Comparative Study on Large and Small Signal Theory for Intensity Modulation Response of Semiconductor Lasers Including Higher-Order Dispersion Terms

In this article, the comparison of large signal theory and small signal theory has been done with dispersive propagation of optical signal with IMDD (Intensity Modulation Direct Detection) systems for semiconductor lasers with higher-order dispersion terms. The expressions for an exact large signal theory and small signal theory including higher-order dispersion terms for propagation of an optical wave with sinusoidal amplitude and frequency modulation in a dispersive fiber have been derived. It is observed that small signal theory is more sensitive compared to large signal theory in terms of intensity modulation/direct detection systems. Also, it is reported that for large signal analysis the higher-order effects of dispersion can be ignored, whereas for small signal theory, the higher-order effects can be ignored for lower modulation frequencies only. The variation in the transfer function for various values of modulation indices are greater for small signal analysis than for large signal analysis. Also, as the intensity modulation index is increased, there is a decrease in the value of transfer function. The large signal model approximates the small signal model for lower values of the intensity modulation index.     

自由曲面光学虚拟制造与检测系统的探讨

自由曲面光学产品设计、制造与检测的工艺流程，通常采取试凑法逐次逼近。由于加工 检测 再加工，循环往复，既费时，成本又高，产生了瓶颈问题。为了解决此弊端，本文运用虚拟制造技术，提出光学虚拟制造的基本构想，即虚拟制造系统结构模型，给出光学系统虚拟原型的构成和光学系统成像质量虚拟检测系统的构成，讨论光学成像质量的仿真检测以及敏度分析方法。研究结果表明：运用虚拟制造与检测技术，可缩短研发周期，降低成本，优化工艺并提高产品质量。     

光互联网的抗毁性设计研究

由于互联网层叠模型中多层都存在重复的保护与恢复机制，致使互联网的实现极其复杂，造成网络传输效率较低，而且拥塞。随着密集波分复用（DWDM）的广泛使用和网络底层性能的大幅度提高，已经不需要再对网络中多层进行重复保护与恢复。在此基础上，采用了未来光互联网3层 (应用层、IP层和光互联层) 协议模型，并对其中的光互联层的保护进行了深入的研究，提出了部分共享备用路径保护(P-SPP)方法。此模型能充分利用IP层电子的灵活恢复机制与光互联层的快速保护与恢复机制，提高光互联网的传输性能，以适应目前高速发展的互联网对传输带宽的要求。     

多层光子晶体滤波器研究

从双层结构出发研究了一种由多块不同的单周期光子晶体组合而成的多层结构的滤波器，论述了这种滤波器的工作原理，研究表明这种结构适于制作带通、窄带通过、带阻、宽带带阻、高通以及其它各种性能的滤波器。实验和理论研究的结果相一致。     

The origin of the formation of cavities in galvanized coatings

The role of water‐soluble corrosion products on galvanized wires was examined. The samples used were industrial hot‐dip galvanized wires, which were exposed to the open air under all weather conditions for a relatively short time (6 and 12 months), in an urban environment close to the sea. The samples were studied by different methods, i.e. scanning electron microscopy (SEM), transmission electron microscopy (TEM), X‐ray diffraction (XRD) and optical microscopy (OM). Several phases were detected because of the galvanization procedure and the steel substrate. Furthermore, phases which were formed as a result of the reaction of zinc with the atmosphere were also detected. These were oxides like ZnO, carbonates like ZnCO₃ and hydrated Zn and Fe sulfates. Their presence influences the corrosion resistance of the wires, which finally, strongly depends on the solubility of the wires in water. The SO₄^2? compounds especially are very soluble and consequently are easily removed from the coating surface, leading to its degradation by the formation of cavities. In any case, their presence, even after a short period of exposure, implies that the coating is highly affected by the atmosphere of the modern city. Copyright © 2006 John Wiley & Sons, Ltd.     

具有高机械强度的掺Er~(3 )∶TeO_2-Nb_2O_5玻璃的光谱性质研究

熔制了掺铒碲铌玻璃样品(100-X)TeO2-XNb2O5(X=5,10,15,20mol%),测试了其密度、折射率、转变温度、析晶温度、维氏机械强度、吸收光谱、荧光光谱、荧光寿命等参量。利用Judd-Ofelt和McCumber理论分别计算了铒离子强度参量Ωt(t=2,4,6)和受激发射截面σemi的大小,研究了掺铒碲铌玻璃样品光谱参量对Nb2O5成分的依赖性,并与典型的碲锌钠玻璃(75TeO2-20ZnO-5Na2O)在热学、机械强度、光谱性质和放大品行四个方面进行了比较.     

Highly polarized dithiafulvenes: synthesis and nonlinear optical properties

Push-pull dithiafulvenes with reduced bond length alternation (BLA) and high optical nonlinearities have been prepared. The interplay between the proaromaticity of the donor and the structural and optical properties of these merocyanines is discussed. The donor ability of dithiafulvenes can reach that of ferrocene or dialkylaminophenyl groups.     

分析布拉格光栅破坏的两纤芯不同的光纤耦合器

进一步推广了描述纤芯不同光纤耦合器的耦合模理论，用于解释被布拉格光栅破坏的两纤芯不同光纤耦合器的耦合现象，理论分析的结果与已报道的实验结果相符，与单独的布拉格光栅所起的反射作用不同,这里布拉格光栅所起的作用主要是引入了强烈的色散，在光栅的频谱范围内使耦合器不再同步，在被布拉格光栅破坏的光纤耦合器的选择性频谱中，其边缘部分出现非常弱的波动，而在其阻带内出现非常强的凹陷。     

简并光学参量振荡器混沌反控制

提出一种实现简并光学参量振荡器混沌反控制的方法，用正弦信号调制简并光学参量振荡器的基模衰减率，使简并光学参量振荡器从定态输出转化为混沌态.数值模拟结果表明，选择不同的调制幅度和调制角频率，只要满足系统的最大李雅谱诺夫指数大于零，即可实现不同的混沌轨道重构.通过比较最大李雅谱诺夫指数λ_max随调制幅度和调制角频率变化曲线， 指出系统从周期态调制到混沌态比从无亚谐波输出的定态调制到混沌态更容易，有更宽的调制幅度和调制角频率选择范围. 关键词： 简并光学参量振荡器 混沌反控制 调制     

红外耦合光学系统设计

红外目标模拟器由红外目标图像发生器和投影光学系统组成。该红外光学系统是一个要求与2个导引光学系统的光学技术参数相匹配的长焦距、大视场和具有像方远心光路的中红外光学系统。叙述用于红外目标模拟器的红外耦合光学系统的设计原理，提出它与导引光学系统一起可组成放大倍率M=4.5×的红外投影光学系统，并指出IR CRT产生的图像通过红外投影光学系统可成像在导引接收器上。针对给出的红外耦合光学系统的设计特点和技术要求，光学材料选取硅（Si） 锗（Ge） 硅（Si），采用简单的柯克三片式结构完成光学系统设计。设计评价结果表明，该系统的光学性能和成像质量均满足设计指标要求。