圆柱型阵机载雷达杂波抑制新方法

圆柱型阵天线相对于常规的平面阵天线具有空间全方位扫描、搜索跟踪方式灵活和波束方向性好等优点。该文首先从圆柱型阵机载雷达杂波协方差矩阵特征值分布和杂波功率谱距离向分布两个方面分析了圆柱型阵列与均匀平面阵列之间的区别,得到杂波功率谱随距离变化的结论。然后根据圆柱型阵机载雷达杂波分布特点提出了两种不同的杂波抑制方法,它们能够很好地解决圆柱型阵机载雷达杂波距离向分布非均匀的问题。最后通过仿真实验验证了该文方法的正确性。     

Iterative receiver for OFDM systems based on semi-blind channel estimation

In this paper we propose two iterative algorithms of joint channel estimation and symbol detection for Orthogonal Frequency Division Multiplexing （OFDM） systems. In which, superimposed pilot scheme is adopted and an initial Channel State Information （CSI） is obtained by employing a first-order statistic. In each subsequent iteration, we propose two algorithms to update the CSI. The Mean Square Error （MSE） of channel estimation and Bit Error Rate （BER） performance are given and simulation results demonstrate that the iterative algorithm using method B has good performance approaching the ideal condition.     

Estimation of carrier frequency offsets for MIMO systems with distributed transmit antennas

The problem of estimating the carrier frequency offsets in Multiple-Input Multiple-Output (MIMO) systems with distributed transmit antennas is addressed. It is supposed that the transmit antennas are distributed while the receive antennas are still centralized, and the general case where both the time delays and the frequency offsets are possibly different for each transmit antenna is considered. The channel is supposed to be frequency flat, and the macroscopic fading is also taken into consideration. A carrier frequency offset estimator based on Maximum Likelihood (ML) is proposed, which can separately estimate the frequency offset for each transmit antenna and exploit the spatial diversity. The Cramer-Rao Bound (CRB) for synchronous MIMO (i.e., the time delays for each transmit antenna are all equal) is also derived. Simulation results are given to illustrate the per- formance of the estimator and compare it with the CRB. It is shown that the estimator can provide satisfactory frequency offset estimates and its performance is close to the CRB for the Signal-to-Noise Ratio (SNR) below 20dB.     

A new de-noising method based on 3-band wavelet and nonparametric adaptive estimation

Wavelet de-noising has been well known as an important method of signal de-noising. Recently,most of the research efforts about wavelet de-noising focus on how to select the threshold,where Donoho method is applied widely. Compared with traditional 2-band wavelet,3-band wavelet has advantages in many aspects. According to this theory,an adaptive signal de-noising method in 3-band wavelet domain based on nonparametric adaptive estimation is proposed. The experimental results show that in 3-band wavelet domain,the proposed method represents better characteristics than Donoho method in protecting detail and improving the signal-to-noise ratio of reconstruction signal.     

基于单视图像的球体姿态估计

该文给出一种基于图像信息估计3D目标球体及其中心轴孔空间姿态的视觉检测技术。若相机焦距已知,且给定球体与圆特征形状参数,则可由单视方法估计球心与圆特征中心位置及其法向方向,从而可由球及中轴构成的多个圆特征给出对目标球体姿态的初步估计。由于图像噪声及投影椭圆拟合误差的存在,每一个特征的独立估计结果并不完全一致,进一步引入非线性最小二乘方法对上述初步结果进行优化以改善估计精度。仿真及实际图像处理结果验证了算法的有效性。     

突发传输中ZP-OFDM的信道估计和跟踪

在缓变信道的突发传输模式中,信道估计通常采用前导(preamble)的方法,并假设在突发过程中信道不变。但是,由于信道实际在不同的OFDM符号中是缓变的,因此这种假设导致了系统性能的下降。在这里,针对ZP-OFDM系统,该文给出了一种低复杂度的信道估计和跟踪方法。它在突发传输的第1个OFDM符号中利用梳状导频的方法进行信道估计,在随后的OFDM符号中利用在时域只插入1位训练位的方法来实现信道的跟踪。仿真结果表明,该方法提高了系统的性能。     

长拖尾K分布杂波下雷达目标散射中心参数的稳健估计

实际条件下,在对基于衰减指数(DE)和模型的雷达目标散射中心参数估计和特征提取时,其噪声背景往往是非高斯的,分布密度函数表现出长拖尾性质。利用基于高斯假设条件下的估计方法进行参数估计时,往往不能得到较好的结果。针对这种情况,该文利用M估计方法来实现对长拖尾杂波下DE模型参数的稳健估计。首先分析了基于PRONY模型的M估计实现方法存在的不足,其次提出了两种较为有效的DE模型散射中心参数M估计的实现方法,并对这两种方法进行了分析和比较。仿真实验结果表明,在一类长拖尾K分布杂波条件下,与ESPRIT方法以及扩展PRONY估计方法相比,该文所提的两种方法均能得到较好的估计结果。     

一种改进的片内ESD保护电路仿真设计方法

对现有的片内ESD保护电路仿真设计方法进行了改进,使之适用于深亚微米工艺.文中设计了新的激励电路以简化仿真电路模型;增加了栅氧化层击穿这一失效判据;使用能量平衡方程描述深亚微米MOSFET的非本地输运,并对碰撞离化模型进行了修正;使用蒙特卡罗仿真得到新的电子能量驰豫时间随电子能量变化的经验模型.最后使用文中改进的仿真设计方法对一个ESD保护电路进行了设计和验证,测试结果符合设计要求.     

三维不可压缩黏弹性流体系统解的逐点估计

本文考虑三维不可压缩黏弹性流体力学模型的Cauchy问题.首先引入适当的变量变换,对变换后的方程组,研究其线性化系统的Green函数.接着,根据Green函数逐点估计方法,结合方程组解的表达式,分析Riesz算子的影响,得到解关于时空的逐点估计.     

一维光子晶体热辐射光谱控制模拟研究

将一维金属-介质光子晶体应用于热辐射光谱控制,基于电磁波理论建立了光谱能量关系和光谱特性计算方法.采用钨(W)和二氧化硅(SiO2)设计了一维金属-介质光子晶体,从麦克斯韦方程组出发,研究了该一维结构的光谱特性.研究结果表明,该结构能够有效地结合材料自身光谱属性和光子晶体的光谱控制特性实现热辐射光谱特性的选择控制,可被用于热光伏系统实现热辐射光谱控制.