodomains, got protonated into a swollen state, while at high pH, P4VP chains were deprotonated into a collapsed state. The reversible protonation/deprotonation procedure on the molecular scale leads to surface topological and chemical transition, thereby pH-sensitive wettability.     

Fabrication and Performance of a Low Operating Pressure Nanofiltration Poly（vinyl chloride） Hollow Fiber Membrane

A low operating pressure nanofiltration membrane is prepared by interfacial polymerization between m-phenylenediamine(MPDA) and trimesoyl chloride(TMC) using PVC hollow fiber membrane as supporting.A series of PVC nanofiltration membranes with different molecular weight cutoff(MWCO) can be obtained by controlling preparation conditions.Chemical and morphological characterization of the membrane surface was carried out by FTIR-ATR and SEM.MWCO was characterized by filtration experiments.The preparation conditions were investigated in detail.At the optimized conditions(40 min air-dried time,aqueous phase containing 0.5% MPDA,0.05% SDS and 0.6% acid absorbent,oil phase containing 0.3% TMC,and 1 min reaction time),under 0.3 MPa,water flux of the gained nanofiltration membrane reaches 17.8 L/m2·h,and the rejection rates of methyl orange and MgSO4 are more than 90% and 60%,respectively.     

羟甲基化木质素磺酸盐添加剂对钻井液性能的影响

为了进一步优化木质素磺酸盐作为钻井液处理剂的效能,利用其与甲醛的羟甲基化反应制备了羟甲基化木质素磺酸盐;采用红外光谱仪、X射线粉末衍射仪、扫描电镜等分析了其结构;测定了改性前后的木质素磺酸盐对钻井液流变性、降滤失性、黏土水化膨胀抑制性等性能的影响.结果显示,改性后的羟甲基化木质素磺酸盐的整体结构变化不大,但羟基数量增加,与水的相溶性增强.与木质素磺酸盐相比,羟甲基化木质素磺酸盐在室温下对基浆有较强的提黏作用,经180℃高温老化后降黏、降滤失作用有所增强,形成的泥饼厚度降低,对黏土水化膨胀的抑制作用增强.     

基于丙二酰胺的不对称双子表面活性剂的合成及其乳化性能

将二(3-二甲氨基丙基)丙二酰胺分别与溴代十六烷和溴代十四烷反应,生成的季铵盐化产物经丙酮-乙腈重结晶,得到含丙二酰胺基的不对称阳离子双子(Gemini)表面活性剂(命名为16-9-14),总收率为45.9%(以溴代十六烷计);利用红外光谱和核磁共振谱表征了合成产物的结构,采用电导法测定了其临界胶束浓度(CMC),采用滴体积法测定了其临界张力(γCMC),进而初步探讨了其发泡沫性能和乳化性能.结果表明,合成的Gemini表面活性剂的CMC为1.57×10-4 mol/L,γCMC为38.45mN/m;其发泡性能和乳化性能优于相应的单子表面活性剂.     

TiO_2/12-磷钨杂多酸/金复合纳米材料的制备及电化学性能

采用水热法制备TiO2纳米管(TNTs),然后以12-磷钨杂多酸(PTA)作为交联剂,运用光催化方法在TiO2纳米管表面负载金纳米颗粒(GNPs),从而得到新型复合纳米材料——TNTs-PTA-GNPs;借助傅立叶变换红外光谱仪,X射线衍射仪和透射电子显微镜分析了新型复合纳米材料的结构及形貌,并利用循环伏安法测试了其电化学性能.结果表明,GNPs均匀分布在TNTs表面,从而大幅度改善纳米材料的导电性;但复合纳米材料中无游离的金纳米颗粒.与此同时,TNTs-PTA-GNPs纳米材料具有良好的生物相容性,且可促进酶与电极之间的直接电子转移.     

一种特殊截止单模光纤的传输性能研究

为了提高特殊截止单模光纤的弯曲可靠性,采用气相沉积工艺制作了包层直径80μm碳涂覆的特殊截止单模光纤,测试了光纤的截止波长、模场、衰减谱、宏弯、色散等传输性能和应力腐蚀敏感性参数。测试结果表明光纤截止波长小于915nm,能够实现915nm以上波长单模工作,在常用的几个波段具有较低的传输损耗,光纤的零色散波长红移到1 670nm。采用碳涂覆工艺提高光纤的应力腐蚀敏感性参数达到35,结合小包层直径预期可以提高光纤的使用寿命。     

用作锂离子电池负极的FeS2微球的制备及性能

以氯化亚铁和硫代硫酸钠为原料, 采用水热法一步合成了由FeS₂纳米片堆积的FeS₂微球. 通过调控铁源与硫源的摩尔比及水热合成时间, 并结合X射线衍射(XRD)和扫描电子显微镜(SEM)表征结果推测了FeS₂的生长机理, 筛选出最优条件以提升其电化学性能. 电化学测试结果表明, 在500 mA/g的电流密度条件下, 材料的首次放电/充电容量可分别达到905和800 mA·h·g ^-1, 首次库伦效率达到88.4%; 在2000 mA/g的大电流密度条件下, 500次放电/充电循环后依然稳定保持350 mA·h·g ^-1的可逆容量.     

新型膦胺配体羰基钌化合物的合成及其催化性能研究

以十二羰基三钌和o-PPh2C6H4NR2(R=H,Me)配体为原料,成功制备了三种新型羰基钌化合物(μ-o-PPh2-C6H4NH)Ru3(μ-H)(CO)9(2)、(o-PPh2C6H4NH)2Ru(CO)2(3)和(μ-o-PPh2C6H4NMe2)2Ru(CO)3(4).对这三个化合物进行了核磁共振和红外谱学、元素分析和X射线单晶衍射分析表征,并对这三个化合物进行了催化性能研究.化合物2和4可催化苯甲醛加氢反应生成苯甲醇,但是3没有催化活性.从实验角度阐述了膦胺配体钌催化剂的结构与性能关联,进一步探讨了加氢催化反应失活的可能原因.