合成丙交酯中微量水分分析

合成丙交酯中微量水分分析徐溢，柳胜春（重庆大学化工学院分析教研室６３００４４）关键词丙交酯，微量水，定量分析丙交酯是人工合成骨材料聚乳酸的合成中间体，其性能决定着合成产品的品质，要获得高质量的合成材料，对中间体的分析和监测十分重要。一般要求丙交酯中间...     

MgO•3B2O3-18%MgSO4-H2O过饱和溶液析出固相组成和机理研究

针对青藏高原盐湖卤水析盐过程的特点, 模拟合成MgO•3B₂O_3-18%MgSO_4-H₂O过饱和溶液, 在150 ℃水热条件下对析出固相进行研究. 用化学分析方法、X射线衍射、红外光谱进行物相鉴定. 提出了可能的结晶反应机理, 分析了水热温度对析出物相的影响及MgSO₄对硼酸镁盐的盐溶效应随水热温度的变化.     

Partial molal heat capacities of aqueous tetraalkylammonium bromides as functions of temperature

Enthalpies of solution have been measured from 5 to 85°C for aqueous tetraethyl- and tetrapropylammonium bromides, and the integral heat method is employed to evaluate for these electrolytes over a wide temperature range. Data taken from the literature have been used to evaluate for aqueous Bu₄NBr over a similar temperature range. These data, along with similar data for Me₄NBr, previously reported, have been used to evaluate absolute ionic heat capacities. While the absolute values agree only qualitatively with two other methods of division, the temperature dependences of the three methods essentially agree up to 65°C. Heat capacities due to structural effects on the solvent, obtained by subtracting the inherent heat capacities of the ions, are extraordinarily positive for all four tetraalkylammonium ions and have negative temperature coefficients, indicating that all four ions, including the tetramethylammonium ion, are structure-making ions.     

Thermal coefficient of linear expansion of non-crystalline chalcogenides in the As-S-Se-Te-I system

The object of the paper is an investigation of the glasses of the (As₂S₃)_x(AsSe_0.5Te_0.5I)_100-x. type for 65≤;x≤;95, using methods of thermomechanical analysis. Values of the thermal coefficients of linear expansion in solid and visco-plastic phase were determined. it was shown that introducing arsenic-sulfide in glass-matrix AsChI, i.e. (AsSe_0.5Te_0.5I), leads to an increasing stability of these glasses. The characteristic temperatures of softening Tg and the temperature of the beginning of deformation t_w increase by increasing content of As₂S₃. The analytical forms of dependence of four significant physical values α_g, α_l, Tg, Tw, as a function of As₂S₃ content in the structure of glasses were fitted. This revised version was published online in July 2006 with corrections to the Cover Date.     

Sub-zero temperature behavior of water in non-ionic microemulsions

Sub-zero temperature DSC measurements were conducted to evaluate the behavior of water in non-ionic microemulsions. Two surfactant systems were studied. The first, based on ethoxylated fatty alcohol, octaethylene glycol monon-dodecylether [hereafter referred to as C₁₂(EO)₈] and also containing water, pentanol and dodecane at a fixed weight ratio of 1:1. The second system, based on oligomeric ethoxylated siloxanes, water and dodecanol as oil phase. In both systems it was found that in up to 30 wt.% of the total water content, all water molecules solubilize in the amphiphilic phase and are bound to the ethylene oxide (hereafter referred to as EO) head-groups. No free water exists in the surfactant aggregates’ core. Up to three molecules of water are bound to each EO group. In the first system, the behavior changes significantly upon adding more water. The added pentanol allows further swelling and the water penetrates into the amphiphile structures and forms a reservoir of free water. Structures are deformed and grow from elongated channels (up to 15–20 wt.% water), via illdefined (one-dimensional growth) local lamellar structures (up to ca. 60 wt.% water) to spherical normal, O/W micelles (at ≥85 wt.% water). In contrast, the oligomeric systems, due to geometrical restrictions of the amphiphiles and the nature of their curvature that prevents inversion, cannot further solubilize water in the surfactant aggregates’ core, causing phase separation to occur. Part of the results presented in this paper were included in S. E.’s doctoral thesis in Applied Chemistry at The Hebrew University of Jerusalem, Israel.     

还原温度对超细K－Co－Mo催化剂合成低碳醇性能的影响

 用溶胶－凝胶法合成了K－Co－Mo催化剂．样品经不同温度还原后，用于低碳醇的合成．XRD和HRTEM结果表明，样品是超细粒子，粒子尺寸为2～5nm．考察了催化剂的还原温度和反应条件对催化剂性能的影响．实验结果表明，还原温度对催化剂的活性有较大的影响，最佳还原温度为500℃．最佳反应温度范围为310～330℃．升高压力和空速可以提高醇的收率和选择性．在空速14400h－1，压力6．0MPa和温度310℃的条件下，醇的选择性为55．8％，收率为520．0g／（kg·h），MeOH／C2＋OH为0．27．催化剂稳定性良好，在200h的寿命实验中，活性基本不变．与文献中催化剂相比，超细K－Co－Mo催化剂对合成醇具有较高的活性和选择性，尤其是对C2＋OH的合成明显高于其他合成醇催化剂体系．     

The Purification and Rapid Identification of Heavy Metal-binding Peptides of Water Hyacinth

This paper studies the rapid identification of heavy metal-binding peptides (phytochelatin) by taking Water Hyacinth as a model plant. Plants were cultured in water containing 2 μg/ml Cd2+ for 13 days. The Sephadex G-50 chromatography of root extract under low salt concentration (0. 01 mol/L PBS) gave a Cd-binding peak with MW of 10 ,000 determined by SEC HPLC. After oxidation with performic acid, its SEC HPLC molecular weight decreased to below 1300 and the reverse phase HPLC showed one peptide peak, whose amino acid composition is the same as that of the sample never undertaking oxidation, and (Glu/Gln):Cys:Gly=2:2:1. According to the general structure of phytochelatin (γ-Glu-Cys)n-Gly, n is 2 in this case. The protocol including the sequential steps of Sephadex G-50 chromatography→performic acid oxidation→reverse phase HPLC→amino acid analysis is a rapid and effective method to identify the existence of phytochelatin and determine its values of n.     

近临界水中苄叉乙酰苯的合成研究

以近临界水作为反应介质,在无外加催化剂的条件下,苯甲醛与苯乙酮可顺利反应生成苄叉乙酰苯。在最佳条件下,苄叉乙酰苯的收率可达31.4%。该方法避免了常规合成方法中有机溶剂的使用以及NaOH催化剂的加入,产物后处理简单,是一种绿色合成新过程。     

纳米氧化铜的制备及常温脱硫效能研究

采用硝酸铜为原料、氢氧化钠溶液为沉淀剂、使用体积比为1∶1的乙醇-水溶液为分散剂的直接沉淀法制备，通过改变工艺条件得到了三种纳米氧化铜产品，平均粒径分别为25.63，10.74和7.57 nm。采用TG-DTA、FIR、XRD和TEM等对纳米氧化铜进行表征。对产品的常温脱硫活性进行了穿透试验，并与已开发的其他常温精脱硫产品进行了比较，结果表明纳米氧化铜应用于H₂S脱硫，可在常温条件下具有优异的脱硫活性，对H₂S的脱除精度可以达到0.05 mg·m^-3以下。经过优选，产品在3 000 h^-1空速下穿透硫容达到25.3%，高于同类型的其他脱硫剂产品。     

高碘酸法测定水中锰的改进

介绍了一种室温下测定水中锰的方法，经检验，其显色反应可在短时间内完成，且色泽稳定，精密度和准确度均能达到分析要求。