Two-Frequency Brillouin Fiber Laser Based on Bragg Grating Fabry-Perot Cavity

Abstract

A novel and simple two-frequency Brillouin fiber laser is presented. It is based on a fiber Fabry-Perot cavity with fiber Bragg gratings as reflectors. The model of stimulated Brillouin scattering in fiber grating–based Fabry-Perot resonator is investigated. The laser allows conversion efficiency of close to 100% and suppresses the higher-order Stokes waves. The theoretical prediction is presented and the experimental demonstration is realized.     

A High Efficiency Yb3+-doped Fiber Ring Cavity Laser with Narrow Line-widthRound-trip Dispersion Calculation for Martinez Pulse Stretcher

A novel Yb3+-doped fiber ring cavity laser pumped by a 977 nm laser diode is presented with its output laser wavelength of 1060 nm. Based on a fiber Bragg grating (FBG), the laser exhibits 0.20 nm line-width, 7.5 mW laser output power, 40 dB signal-to-noise ratio (SNR) and 66% slope efficiency.This paper proposed a ray-tracing model for the Martinez stretcher, derived the calculation formulae for the stretcher of a grating-spherical mirror system and discussed the error for the total dispersion resulted from the spatial dispersion. The calculated results show that the error could be ignored for the beam returned to the stretcher for the second pass in the wavelength range of 750 nm and 850 nm.     

Measurement of στ product of solid state laser materials by an alternative method: Application to Nd3+ doped YVO4 crystal for 4 F 3/2→4 I 11/2 transition

In this paper an alternative approach for measurement of στ product for ⁴ F _3/2→⁴ I _11/2 transition of Nd³⁺ doped YVO₄ crystal is reported. In this method a microchip laser is formed by keeping a small piece of the sample in plane-plane resonator and a diode laser (808 nm) is used for pumping. The pump power induced thermal lensing effect is used to make the cavity stable. The cavity mode area is estimated by measuring the thermal lens focal length at the threshold and the average pump area is measured by Gaussian fit to the intensity profiles of the pump beam. The value of στ product of Nd:YVO₄ crystal obtained by this method is within 10% of the reported values. The advantage of this method is that it is a simple method for direct measurement of στ product of laser crystals.     

Equipartition and rate of energy exchanges in a model of a radiant cavity

Results of calculations on a model of a radiant cavity, performed in order to explore the relation between stochasticity and geometrical structure of phase space, are presented. The rate of energy exchanges, as indicator of stochasticity, is found to be quite effective. Furthermore, a trend to equipartition for such a quantity is observed at increasing energy, and this implies an increasing rigidity of high harmonic modes also in the stochastic regime of motion. Such a feature may be correlated to the shape of the spectrum which characterizes the radiant cavity with respect to nonlinear chains.     

Efficient Scheme for Entangling Two Distant Atoms

A scheme is presented for the generation of entangled states for two atoms trapped in two distant cavities. In the scheme each atom is resonantly coupled with the respective cavity mode and driven by a strong classical field. The detection of a photon decaying from the cavities and passing through a beam-splitter collapses the atoms to an entangled state. The required atom-field interaction time is very short and thus the decoherence effect is suppressed. Our scheme is within the reach of presently available cavity QED techniques.     

Synthesis of resonant cavities having continuum spectra by genetic algorithm

This paper proposes a novel method for generating continuum spectra with possible applications in WDM access networks. This new method would allow the development of a simple continuum laser structure with better performances in terms of cost and simplicity than those of present supercontinuum sources. In this aim, we will analyze the possibility to broaden the resonant modes of a Fabry–Perot cavity by operating only on the design of one of the cavity's Bragg mirrors. Firstly we considered the conditions which a Bragg grating must satisfy in order to broaden the resonant modes of a resonant cavity. Because an exact solution is not physical possible, the genetic algorithm is the best available tool for the design of such a grating. An active medium is then added inside the cavity and its behavior below threshold is simulated. The spectra thus simulated are continuum over 5–15 nm.     

恒热流加热开口腔自然对流的可视化实验和数值模拟

本文采用激光全息干涉和激光片光照射烟可视化方法获得了恒热流加热的二维开口腔自然对流问题的温度场和流场,并进行了数值分析.实验结果与数值模拟结果吻合.数值计算表明方腔内流体的流通量与Ra*和深高比B有关,当Ra*＞104时随深高比B增加流通量增加;B×Nu与深高比B呈线性关系.利用B×Nu与深高比B的线性关系,通过引入当量导热系数λc,本文还给出了加热壁面的平均温度的简单计算方法.     

Optimal time advancing dispersion relation preserving schemes

In this paper we examine the constrained optimization of explicit Runge–Kutta (RK) schemes coupled with central spatial discretization schemes to solve the one-dimensional convection equation. The constraints are defined with respect to the correct error propagation equation which goes beyond the traditional von Neumann analysis   developed in Sengupta et al. [T.K. Sengupta, A. Dipankar, P. Sagaut, Error dynamics: beyond von Neumann analysis, J. Comput. Phys. 226 (2007) 1211–1218]. The efficiency of these optimal schemes is demonstrated for the one-dimensional convection problem and also by solving the Navier–Stokes equations for a two-dimensional lid-driven cavity (LDC) problem. For the LDC problem, results for Re=1000$\mathit{Re}=1000$ are compared with results using spectral methods in Botella and Peyret [O. Botella, R. Peyret, Benchmark spectral results on the lid-driven cavity flow, Comput. Fluids 27 (1998) 421–433] to calibrate the method in solving the steady state problem. We also report the results of the same flow at Re=10,000$\mathit{Re}=10\text{,}000$ and compare them with some recent results to establish the correctness and accuracy of the scheme for solving unsteady flow problems. Finally, we also compare our results for a wave-packet propagation problem with another method developed for computational aeroacoustics.     

The characteristics analysis of a new-style four-mirror axisymmetric-fold-combination cavity adapting to cylindrical discharge region

An axisymmetric-fold-combination (ASFC) cavity composed of two planar mirrors and spherical mirrors was designed. It is a stable-unstable resonator cavity. The light field of radial direction is Gaussian distribution. And in angular orientation, the distribution keeps invariant. It could generate annular CO₂ laser beam with excellent spatial coherence. And the spatial coherence is commendably realized with its stable-unstable cavity structure. The output light intensity distribution of this special model was discussed and simulated. With exterior lenses group, the output beams can be adjusted and controlled better to meet the manufactural requirements. Some references were provided for further research of the cavity with cylindrical discharge region.     

Feedback method of the noise suppression in wave-mixing amplifiers based on non-linear materials with photorefractive response in a reflection grating configuration

In the photorefractive wave-mixing system, fluctuation in the signal beam intensity of the photorefractive output with a reflection grating has been analyzed by employing pump feedback method. In this method, fluctuations of the photorefractive wave-mixing process not only induce the intensity fluctuation of the mixing waves but also induce phase fluctuation of the mixing waves. Thus, the phase of the pump and signal beams at the output surface fluctuates in time around a mean value. Using such a positive feedback method of a pump beams, the relative fluctuation in the photorefractive output signal beam intensity with respect to its mean intensity can be minimized significantly without reducing its mean intensity. The factors that control the fluctuation in the signal beam intensity, such as the phase fluctuation of the output pump beam, absorption strength of the material and the feedback reflectivity of the cavity mirrors, on the relative fluctuation of the output signal intensity in the photorefractive wave-mixing systems have been studied in detail. It has been found that the fluctuation of the output signal intensity relative to its mean intensity in the photorefractive wave-mixing system can be suppressed to larger extent by taking lower value of feedback reflectivity of the cavity mirrors which could exist at a higher value of absorption strength of the photorefractive materials.