Application of enzyme-field effect transistor sensor arrays as detectors in a flow-injection analysis system for simultaneous monitoring of medium components. Part II. Monitoring of cultivation processes

Glucose, maltose, sucrose, lactose, ethanol and urea concentrations were monitored simultaneously during the cultivation of Escherichia coli and Saccharomyces cerevisiae by means of enzyme field effect transistors (EnFETs) applying glucose dehydrogenase (GDH), maltase (MAL)/GDH, invertase (INV)/GDH, β-galactosidase (β-GAL)/galactosedehydrogenase (GALDH), alcoholdehydrogenase (ADH)/aldehydedehydrogenase (ALDH), and urease. These enzymes were (co)immobilized on the pH sensitive gates of an eight-FET array. The FET array was integrated in a commercial FIA system.     

注入控制铜蒸气激光方向性时间过程测量

实验研究了注入控制对铜蒸气激光非稳腔输出光束质量的影响，从输出光发散角时间分辨过程的测量结果说明注入加速被注入腔内激光发散角的减小过程。由于被注入腔内放大自发辐射的存在，为得到较好的注入控制效果，注入光的脉宽和进入被注入腔的延时必须恰当。     

HPLC法测定阿奇霉素葡萄糖注射液中阿奇霉素的含量

利用高效液相色谱法，以VP-ODS型色谱柱，乙腈-异丙醇-水-氨水（60：25：15：0.1)为流动相，于210nm波长处测定了阿奇霉素葡萄糖注射液中阿奇霉素葡萄糖注射液中阿奇霉素的含量。阿奇霉素的浓度在0.75-1.75mg/mL线性关系良好，线性方程的A=881910.4c-16208.2，相关系数r=0.9999。阿奇霉素的平均回收率为99.59%，测定结果的相对标准偏差为1.31%。     

Measurement of small-signal and large-signal responses of packaged laser modules at high temperature

In this paper, the pulsed injection method is extended to measure the chip temperature of various packaged laser modules, such as the DFB laser modules, the FP laser modules, and the EML laser modules. An optimal injection condition is obtained by investigating the dependence of the lasing wavelength on the width and period of the injection pulse in a relatively wide temperature range. The small-signal frequency responses and large-signal performances of packaged laser modules at different chip temperature are measured. The adiabatic small-signal modulation characteristics of packaged LD are first extracted. In the large-signal measurement, the effects of chip temperature, bias current and driving signal on the performances of the laser modules are discussed. It has been found that the large-signal performances of the EML modules depend on the different red-shift speeds of the DFB and EAM sections as chip temperature varying, and the optimal characteristics may be achieved at higher temperature.     

ECR-SFC轴向注入系统聚束器效率的研究

为了减少目前SFC轴向注入系统中聚束器杂散电场对束流轴向注入效率的影响, 提高新系统中SFC的束流俘获效率, 参考原始设计, 对目前聚束器的电极结构进行了设计改进. 两种情况下的聚束器杂散场对注入效率影响的计算表明, 改进后0B02的聚束效率较目前有较大提高. 同时计算了束流空间电荷效应对聚束效率的影响, 据此对新SFC轴向注入系统中聚束器的位置进行了重新调整.     

Fast Fourier Continuous Cyclic Voltammetry at Gold Ultramicroelectrode in Flowing Solution for Determination of Ultra Trace Amounts of Penicillin G

In this work, for the first time a fast continuous cyclic voltammetry was used as a highly sensitive detection method for Penicillin G in a flow‐injection system. A special computer‐based numerical calculation method (using Fast Fourier Transformation) is introduced here for enhancing the analyte signal and noise reduction. During the measurements, the potential waveform (consists of potential steps for cleaning, stripping and potential ramp) was continuously applied on an Au disk microelectrode (with a radius 12.5 μm in radius). The stripping time was less than 200 ms. Effects of rest potential, sweep rate, and delay time on the sensitivity of the method were investigated. The limit of detection of the method was 1.0 × 10^?11 M. The detection limit of the method is 660 times lower than the most sensitive reported method. The relative standard deviation of the method at 1.0×10^?7 M of Penicillin G was 2.7% for 10 runs.     

断续喷洒去溶电热雾化法在电感耦合等离子体原子发射光谱方法中的应用研究

本文所讨论的电热雾化法是采用继续喷洒去溶技术,使试样在石墨炉表面逐步积累的进样方法。文章简要介绍了实验条件的选择和控制以及石墨炉装置的结构,探讨了提高电热雾化法相对检测能力的途径。实验结果表明:谱线黑度值与试样积累时间的对数值之间具有较好的线性关系。     

流动注射-氢化物发生-原子吸收光谱法测定雪中的微量铅

建立了测定雪中微量铅的流动注射-氢化物发生-原子吸收光谱法。在优化条件下。测定铅的线性范围为0～52．0ng／mL，线性回归方程为A=0．018c 0．016，相关系数r=0．9995，检出限为0．2ng／mL。用于雪中微量铅的测定，加标回收率为94．2％～107．3％，相对标准偏差为1．47％～3．22％。该方法的测定结果与标准加入法基本一致。     

Novel flow injection-fluorometric method for the determination of trace silicate and its application to ultrapurified water analysis

A highly sensitive fluorescence quenching method for the determination of silicate based on the formation of an ion associate between molybdosilicate and Rhodamine B (RB) in nitric acid medium was developed. A flow injection system coupled with a fluorescence detector was used for the measurement of fluorescence intensity at 560 and 580 nm as excitation and emission wavelengths, respectively. The calibration graph for Si showed a linear range of 0.1–5 ng cm⁻³ with correlation coefficient of 0.9999, and the detection limit of 0.06 ng cm⁻³. The proposed method was successfully applied to the determination of silicate in ultrapurified water with satisfactory results.