应用双面电极的PLZT横向电光调制器电场的精确解

使用保角变换方法导出了横向电光调制器中双面电极结构的电场和电容的解析表达式，给出了用于ＰＬＺＴ电光陶瓷介质中二次电光效应分析的电场分布的物理图像。通过计算对比表明，双面电极结构电极边级区域由于过剩双折射引起的强度调制非均匀性较单面电极有所改善。     

二极管激光侧泵浦单横模100Hz电光调Q激光器

介绍了二极管激光侧泵浦单横模１００Ｈｚ电光调Ｑ激光器的实验结果。泵浦源为一个线阵准连续１００Ｗ二极管激光器，激光工作介质为ＮｄＹＡＧ薄梯形板条，板条与泵浦源间用柱透镜耦合，ＫＤ＊Ｐ电光晶体调Ｑ。在１００Ｈｚ重复频率下，获得单脉冲能量２．３７ｍＪ，脉宽小于７ｎｓ，光束质量因子Ｍ２＝１．１的１．０６μｍ激光，光－光效率为８．５％，斜效率为１８．７％。     

用横波推导简谐波的能量

本文提出用横波推导简谐波能量的方法，并就此进行了具体时推导。     

叶片扰流器对风力机性能影响的数值研究

风力发电机组不断向大型化发展,风力机叶片的长度越来越长,为满足其结构要求,需要在叶片内侧采用厚翼型,而厚翼型在大攻角下容易导致流动分离,影响功率输出。本文通过对某一风力机叶片进行数值模拟,分析其近叶根处的流场,发现存在较大的流动分离现象。针对两种工况,在叶片内侧最大弦长位置增加环形扰流器后进行数值模拟,与原始叶片进行比较。结果表明:扰流器可以有效减小叶片内侧的流动分离区域,风速为11 m/s和15 m/s时功率都得到一定程度的提高,扰流器附近截面上的压力分布也有所改善。     

Control of a turbulent flow separated at mid-chord along an airfoil with DBD plasma actuators

The goal of the present experimental study is to investigate the ability of surface DBD plasma actuators to delay flow separation along the suction side of a NACA0015 airfoil. Three single surface DBD actuators that can operate separately are mounted on the suction side of the profile, at 18%, 27% and 37% of the chord length. The boundary layer is transitioned by a tripper to be sure that the flow control is not due to the laminar-to-turbulent transition. The angle of attack is equal to 11.5° and the free-stream velocity to U₀ = 40 m/s, resulting in a chord-based Reynolds number of Re_c = 1.33 × 10⁶. The flow is studied with a high-resolution PIV system. In such conditions, the baseline flow separation occurs at 50% of chord. Then, the different single DBD have been switched on separately, in order to investigate the actuator location effect. One highlights that the DBD located at x_c/c = 18% is more effective than the two others ones, with a separation delay up to 64% of chord. When the three DBDs operate simultaneously, the separation point moves progressively toward the trailing edge when the high voltage is increased, up to 76% of chord at 20 kV. Finally, the effect of the actuation frequency on the control authority has been investigated, by varying the value of the operating frequency and by burst-modulation. For frequencies equal to 50 Hz and 500 Hz (reduced frequency F⁺ = 0.31 and 3.1), the separation has been delayed at 76 and 80% of chord, respectively.     

Low tropospheric wind measurement with Mie Doppler Lidar

A double edge Mie Doppler lidar at 1064 nm was developed in Hefei, China in 2005 for low tropospheric wind measurement. Intercomparison experiments with a wind profiler and a wiresonde were held. Intercomparisons of concurrent lidar and other instrument observations show good agreement with expected measurement accuracy. The examples of validated lidar wind profiles obtained during these experiments as well as an example of continuous wind observations are presented. The instrument has demonstrated the capability of atmospheric wind field measurement from 0.2 to 5 km altitude, achieving below 2 m/s accuracy with 1 min averaging and 21.2 m vertical resolution.     

使用叠栅层析技术测量超音速风洞中的非对称复杂密度场

使用叠栅层析技术解决超音速风洞中复杂密度场的测量难题。应用高灵敏度叠栅偏折仪和间隔角度旋转模型的方法获取超音速风洞中流场的多方向叠栅条纹图。层析计算中使用一种新的偏折角修正迭代的叠栅层析算法,该方法可以实现对有限角采样和包含遮挡物的非完全数据重建,迭代过程中结合内边界平滑滤波提高重建精度。实验中获取了马赫数为2.52的超音速风洞中9幅不同采样角的条纹图,经过50次迭代计算后重建出膨胀波区非对称密度场的截面分布,并对测量结果和误差进行了分析和讨论。使用计算流体力学技术对该密度场进行建模和计算,验证了叠栅层析重建结果的正确性,证实了该技术在测量复杂流场领域的重要价值。     

多纵模激光F-P标准具双边缘测风可行性分析

讨论采用多纵模激光器作探测光源用于双边缘多普勒激光雷达测风的可行性。给出了多纵模激光器谐振腔腔长与边缘滤波器F-P标准具腔长之间的关系。分析了多纵模双边缘测风的主要特性,计算灵敏度、信噪比和径向测速误差,并与单纵模测风性能进行对比。可用类似单纵模测风中动态频率跟踪技术解决多纵模激光器频率漂移问题。     

新型静态偏振风成像干涉仪理论探测误差的分析与计算

简述了新型静态偏振风成像干涉仪的原理,推导出一般情况下系统的Jones矩阵.在此基础上计算了系统中各偏振器件重要参数在非理想情况下对风速和温度探测结果的影响.利用计算机模拟对探测误差进行了分析,并按照系统精度要求从理论上提出了各重要参数的误差容限.该研究为新型静态偏振风成像干涉仪的研制、定标及后期数据处理提供了理论依据. 关键词： 静态偏振风成像干涉仪 Jones矩阵 方位角误差 相位延迟量误差     

静态偏振风成像干涉仪中光在四面角锥棱镜中的传播规律研究

简述了自行设计的新型静态偏振风成像干涉仪的原理和四面角锥棱镜的分光机理;应用光线追迹法,推导出了主截面内任意光线在棱镜中的传播方向及出射点坐标,建立了平行光束经角锥棱镜后的偏向角和透过率的理论表达式;采用计算机模拟给出了偏向角和透过率随入射角的变化关系曲线;根据静态偏振风成像干涉仪的具体参数确定了四面角锥棱镜的侧面和底面夹角以及底边长度.该研究为静态偏振风成像干涉仪的研制提供了理论依据.