Fission fragment mass yields of Th to Rf even-even nuclei

Fission properties of the actinide nuclei are deduced from theoretical analysis. We investigate potential energy surfaces and fission barriers and predict the fission fragment mass yields of actinide isotopes. The results are compared with experimental data where available. The calculations were performed in the macroscopic-microscopic approximation with the Lublin-Strasbourg Drop (LSD) for the macroscopic part, and the microscopic energy corrections were evaluated in the Yukawa-folded potential. The Fourier nuclear shape parametrization is used to describe the nuclear shape, including the non-axial degree of freedom. The fission fragment mass yields of the nuclei considered are evaluated within a 3D collective model using the Born-Oppenheimer approximation.     

快中子引起的背向溅射

描述了用实验方法测量快中子引起的背向溅射,测量了Mg、Al、Sc、V、Fe、CO、Cu、Zr、Au和316型不锈钢等10种材料的背向溅射产额,并与正向产额进行了比较,发现背向和正向溅射产额的比值与核反应的类型有关.本实验的结果同其它小组的结果进行了比较,并用溅射理论对实验结果进行了解释.     

30MeV/u 40Ar引起的反应中核温度参数的提取

利用同位素产额比方法,提取了30MeV/u ⁴⁰Ar轰击⁵⁸Ni,⁶⁴Ni和¹¹⁵In的反应中中等质量碎片(IMFs:3≤Z≤8)的发射体的核温度参数,给出了“表观”温度与一些物理量的依赖关系以及对边馈(side-feeding)效应的影响进行修正后的温度参数. 并就此进行了简单的讨论.     

胶体水相法制备高量子产率及高稳定性的水溶性ZnSe量子点

采用简便的胶体水相法制备了高荧光强度且稳定性良好的ZnSe量子点(ZnSe QDs),克服了以往水相合成法稳定性差、量子产率低等缺陷。优化后的最佳合成条件为：以还原型L-谷胱甘肽作为稳定剂,L-谷胱甘肽∶Se2-∶Zn2+摩尔比为5∶1∶5,介质pH 10.5,反应温度在90～100 ℃之间。且合成后不需要采取任何光照后处理,ZnSe QDs的量子产率(QYs) 即可高达50.1%,放置3个月后荧光强度基本不变,水溶性优良。用紫外-可见分光光度法(UV-Vis)、荧光分光光度法(FL)、透射电子显微镜(TEM)等分析检测手段,对得到的ZnSe QDs的性能进行表征。合成的量子点在300 nm激发下发蓝紫色荧光(370 nm),其优良的光化学特性将有利于其在光热器件的制造及化学生物领域的应用。     

Calculation of X-ray and Auger transition rates, lifetimes, X-ray wavelengths, and fluorescence yields of variously ionized silicon atoms

X-ray and Auger transition rates, X-ray wavelengths, and fluorescence yields are calculated for variously ionized silicon atoms with configurations 1s2s^m2pⁿ, m=0-2, n=1-6. The calculation has been performed using the Hartree-Fock atomic model. Intermediate coupling and configuration interaction have been taken into account. The energies and widths are found to be strongly affected by configuration mixing. The results from the present calculation have been compared with those available in the literature. The theoretical K_α hypersatellite and satellite spectra fall into several well-separated regions, corresponding to each of the possible number of spectator electrons in the 2s and 2p shells. The dependence of radiative rates and fluorescence yields on the number of spectator electrons is also investigated.     

同位旋效应对中能重离子反应中轻粒子产物的影响

利用同位旋相关的量子分子动力学模型,研究了¹¹²Sn+¹¹²Sn和¹²⁴Sn+¹²⁴Sn两反应系统在不同入射能量、不同碰撞参数、不同势场和不同核子-核子碰撞截面下的粒子发射特征.阐述了发射体系的同位旋对轻粒子产额比的影响.发现轻粒子产额比是同位旋的敏感观测量.另外,还发现中快度区发射的粒子有更高的丰中子程度.同时,轻粒子的比不敏感于核子核子碰撞截面,而敏感于核态方程,这使得从轻粒子比提取同位旋相关的核态方程变成一种可能. 关键词： 同位旋相关的量子分子动力学 同位旋效应 轻粒子产额比     

Deformation parameter changes in fission mass yields within the systematic statistical scission-point model

The fission fragment mass-yields are evaluated for pre-actinide and actinide isotopes using a systematic statistical scission point model. The total potential energy of the fissioning systems at the scission point is presented in approximate relations as functions of mass numbers,deformation parameters and the temperature of complementary fission fragments. The collective temperature, Tcoll, and the temperature of fission fragments, Ti, are separated and the effect of collective temperature on mass yields results is investigated. The fragment temperature has been calculated with the generalized superfluid model. The sum of deformation parameters of complementary fission fragments has been obtained by fitting the calculated results with the experimental data. To investigate the transitions between symmetric and asymmetric modes mass yields for pre-actinide and heavy actinides are calculated with this model. The transition from asymmetric to symmetric fission is well reproduced using this systematic statistical scission point model. The calculated results are in good agreement with the experimental data with Tcoll= 2 Me V at intermediate excitation energy and with T_(coll)= 1MeV for spontaneous fission.Despite the Langevin model, in the scission point model, a constraint on the deformation parameters of fission fragments has little effect on the results of the mass yield.     

Systematics on fission fragment mass distribution of neutron induced 235U fission

Based on the neutron induced fission fragment mass distribution data up to neutron energy 20 MeV measured with the double kinetic energy method (KEM) and the radio active method (RAM), the systematics of fission fragment mass distribution was investigated by using 5 Gaussian model and the systematics parameters were obtained by fitting the experimental data. With the systematics, the yields of any mass A and at any energy in the region from 0 to 20 MeV of neutron energy can be calculated. The calculated results could well reproduce the experimental data measured with KEM, but show some systematical deviation from the data measured by RAM, which reflects some systematical deviations between the two kinds of measured data.The error of systematics yield was calculated in an exact error transformation way, including from the error of the experimental yield data to the error of the discrete parameters, then to the systematics parameters,and at last to the yield calculated with systematics.     

Empirical,Semi-Empirical and Experimental Determination of K X-Ray Fluorescence Parameters of Some Elements in the Atomic Range 21 ≤ Z ≤ 30

In this study, the semi-empirical and empirical calculations of K X-ray intensity ratios, K-shell fluorescence yields, and vacancy transfer probabilities have been performed for 3d transition elements. Also, σ_Kα, σ_Kβ production cross-sections, K_β/K_α intensity ratios, ω_K fluorescence yields, and η_KL vacancy transfer probabilities of 3d transition elements have been measured. The samples were excited by 59.5 keV γ-rays from a ²⁴¹Am annular radioactive source. K X-rays emitted by samples were counted by an Ultra-LEGe detector with a resolution of 150 eV at 5.9 keV.     

Predicting experimental yields as an index to rank synthesis routes II: application to the Curtius rearrangement

Synthesis yields of organic reactions are one of the most important factors in ranking synthesis routes created by synthesis route design systems such as Transform‐Oriented Synthesis Planning and Knowledge base‐Oriented Synthesis Planning. If it is possible to predict the yields of synthesis reactions before starting experiments, one can easily determine an order of synthesis routes for experimental works. In the present study, the reaction profiles of the Curtius rearrangement with different substituents were calculated to generate an equation predicting experimental yields of this reaction. Reactions followed by the formation of isocyanates were also analyzed to consider the relationship between reaction times and experimental yields. A partial least squares (PLS) regression was used to correlate the experimental yields with the calculated activation energies, E_a(calc), together with experimental conditions such as dielectric constants of solvents, reaction times, and reaction temperatures as explanatory variables. Although the PLS regression using all the data gave very poor results, we succeeded in making a model equation with R² = 0.887 using a modified data set. However, there is a conflict between the predictability and the interpretability on the reaction time. This discrepancy mainly comes from unnecessarily long reaction times in the experiments for azides with calculated E_a values of less than 33 kcal mol^–1. To construct a good model equation for the experimental yields of the Curtius reaction, we have to use data sets obtained from within 90 min of the reaction for the PLS regression. Copyright © 2011 John Wiley & Sons, Ltd.